WEWARM Small Space Heater (Model HT1118C) Instruction Manual

Introduction

This manual provides essential instructions for the safe and efficient operation, maintenance, and troubleshooting of your WEWARM Small Space Heater, Model HT1118C. Please read this manual thoroughly before using the appliance and retain it for future reference.

Important Safety Instructions

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

• Read all instructions before using this heater.
• This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handles when moving this heater.
• Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.
• Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
• Always unplug heater when not in use.
• Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.
• Do not use outdoors.
• This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over.
• To disconnect heater, turn controls to OFF, then remove plug from outlet.
• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
• This heater has an automatic overheat protection system that will shut off the unit when parts of the heater get excessively hot. If the unit shuts off, immediately turn the heater OFF and inspect for any objects on or adjacent to the heater that may cause high temperatures.
• This heater is equipped with a tip-over safety switch. If the heater is accidentally tipped over, it will automatically shut off. To reset, simply place the heater upright.

Product Overview

The WEWARM Small Space Heater (Model HT1118C) is a compact and portable heating solution designed for indoor use. It features PTC ceramic heating technology for rapid and consistent warmth, along with multiple safety features.

Key Features:

• Dual Heat Settings: 1,000W (Low Heat) and 1,500W (High Heat) for customizable comfort.
• PTC Ceramic Heating Element: Ensures rapid heating and consistent temperature.
• Adjustable Thermostat: Allows you to set and maintain your desired room temperature.
• Fan-Only Mode: Provides air circulation during warmer months.
• Safety Features: Overheat protection, tip-over switch, and a cool-touch exterior.
• Integrated Carry Handle: For easy portability.

Figure 1: Multi-mode selections for the WEWARM Space Heater, including 1000W low heat, 1500W high heat, and fan-only options.

Figure 2: Overview of the WEWARM Space Heater's safety features, including PTC ceramic heating, TUV certification, overheat protection, and a tip-over switch.

Setup

1. Unpacking: Carefully remove the heater from its packaging. Retain the packaging for storage or if the product needs to be returned.
2. Placement: Place the heater on a firm, level surface. Ensure there are no obstructions within 3 feet (0.9 m) of the front, sides, and rear of the heater. Do not place it on soft surfaces like rugs or carpets that could block air vents.
3. Power Connection: Plug the power cord directly into a 120V AC, 60Hz electrical outlet. Do not use extension cords or power strips, as they may overheat and cause a fire risk.

Operating Instructions

Your WEWARM Space Heater features two control knobs on the top panel for power/mode selection and thermostat adjustment.

Control Knobs:

• Mode Selector Knob (Right Knob): This knob controls the power and fan settings.
• OFF: Turns the heater off.
• FAN ONLY (💨): Activates the fan without heat for air circulation.
• LOW HEAT (1): Provides 1,000W of heating power.
• HIGH HEAT (2): Provides 1,500W of heating power.
• Thermostat Control Knob (Left Knob): This knob adjusts the desired temperature.
• Turn the knob from MIN to MAX to set your preferred temperature. The heater will cycle on and off to maintain this temperature.

Maintenance

Regular maintenance ensures optimal performance and longevity of your heater.

1. Cleaning:
   • Always unplug the heater and allow it to cool completely before cleaning.
   • Use a soft, damp cloth to wipe the exterior surfaces of the heater.
   • Do not use cleaning sprays, abrasive cleaners, or polishes as they may damage the finish.
   • Use a vacuum cleaner with a brush attachment to gently remove dust and lint from the air intake and exhaust grilles.
   • Never immerse the heater in water or allow water to drip into the motor housing.
2. Storage:
   • Store the heater in a cool, dry location when not in use.
   • To prevent dust and dirt build-up, it is recommended to store the heater in its original packaging.

Troubleshooting

If your heater is not operating correctly, please refer to the following common issues and solutions:

Specifications

Warranty and Support

For warranty information or technical support, please contact WEWARM customer service. Details can typically be found on the product packaging or the official WEWARM website.

Please have your model number (HT1118C) and purchase date available when contacting support.

For further assistance, you may visit the WEWARM Store on Amazon.