Aquasonic Icon Toothbrush & Water Flosser Bundle Instruction Manual

Introduction

This manual provides essential instructions for the safe and effective use of your Aquasonic Icon Toothbrush and Water Flosser Bundle. This oral care system is designed to enhance your daily hygiene routine, offering both advanced brushing and targeted water flossing capabilities.

Important Safety Information

Please read all safety warnings before using the device.

• Do not use if you have a history of oral disease or injury. Consult your dentist before use if you have any medical conditions.
• Keep the device away from water while charging.
• Do not use while sleeping or unconscious.
• Statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition.

Package Contents

Your Aquasonic Icon Bundle includes the following items:

• Aquasonic Icon Rechargeable Toothbrush
• Aquasonic Icon Rechargeable Water Flosser
• Replacement Brush Head
• Charging cables (not explicitly listed but implied for rechargeable devices)

Setup

1. Initial Charge: Charge both the Aquasonic Icon Toothbrush and Water Flosser before their first use. Ensure devices are dry before connecting to power.
2. Prepare Water Flosser: Fill the water tank of the water flosser with warm water.

Image: The Aquasonic Icon Toothbrush connected to a charging cable, illustrating its rechargeable battery feature.

Image: A person filling the large, easy-to-access water tank of the Aquasonic Icon Water Flosser under a faucet.

Operating Instructions

Aquasonic Icon Toothbrush

The Icon Toothbrush is ADA-approved and features micro-vibrational brushing for an effective clean. It offers two brushing modes:

• Clean Mode: For daily plaque removal.
• Whiten Mode: For surface stain removal.

1. Apply a small amount of toothpaste to the brush head.
2. Select your desired brushing mode (Clean or Whiten) using the mode button.
3. Place the brush head against your teeth at a slight angle towards the gumline.
4. Move the toothbrush gently across all surfaces of your teeth, using a normal brushing motion. The toothbrush will provide micro-vibrations to assist in cleaning.

Image: A detailed view of the Aquasonic Icon Toothbrush handle, highlighting the 'clean' and 'whiten' mode indicators and the power button.

Image: A person demonstrating the use of the Aquasonic Icon Toothbrush, emphasizing its micro-vibrational cleaning and ADA acceptance.

Aquasonic Icon Water Flosser

The Icon Water Flosser provides targeted water flossing with customizable pressure settings:

• Normal Mode: For everyday cleaning.
• Soft Mode: For sensitive gums.
• Pulse Mode: For gum massage and enhanced cleaning.

1. Select the desired water pressure setting (Normal, Soft, or Pulse) on the device.
2. Lean over the sink and place the tip of the water flosser in your mouth.
3. Turn on the device and close your lips to form a tight seal around the tip to prevent splashing.
4. Guide the tip along your gum line and between your teeth, focusing on each area for a few seconds. The 360° rotating tip allows for easy access to all areas.

Image: The Aquasonic Icon Water Flosser showcasing its modern design, three flossing modes, 360-degree rotating tip, and leak-proof water tank.

Image: The Aquasonic Icon Water Flosser demonstrating its user-friendly two-button operation and the removable tank for easy cleaning.

Image: A woman using the Aquasonic Icon Water Flosser, illustrating its ability to provide an ultimate deep clean and remove plaque effectively.

Maintenance

1. Clean Flosser Tip: After each use, remove the water flosser tip and rinse it thoroughly under warm water.
2. Storage: Store both devices with their respective tips facing up to allow for proper air drying and prevent moisture buildup.
3. Recharging: Charge the devices after each use to ensure they are ready for your next oral care routine. The toothbrush offers 30+ days of brushing on a single charge, and the water flosser provides 90+ days of flossing.
4. Brush Head Replacement: Replace the toothbrush head every three months, or sooner if bristles are frayed.

Image: The Aquasonic Icon Toothbrush and Water Flosser displayed with their sleek storage options, including a magnetic holder and a slim travel case.

Specifications