Introduction
Welcome to the SLOPEHILL Dog Training Collar instruction manual. This device is designed to assist in humane and effective dog training through various modes, including beep, vibration, safe shock, and flash light. It is suitable for small, medium, and large dogs, aiming to improve behavior and enhance communication between you and your pet.
Package Contents
The SLOPEHILL Dog Training Collar package includes:
- Remote Control
- Receiver Collar (Orange, IP68 Waterproof)
- USB Charging Cable (Dual Type-C)
- Lanyard
- Conductive Silicone Contact Points (various lengths)
- Test Light
- User Manual
Image: The complete SLOPEHILL Dog Training Collar kit, including the remote control and the orange receiver collar.
Setup Guide
Charging the Device
Both the remote and receiver are rechargeable. Use the provided dual Type-C USB cable to charge both units simultaneously.
- Connect the USB cable to a power source (e.g., laptop, phone charger, PC, power bank).
- Connect the Type-C ends to the charging ports on the remote and receiver.
- A full charge takes approximately 2 hours. The collar can work for 15-20 days, and the remote for up to 45 days on a single charge.
Image: The remote and receiver collar connected to the dual Type-C USB charging cable, illustrating the charging process.
Adjusting Collar Fit
Ensure the collar fits snugly but comfortably around your dog's neck. The strap is adjustable from 8 to 26 inches and can be trimmed if too long.
Image: Diagram illustrating the adjustable collar strap and recommended dog weight range (8-140 lbs) for proper fit.
Pairing the Remote and Receiver
To pair your remote and receiver:
- Long press the receiver button.
- After a beep, the green light on the receiver will flash continuously.
- Then, press any function button on the remote control.
- The receiver will beep again when the pairing is successful.
Video: A detailed demonstration of the functional operations of the Slopehill Dog Shock Collar, including the pairing process.
Replacing Electrode Columns
To replace the electrode columns:
- Remove the two conductive silicone caps.
- Use the hexagonal holes on the electric shock test lamp to unscrew the two electrode columns.
- Replace the electric shock column with another length and tighten it, and finally install the conductive silicone cap.
Video: Step-by-step guide on how to replace the electrode columns on the receiver collar.
Operating Modes
The SLOPEHILL Dog Training Collar offers five humane training modes:
- Beep Mode: Provides an audible tone (1-8 levels).
- Vibration Mode: Delivers a vibration (0-8 levels).
- Safe Shock Mode: Provides static stimulation (0-99 levels).
- Flash Light Mode: Activates a light on the collar (solid or flashing).
- No Shock Mode: Disables the static shock function for safety.
To select and adjust modes:
- Press the top knob on the remote to cycle through beep, vibration, and shock modes.
- Rotate the knob to adjust the intensity level for the selected mode.
Image: Visual representation of the five effective training modes: Beep, Vibration, Shock, Flash Light, and No Shock.
Testing the Shock Function
To test the electric shock function safely:
- Connect the test light to the receiver's two electric shock pins.
- Push the remote control's electric shock button (ensure the intensity level is more than 0).
- The test red light will illuminate if the shock function is working.
Video: Demonstration of how to test the electric shock function using the provided test light.
