A3 Gal Gamers 02 Rine Suzuki & Yuu Kunioka Character Acrylic Figure Instruction Manual

1. Introduction

Thank you for purchasing the A3 Gal Gamers 02 Rine Suzuki & Yuu Kunioka Character Acrylic Figure. This manual provides essential information for the proper setup, display, and care of your collectible figure. Please read these instructions carefully to ensure the longevity and enjoyment of your product.

2. Safety Information

• This product is a collectible item and not a toy. It is recommended for ages 15 years and up.
• Keep out of reach of small children to prevent accidental ingestion of small parts.
• Avoid exposing the figure to direct sunlight or high temperatures, as this may cause discoloration or deformation.
• Handle with care to prevent scratches or breakage. The edges of acrylic may be sharp.
• Do not use harsh chemicals or abrasive materials for cleaning.

3. Package Contents

Upon opening the package, please verify that all components are present and undamaged:

• 1 x Gal Gamers 02 Rine Suzuki & Yuu Kunioka Character Acrylic Figure
• 1 x Base (if applicable, check packaging)

If any parts are missing or damaged, please contact the retailer or manufacturer for assistance.

4. Setup and Display

This section guides you through the assembly and proper placement of your acrylic figure.

1. Unpacking: Carefully remove the figure and any accompanying base from its packaging. Retain packaging for future storage or transport.
2. Assembly (if required): If the figure comes with a separate base, gently insert the figure's tab into the slot on the base. Ensure a snug fit without forcing.
3. Placement: Choose a stable, flat surface for display. Avoid areas prone to vibrations, direct sunlight, or extreme temperature changes.
4. Protective Film: Some acrylic figures may have a thin protective film on one or both sides. Carefully peel this off for optimal clarity.

Image 1: The Gal Gamers 02 Rine Suzuki & Yuu Kunioka Character Acrylic Figure. This image shows the assembled figure, featuring the two characters Rine Suzuki and Yuu Kunioka in an official illustration style, standing on a clear base.

5. Handling and Care

Proper handling and care will help maintain the condition of your figure.

• Always handle the figure by its base or edges to avoid touching the printed surface directly, which can leave fingerprints or cause damage over time.
• To clean dust, use a soft, dry microfiber cloth. Gently wipe the surface.
• For stubborn smudges, lightly dampen a microfiber cloth with water and a tiny amount of mild soap (e.g., dish soap). Wipe gently, then dry immediately with a clean, dry microfiber cloth.
• Do not use alcohol, ammonia-based cleaners, or abrasive materials, as these can damage the acrylic or the printed illustration.

6. Troubleshooting

This section addresses common minor issues you might encounter.

• Figure is wobbly on base: Ensure the figure's tab is fully inserted into the base slot. If it's still loose, check for any debris in the slot or on the tab.
• Dust accumulation: Use a soft brush or microfiber cloth to gently remove dust. For hard-to-reach areas, a can of compressed air (held upright and at a distance) can be used.
• Minor scratches: Acrylic is prone to minor surface scratches. Avoid rubbing vigorously. For very fine scratches, specialized acrylic polish kits are available, but use with caution and test on an inconspicuous area first.

7. Specifications

8. Warranty and Support

This product is manufactured by A3. For any questions regarding product defects, missing parts, or general inquiries, please contact the retailer where the product was purchased or refer to the manufacturer's official website for support information.

Please retain your proof of purchase for any warranty claims.