SOLLA SOLLA 600W LED Floodlight & 400W LED Flood Light

SOLLA LED Flood Light Instruction Manual

Models: 600W (48000lm) & 400W (32000lm)

1. Introduction

This manual provides essential information for the safe installation, operation, and maintenance of your SOLLA LED Flood Light. Please read these instructions thoroughly before installation and retain them for future reference. The SOLLA LED Flood Light is designed for outdoor use, providing high-brightness illumination for various applications such as gardens, yards, parking lots, and streets.

2. Important Safety Information

  • Electrical Safety: Installation must be performed by a qualified electrician in accordance with all local electrical codes and regulations. Ensure power is disconnected at the circuit breaker before installation or servicing.
  • Grounding: The fixture must be properly grounded to prevent potential electrical shock.
  • Voltage: Verify that the supply voltage is compatible with the fixture's requirements.
  • Heat: Do not touch the fixture when it is operating or immediately after turning it off, as it may be hot.
  • Waterproof Rating: The fixture is IP66 rated for outdoor use, protecting against dust and powerful water jets. Do not submerge the fixture in water.
  • Eye Protection: Avoid looking directly into the LED light source when illuminated, as it can cause eye strain or damage.

3. Package Contents

Verify that all components are present and undamaged upon opening the package:

  • SOLLA LED Flood Light Unit (1x 600W and/or 1x 400W)
  • Adjustable Mounting Bracket (pre-attached)
  • Instruction Manual

4. Product Specifications

Feature400W Model600W Model
Power Consumption400W600W
Luminous Flux32000lm48000lm
Color Temperature6000K Daylight White
Beam Angle140°
IP RatingIP66 (Waterproof & Dustproof)
Surge Protection10KV
Lifespan>50,000 hours
MaterialDie-casting Aluminum, Tempered Glass
Cable Length1.1m (43.3in)
Dimensions (W x H x D)51cm x 37cm x 7.6cm (20in x 14.6in x 3in)56.59cm x 44.47cm x 10.38cm (22.28in x 17.51in x 4.09in)
Mounting OptionsWall, Ground, Ceiling

Note: This light might be larger than anticipated. Please check the measurements carefully before installation.

5. Installation Instructions

The SOLLA LED Flood Light is designed for hardwired installation. Professional installation is recommended.

5.1 Component Overview

Diagram showing components of the SOLLA LED Flood Light, including waterproof joint, die-casting aluminum fin heatsinks, waterproof and dustproof tempered glass, Hi-Q SMD LED chips, SPD lightning-proof, and cable with live, neutral, and earth wires.

Figure 1: Key components of the SOLLA LED Flood Light, highlighting the robust construction and electrical connections.

5.2 Mounting Options

The adjustable metal bracket allows for versatile mounting:

  • Wall-mount: Secure the bracket to a vertical surface.
  • Ground-mount: Attach the bracket to a horizontal surface or stake.
  • Ceiling-mount: Fasten the bracket to an overhead structure.
Diagram showing dimensions of the 400W SOLLA LED Flood Light and illustrations of wall, ground, and ceiling mounting options.

Figure 2: 400W Model dimensions and various mounting configurations.

Diagram showing dimensions of the 600W SOLLA LED Flood Light and illustrations of wall, floor, and ceiling mounting options.

Figure 3: 600W Model dimensions and various mounting configurations.

5.3 Wiring Instructions

The flood light is hardwired and does not include a plug. Follow these steps for electrical connection:

  1. Disconnect Power: Ensure the main power supply to the installation area is turned off at the circuit breaker.
  2. Identify Wires: The fixture cable contains three wires: Live (black), Neutral (white), and Earth/Ground (green/yellow).
  3. Connect Wires: Connect the fixture's wires to the corresponding wires from your power supply using appropriate wire connectors (not included).
    • Black (Live) to Live
    • White (Neutral) to Neutral
    • Green/Yellow (Earth) to Earth/Ground
  4. Secure Connections: Ensure all connections are secure and insulated.
  5. Restore Power: Once installation is complete and verified, restore power at the circuit breaker.
Diagram illustrating the wiring connections for the SOLLA LED Flood Light, showing Live (black), Neutral (white), and Earth (green) wires.

Figure 4: Wiring diagram for the SOLLA LED Flood Light.

6. Operating Instructions

Once properly installed and wired, the SOLLA LED Flood Light operates by simply turning on the power supply to which it is connected. The light is designed for immediate full brightness.

  • Power On/Off: Control the light using the wall switch or circuit breaker connected to the fixture.
  • Non-Dimmable: This flood light is NOT Dimmable. Do not connect it to a dimmer switch, as this may damage the unit.
  • Wide Illumination: The 140° wide beam angle ensures broad and even light distribution.
Chart showing lighting distance and area for reference for the 400W SOLLA LED Flood Light, indicating it is not dimmable.

Figure 5: Lighting distance and area reference for 400W model, confirming non-dimmable feature.

7. Maintenance

The SOLLA LED Flood Light requires minimal maintenance due to its durable design and long-lasting LED technology.

  • Cleaning: Periodically clean the tempered glass surface with a soft, damp cloth to remove dirt and debris. Do not use abrasive cleaners or solvents. Ensure the power is off before cleaning.
  • Inspection: Regularly inspect the fixture for any signs of damage to the housing, cable, or mounting bracket. Address any issues promptly.
  • No User-Serviceable Parts: There are no user-serviceable parts inside the fixture. Do not attempt to open or repair the unit, as this will void the warranty and may pose a safety risk.

8. Troubleshooting

If you encounter issues with your SOLLA LED Flood Light, refer to the following common problems and solutions:

ProblemPossible CauseSolution
Light does not turn onNo power supply
Incorrect wiring
Faulty switch/breaker
Check power supply to the fixture.
Verify wiring connections (Live, Neutral, Earth).
Test the switch or circuit breaker.
Light flickersLoose wiring connection
Incompatible dimmer switch
Check and secure all wiring connections.
Ensure the light is not connected to a dimmer switch.
Reduced brightnessDirt or debris on lensClean the tempered glass lens with a soft, damp cloth.

If the problem persists after attempting these solutions, please contact customer support.

9. Warranty and Support

SOLLA LED Flood Lights are built for durability and a long operational lifespan of over 50,000 hours. For any questions regarding your product, installation, or troubleshooting, please do not hesitate to contact our customer support team. We are committed to providing assistance and will respond to your inquiries within 24 hours.

For support, please refer to the contact information provided with your purchase or visit the official SOLLA website.

Related Documents - SOLLA 600W LED Floodlight & 400W LED Flood Light

Preview SOLLA RGBCW Smart Flood Light User Manual - Installation, Features, and Support
Comprehensive user manual for the SOLLA RGBCW Smart Flood Light. Includes safety instructions, installation guide, app features, troubleshooting, and FCC statement.
Preview SOLLA LED Motion Sensing Security Light - Outdoor Floodlight with Motion Detection and Dusk to Dawn
Comprehensive user manual for the SOLLA LED Motion Sensing Security Light. Covers safety instructions, specifications, installation, operation, and custom settings for outdoor security lighting. Features include adjustable detection range, dimmable brightness, and IP65 rating.
Preview SOLLA LED Motion Sensing Security Light User Manual
User manual for the SOLLA LED Motion Sensing Security Light. Provides detailed instructions for installation, operation, safety precautions, and specifications. Features adjustable motion detection, dimming capabilities, and IP65 weather resistance.
Preview VEVOR Solar Street Light User Manual and Installation Guide
This VEVOR Solar Street Light manual provides essential information on product overview, remote control operation with multiple brightness modes, installation guidance including wall and pole mounting, and optimal solar panel orientation for maximum efficiency. It covers troubleshooting tips and contact details for support.
Preview Gefolly 600W Solar Street Light Manual: Features, Specifications, and Remote Control Guide
Comprehensive manual for the Gefolly 600W Solar Street Light, detailing its features, specifications, installation, light and motion sensor modes, and remote control functions. Includes energy-saving benefits and operational tips for outdoor security and illumination.
Preview LOYEOLE Solar Street Light User Manual
User manual for the LOYOELE Solar Street Light, detailing package contents, installation instructions for wall and pole mounting, remote control functions, motion sensor mode, and troubleshooting tips.