Introduction
This manual provides instructions for the Fastrack StreetStyle Digital Watch, model 38120PP01. Please read this manual thoroughly to understand the watch's functions and proper operation. This digital watch is designed for daily wear and features a segmented digital display, multi-function capabilities, and a durable silicone strap.
Front view of the Fastrack StreetStyle Digital Watch, displaying time and date.
Setup
Initial Power On
The watch comes with a pre-installed Lithium Polymer battery. It should be ready for immediate use. If the display is blank, press any button to activate it. If it remains blank, the battery may need replacement (refer to Maintenance section).
Setting Time and Date
Your Fastrack StreetStyle Digital Watch features multiple buttons for operation. Typically, digital watches have a "MODE" button to cycle through functions and "SET" or "ADJUST" buttons to modify values. Refer to the button diagram below for general guidance.
Angled view of the watch, highlighting the side control buttons.
- Identify Buttons: Locate the buttons on the side of the watch. There are typically two on the right and two on the left.
- Enter Setting Mode: Press and hold the "MODE" or "SET" button (usually bottom-left or top-left) until the time display starts flashing.
- Adjust Values: Use the "ADJUST" or "UP/DOWN" buttons (usually on the right side) to change the flashing value (e.g., hours, minutes).
- Navigate Settings: Press the "MODE" button again to move to the next setting (e.g., minutes, year, month, day).
- Exit Setting Mode: Once all settings are adjusted, press the "MODE" button again, or wait for the watch to automatically exit setting mode.
Operating Instructions
Display Modes
Press the "MODE" button (typically bottom-left) to cycle through different display modes:
- Time Mode: Displays current time (hours, minutes, seconds), day, and date.
- Alarm Mode: Allows setting and activating an alarm.
- Stopwatch Mode: For timing events.
- Chime Mode: Activates or deactivates the hourly chime.
Using the Stopwatch
- Enter Stopwatch Mode: Press the "MODE" button until "STW" or "STOPWATCH" appears on the display.
- Start/Stop: Press the "START" button (typically top-right) to begin timing. Press it again to stop.
- Reset: While the stopwatch is stopped, press the "RESET" button (typically bottom-right) to clear the time to zero.
Setting the Alarm
- Enter Alarm Mode: Press the "MODE" button until "ALM" or "ALARM" appears.
- Set Alarm Time: Press and hold the "SET" button until the alarm time flashes. Use the "ADJUST" buttons to set the desired hour and minute.
- Activate/Deactivate Alarm: In Alarm Mode, press the "START" button to toggle the alarm ON/OFF. An alarm icon will appear when active.
Using the Light Feature
Press the "LIGHT" button (typically top-left) to illuminate the display for a few seconds in low-light conditions.
Maintenance
Cleaning Your Watch
Wipe the watch case and silicone strap with a soft, damp cloth. Avoid using harsh chemicals or abrasive cleaners, as these can damage the finish or strap material.
Battery Replacement
The watch uses one Lithium Polymer battery. When the display dims or functions become erratic, it may be time to replace the battery. Battery replacement should ideally be performed by a qualified watch technician to ensure proper sealing and water resistance. Attempting to replace the battery yourself may void the warranty and compromise the watch's water resistance.
Water Resistance
This watch is water resistant up to 30 meters (3 ATM). This means it is suitable for everyday use and can withstand splashes or brief immersion in water. It is not suitable for swimming, diving, or showering with hot water, as steam and pressure changes can compromise the seals. Do not operate buttons while the watch is wet.
The watch's case back indicates 30M water resistance.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Display is blank or dim. | Low or depleted battery. | Replace the battery (refer to Maintenance). |
| Time is incorrect. | Time not set correctly or accidental button press. | Reset the time and date (refer to Setup). |
| Buttons are unresponsive. | Watch may be in a locked mode or battery is very low. | Try pressing all buttons to see if any respond. If not, consider battery replacement. |
| Water inside the watch. | Water resistance compromised due to impact, improper battery change, or exposure to excessive water pressure/steam. | Immediately take the watch to an authorized service center. Do not attempt to dry it yourself. |
Specifications
- Brand: Fastrack
- Model: 38120PP01
- Model Name: StreetStyle
- Display Type: Digital
- Case Material: Matte Black
- Strap Material: Silicone
- Power Source: Battery Powered
- Battery Type: 1 Lithium Polymer (included)
- Special Features: Light Up, Second Hand, Alarm, Chime, Stopwatch
- Water Resistance: 30 Meters (3 ATM)
- Product Dimensions: 13 x 9 x 6 cm
- Item Weight: 153 g
- Country of Origin: India
- Manufacturer: Titan Company Limited
Warranty and Support
For warranty information and customer support, please refer to the warranty card included with your purchase or visit the official Fastrack website. Keep your purchase receipt as proof of purchase for warranty claims.
Manufacturer: Titan Company Limited, #3, SIPCOT Industrial Complex, Hosur - 635126, Tamil Nadu, India.
For service or inquiries, please contact Fastrack customer service through their official channels. You can often find contact details on the brand's official website: www.fastrack.in