Lasko S16500 16" Oscillating Adjustable Pedestal Stand 3 Speed Fan

1. Introduction

The Lasko S16500 is a 16-inch oscillating pedestal fan designed to provide efficient air circulation and cooling. It features three speed settings and an adjustable height, allowing you to direct airflow precisely where needed. This manual provides essential information for the safe and effective use of your fan.

Figure 1.1: Front view of the Lasko S16500 Pedestal Fan.

2. Important Safety Instructions

Please read and save these important safety instructions before using this fan. Failure to follow these instructions may result in electric shock, fire, or injury.

• Always plug the fan directly into a 120V AC wall outlet. Never use with an extension cord.
• Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized service facility for examination and/or repair.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
• To disconnect fan, first turn controls to OFF, then remove plug from outlet.
• Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the fan.
• Do not block air intakes or exhaust in any manner. Do not use on any soft surface, like a bed, where openings may become blocked.
• This fan is not intended for use in wet or damp locations. Never locate fan where it may fall into a bathtub or other water container.
• Do not use fan outdoors or in wet locations.
• This fan is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please refer to National Electric Code (NEC) Article 547-7 (2008), or applicable state or local codes or standards relating to electrical requirements for Agricultural Buildings.
• This fan does not meet the requirements of NEC Article 500 (2008) for Hazardous Locations.
• Always place the fan on a stable, flat surface during operation to prevent tipping.
• Unplug the fan from the power outlet when not in use or when moving it.

3. Package Contents

Before beginning assembly, ensure all parts are present and accounted for:

• Fan Head Assembly (with motor and blades)
• Adjustable Height Pole
• Base
• Power Cord (pre-attached to fan head)

4. Setup and Assembly

The Lasko S16500 fan is designed for simple, no-tools assembly. Follow these steps to set up your fan:

1. Attach the Pole to the Base: Insert the bottom end of the adjustable height pole into the center opening of the fan base. Twist or secure according to the markings until it is firmly seated.
2. Attach the Fan Head to the Pole: Carefully place the fan head assembly onto the top of the adjustable height pole. Ensure it clicks into place or is secured with any provided locking mechanisms.
3. Adjust Height (Optional): Loosen the height adjustment collar on the pole, extend or retract the pole to your desired height, and then tighten the collar securely.
4. Position the Fan: Place the assembled fan on a stable, flat surface, ensuring the power cord is not obstructed or in a high-traffic area.

5. Operating Instructions

Once assembled, your Lasko S16500 fan is ready for operation.

5.1 Powering On/Off and Speed Settings

• Plug the fan's power cord into a standard 120V AC wall outlet.
• Locate the speed control knob or buttons, typically on the fan's motor housing.
• Select your desired fan speed:
• 0 (Off): Turns the fan off.
• 1 (Low): Provides a gentle breeze.
• 2 (Medium): Offers moderate airflow.
• 3 (High): Delivers maximum air circulation.

5.2 Oscillation Function

To enable the fan to oscillate (swing from side to side), locate the oscillation knob or button on top of the motor housing. Press it down to engage oscillation. Pull it up to stop oscillation and direct airflow in a fixed direction.

5.3 Height Adjustment

The fan's height can be adjusted to suit your needs. Loosen the height adjustment collar on the pole, slide the inner pole up or down to the desired height, and then firmly tighten the collar to secure it in place.

Figure 5.1: Illustration of the fan's adjustable height feature.

5.4 Tilt Adjustment

The fan head can be tilted up or down to direct airflow. Gently push or pull the fan head to the desired angle. The fan head will hold its position once adjusted.

Figure 5.2: Illustration of the fan's adjustable tilt feature.

6. Maintenance and Care

Proper maintenance ensures the longevity and efficient operation of your fan.

• Cleaning: Always unplug the fan before cleaning. Use a soft, damp cloth to wipe the exterior surfaces of the fan. Do not use harsh chemicals or abrasive cleaners. For dust accumulation on the fan blades, you may carefully remove the front grille (if designed for removal) and wipe the blades. Ensure all parts are dry before reassembling and plugging in.
• Storage: When not in use, store the fan in a cool, dry place. It is recommended to store it in its original box or cover it to protect it from dust.
• Motor Lubrication: The fan motor is permanently lubricated and requires no further lubrication.

7. Troubleshooting

If your fan is not operating as expected, consult the following table for common issues and solutions.

If the problem persists after attempting these solutions, please contact Lasko customer support.

8. Specifications

Key technical specifications for the Lasko S16500 Pedestal Fan:

Figure 8.1: Key dimensions and features of the Lasko S16500 Pedestal Fan.

9. Warranty and Support

For information regarding warranty coverage, product registration, or technical support, please refer to the warranty card included with your purchase or visit the official Lasko website. You may also contact Lasko customer service directly for assistance with any issues not covered in this manual.

Lasko Customer Service:

• Website: www.lasko.com (Please check for the most current contact information)
• Phone: Refer to website or product packaging for current phone numbers.