Introduction
This manual provides instructions for the Re-Flix Superior Light 4-in-1 Universal Remote Control, specifically pre-programmed for your SABA M6301 TV. This remote is designed for immediate use upon battery insertion, eliminating the need for complex code setup.
While this remote is a 4-in-1 universal model, it has been pre-configured for a single device as specified in the product listing. Should you wish to program it for additional devices, a separate USB programming device is required (not included).
Figure 1: Side view of the Re-Flix Superior Light 4-in-1 Remote Control. This image displays the ergonomic design and the arrangement of buttons along its length.
Setup
1. Battery Installation
The remote control requires two (2) AAA 1.5V batteries (not included). Follow these steps to install them:
- Locate the battery compartment cover on the back of the remote control.
- Slide the cover downwards or press the latch to open it.
- Insert two AAA batteries, ensuring the positive (+) and negative (-) terminals match the diagrams inside the compartment.
- Replace the battery compartment cover, sliding it back into place until it clicks securely.
Important: Ensure correct battery polarity to prevent damage to the remote control.
Figure 2: Back view of the remote control, highlighting the battery compartment. This is where the 2x AAA batteries are inserted.
2. Initial Use (Pre-programmed)
Your Re-Flix Superior Light remote control is pre-programmed for the SABA M6301 TV. Once batteries are installed, it is ready for immediate use. No code entry or additional setup is required for the specified device.
Compatibility Check: Always ensure that the model designation of your device or original remote control matches the model indicated in the product description (SABA M6301).
Operating Instructions
To operate your SABA M6301 TV with the Re-Flix Superior Light remote control:
- Point the remote control directly at your SABA M6301 TV.
- Press the desired function button (e.g., Power, Volume Up/Down, Channel Up/Down, Menu).
- Ensure there are no obstructions between the remote control and the TV's infrared receiver.
The remote control transmits commands via infrared signals. For optimal performance, maintain a clear line of sight.
Advanced Programming (Optional)
As a 4-in-1 universal remote, this device has the capability to control up to four different devices. However, this requires a separate USB programming device, which is not included with your purchase. If you wish to program the remote for additional devices, please refer to the instructions provided with the USB programming device.
Maintenance
Battery Replacement
Replace the batteries when the remote control's response becomes sluggish or stops working. Always replace both AAA batteries simultaneously with new ones. Do not mix old and new batteries, or different types of batteries.
Cleaning
To clean the remote control, gently wipe its surface with a soft, dry cloth. Do not use abrasive cleaners, solvents, or wet cloths, as these can damage the remote's finish or internal components.
Storage
When not in use for extended periods, it is recommended to remove the batteries to prevent leakage and potential damage to the remote control.
Troubleshooting
- Remote Control Not Working:
- Check if the batteries are inserted correctly with the correct polarity.
- Replace old batteries with new AAA batteries.
- Ensure there is a clear line of sight between the remote control and the TV's infrared receiver.
- Verify that the remote control is pointed directly at the TV.
- Confirm that your TV model (SABA M6301) matches the pre-programmed remote.
- Buttons Not Responding:
- This often indicates low battery power. Replace the batteries.
- Ensure no foreign objects are lodged under the buttons.
- Loss of Settings:
- The Re-Flix Superior Light remote control is designed to retain its programming even when batteries are removed or depleted. If settings are lost, it may indicate a fault with the remote or an incorrect programming procedure if you attempted advanced programming.
Specifications
| Brand | Re-Flix |
| Model Number | 747516 |
| Product Type | 4-in-1 Universal Remote Control (pre-programmed for SABA M6301 TV) |
| Compatible Devices | Television (SABA M6301) |
| Connectivity Technology | Infrared (IR) |
| Batteries Required | 2 x AAA 1.5V (not included) |
| Weight | 89 g |
| Dimensions (L x W x H) | 21.0 x 4.7 x 2.0 cm |
Warranty Information
Specific warranty details for the Re-Flix Superior Light 4-in-1 Remote Control are not provided in the product information. Please refer to your purchase documentation or contact the seller directly for warranty terms and conditions.
Customer Support
For technical assistance or further inquiries regarding your Re-Flix Superior Light 4-in-1 Remote Control, please contact the seller or manufacturer through the platform where the product was purchased. Ensure you have your product model number (747516) and purchase details available when seeking support.
Manufacturer: Re-Flix
