1. Introduction
Thank you for choosing the tectake SK1000W Sandwich Maker. This appliance is designed for preparing delicious toasted sandwiches quickly and efficiently. Please read this instruction manual carefully before first use to ensure safe operation and optimal performance. Keep this manual for future reference.
2. Important Safety Instructions
- Read all instructions before using the appliance.
- Do not touch hot surfaces. Use handles or knobs.
- To protect against electrical shock, do not immerse cord, plugs, or the appliance in water or other liquid.
- Close supervision is necessary when any appliance is used by or near children.
- Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts, and before cleaning the appliance.
- Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions or has been damaged in any manner. Contact customer service for examination, repair, or adjustment.
- The use of accessory attachments not recommended by the appliance manufacturer may cause injuries.
- Do not use outdoors.
- Do not let cord hang over edge of table or counter, or touch hot surfaces.
- Do not place on or near a hot gas or electric burner, or in a heated oven.
- Extreme caution must be used when moving an appliance containing hot oil or other hot liquids.
- Always attach plug to appliance first, then plug cord into the wall outlet. To disconnect, turn any control to "off", then remove plug from wall outlet.
- Do not use appliance for other than intended use.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
3. Setup
3.1 Unpacking
Carefully remove the sandwich maker from its packaging. Retain the packaging for future storage or disposal. Ensure all components are present and undamaged. The package should contain the sandwich maker and this instruction manual.
3.2 First Use Cleaning
Before first use, wipe the non-stick cooking plates with a damp cloth or sponge. Dry thoroughly. The exterior can be wiped with a soft, damp cloth. Do not immerse the appliance in water.
3.3 Placement
Place the sandwich maker on a stable, heat-resistant, and dry surface. Ensure there is adequate ventilation around the appliance. Do not place it near flammable materials or under cabinets that could be damaged by heat or steam.
4. Operating Instructions
4.1 Preheating
- Close the sandwich maker and plug the power cord into a suitable wall outlet (220-240V).
- The red indicator light will illuminate, indicating the appliance is powered on and beginning to heat.
- Allow the sandwich maker to preheat for approximately 3-5 minutes. The green indicator light will illuminate when the optimal cooking temperature is reached.
4.2 Making Sandwiches
- Once the green indicator light illuminates, carefully open the sandwich maker using the handle.
- Place your prepared sandwiches onto the lower cooking plates. The appliance is designed for two sandwiches.
- Close the lid gently, ensuring the latch is secured. Do not force the lid shut if the sandwiches are too thick, as this may damage the appliance.
- Cook for approximately 3-6 minutes, or until the sandwiches are golden brown and the filling is heated through. Cooking time may vary depending on the ingredients and desired crispness.
- During cooking, the green indicator light may cycle on and off, indicating that the thermostat is maintaining the correct temperature.
- Once cooked, carefully open the lid and remove the sandwiches using a heat-resistant plastic or wooden utensil. Do not use metal utensils, as they can damage the non-stick coating.
- Unplug the appliance from the wall outlet after use.

Image 1: The tectake SK1000W Sandwich Maker showing its non-stick cooking plates and indicator lights. The red light indicates power, and the green light indicates readiness for cooking.
5. Cleaning and Maintenance
Always unplug the sandwich maker and allow it to cool completely before cleaning.
- Cooking Plates: The non-stick coating allows for easy cleaning. Wipe the cooking plates with a damp cloth or sponge. For stubborn residue, a small amount of mild dish soap can be used, then wipe clean with a damp cloth. Do not use abrasive cleaners, scouring pads, or metal utensils, as these will damage the non-stick surface.
- Exterior: Wipe the exterior of the appliance with a soft, damp cloth. Do not use harsh or abrasive cleaners.
- Storage: Once clean and dry, the sandwich maker can be stored in a vertical position to save space. Wrap the power cord neatly around the base if a cord wrap feature is present.
- Do not immerse the appliance in water or any other liquid.
6. Troubleshooting
- Appliance does not heat up:
- Ensure the power cord is securely plugged into a working electrical outlet.
- Check if the red indicator light is on. If not, check the power supply.
- Sandwiches are not cooking evenly:
- Ensure the appliance was fully preheated (green light on) before placing sandwiches.
- Check that the sandwiches are evenly placed on the cooking plates and the lid is closed properly.
- Adjust cooking time as needed.
- Smoke or unusual odor during first use:
- A slight smoke or odor may occur during the first use due to manufacturing residues. This is normal and should dissipate quickly. Ensure good ventilation. If it persists, unplug the appliance and contact customer support.
7. Specifications

Image 2: The tectake SK1000W Sandwich Maker with key dimensions and technical details highlighted.
| Model Number | 405369 |
| Total Dimensions (L x W x H) | Approx. 29 cm x 24.5 cm x 10 cm |
| Per Sandwich Compartment | Approx. 14.5 cm x 13.5 cm |
| Weight | Approx. 1.7 kg |
| Power | 1000 W |
| Voltage | 220 - 240 V (AC) |
| Cable Length | Approx. 63 cm |
| Materials | Aluminum, Bakelite, Stainless Steel, Copper Alloy, Polyvinyl Chloride |
| Special Features | Temperature control, Non-stick coating |
8. Warranty and Support
This product is covered by the standard warranty terms and conditions of tectake. For detailed warranty information, please refer to the documentation provided with your purchase or visit the official tectake website. If you encounter any issues or require technical assistance, please contact tectake customer support. Information regarding spare parts availability is not provided in this manual.
For further assistance, please visit the tectake Brand Store.





