Introduction
This manual provides essential information for the proper setup, operation, and maintenance of your Unique 3D Print Robot Hand Controller Stand. This product is designed to securely hold gaming controllers and most standard headsets, helping to organize your gaming space.
Setup
The Unique 3D Print Robot Hand Controller Stand requires no assembly. Follow these steps for initial setup:
- Unboxing: Carefully remove the controller stand from its packaging. Inspect the stand for any signs of damage during transit.
- Placement: Position the stand on a flat, stable, and level surface. Ensure the surface is clear of obstructions and provides adequate space for the stand and your device.
- Stability Check: Gently press down on the stand to confirm it is stable and does not wobble.
Once placed, the stand is ready for use.
Image: The Unique 3D Print Robot Hand Controller Stand in purple, demonstrating its design and scale.
Operating
Using the controller stand is straightforward:
- Controller Placement: Gently place your gaming controller onto the robot hand's open palm or fingers. Ensure the controller is balanced and rests securely.
- Headset Placement: If using for a headset, drape the headset over the robot hand's fingers or wrist area, ensuring it is stable and does not obstruct the controller if both are stored simultaneously.
- Removal: Lift your device directly upwards from the stand when ready to use.
Maintenance
To ensure the longevity and appearance of your controller stand, follow these maintenance guidelines:
- Cleaning: Wipe the stand with a soft, slightly damp cloth. Avoid using abrasive cleaners, solvents, or harsh chemicals, as these may damage the 3D printed material.
- Dust Removal: Use a dry cloth or a soft brush to remove dust regularly.
- Storage: Store the stand in a cool, dry place away from direct sunlight or extreme temperatures to prevent material degradation.
Troubleshooting
If you encounter any issues with your controller stand, refer to the following common solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Stand is unstable or wobbles. | Uneven surface; improper placement. | Ensure the stand is placed on a completely flat and stable surface. Adjust its position if necessary. |
| Controller/Headset does not fit securely. | Device dimensions exceed stand capacity; improper placement. | Verify your device's dimensions against the stand's specifications (26x10 cm). Adjust the device's position on the hand for better balance. |
Specifications
- Product Dimensions (HxW): Approximately 26 cm x 10 cm (10.2 inches x 3.9 inches)
- Material: 3D Printed Polymer
- Color: Purple (as per current model)
- Compatibility: Designed for official gaming controllers and most standard headsets.
Warranty and Support
This product is handcrafted. For any questions, concerns, or issues not covered in this manual, please contact the seller directly through your purchase platform. Provide your order details for efficient assistance.
