Introduction
Thank you for choosing the TOY Life Space Adventure Set. This manual provides essential information for the safe assembly, operation, and maintenance of your new toy. Please read it thoroughly before use and retain it for future reference.
Image: The complete TOY Life Space Adventure Set, including a rocket, space shuttle, and two astronaut figures, being held by a child.
Package Contents
Verify that all components are present in your package:
- 1x Rocket Ship
- 1x Space Shuttle
- 2x Astronaut Figures (one white, one green)
- 1x Space Satellite
- 1x Aircraft/Rover
- 1x Water Bottle (for smoke effect)
Image: A visual breakdown of the TOY Life Space Adventure Set, showing the rocket, space shuttle, two astronaut figures, aircraft, water bottle, and satellite, each numbered for identification.
Setup and Assembly
1. Battery Installation
The rocket and space shuttle require batteries for light and sound effects. Locate the battery compartments, typically on the underside or rear of each unit. Insert the required batteries (not included) according to the polarity indicators (+/-).
Warning: Ensure batteries are inserted correctly. Do not mix old and new batteries, or different types of batteries.
2. Rocket Assembly and Astronaut Placement
The rocket features a detachable top section for astronaut placement.
- To separate the rocket pod, gently twist the top section counter-clockwise and lift.
- Open the door on the rocket pod to reveal the astronaut seat.
- Place an astronaut figure inside the seat.
- Close the door and reattach the rocket pod to the main rocket body by aligning and twisting clockwise until secure.
Image: A step-by-step visual guide demonstrating how to twist and separate the rocket's top pod, open its door, and place an astronaut figure inside.
Image: A close-up view of an astronaut figure seated within the detachable rocket pod, illustrating the internal compartment.
3. Space Shuttle Preparation
The space shuttle also has an opening cockpit for an astronaut figure. Place an astronaut inside the cockpit and close the canopy.
Image: An astronaut figure positioned in the cockpit of the space shuttle, with the satellite accessory visible nearby.
Operating Instructions
1. Rocket Launch Simulation (Lights, Sounds, and Water Mist)
- Ensure batteries are installed in the rocket.
- Locate the water reservoir on the side of the rocket.
- Using the provided water bottle, carefully fill the reservoir with clean water. Do not overfill.
- Locate the On/Off switch, typically on the back of the rocket pod or main body. Switch it to "On".
- Press the designated button (often on the rocket body) to activate realistic launch countdown sounds, flashing lights, and a simulated "smoke" mist effect from the rocket's base.
Image: A diagram showing how to use the small water bottle to fill the designated reservoir on the rocket, enabling the simulated launch mist effect.
Image: A detailed view of the water filling port on the rocket, with the water bottle tip inserted, demonstrating the process of adding water for the mist effect.
2. Space Shuttle Operation (Lights and Movement)
- Ensure batteries are installed in the space shuttle.
- Locate the On/Off switch on the space shuttle. Switch it to "On".
- The space shuttle is equipped with wheels on its underside, allowing it to be rolled across flat surfaces to simulate ground takeoffs and landings.
- Press the designated button (if present) to activate lights and sounds.
Image: The space shuttle with its lights activated, highlighting the illuminated thrusters and cockpit area.
3. Astronaut and Satellite Play
The astronaut figures are poseable and can be placed in the rocket, shuttle, or on the aircraft/rover. The satellite is a static accessory designed to enhance imaginative play scenarios.
Maintenance
1. Cleaning
Wipe all surfaces with a soft, dry cloth. For stubborn dirt, a slightly damp cloth can be used, followed by immediate drying. Do not immerse any electronic components in water.
Caution: Do not use harsh chemicals or abrasive cleaners, as these may damage the toy's finish.
2. Battery Care
- Remove batteries from the toy if it will not be used for an extended period to prevent leakage.
- Replace all batteries at the same time.
- Dispose of used batteries responsibly according to local regulations.
3. Water Reservoir
After using the rocket's mist feature, empty any remaining water from the reservoir. Allow the reservoir to air dry completely to prevent mold or mildew buildup.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| No lights or sounds |
|
|
| Rocket mist effect not working or leaking |
|
|
| Detachable parts do not stay connected |
|
|
Specifications
- Model Number: 80118
- Product Dimensions: 8.15 x 4.33 x 11.22 inches
- Item Weight: 1.69 pounds
- Manufacturer Recommended Age: 36 months - 12 years
- Manufacturer: CANXIN TOYS FACTORY (Brand: TOY Life)
Warranty Information
Specific warranty details for the TOY Life Space Adventure Set are not provided in the product information. Please refer to the retailer's return policy or contact TOY Life customer support for warranty inquiries.
Customer Support
For further assistance, questions, or concerns regarding your TOY Life Space Adventure Set, please contact TOY Life customer support through their official website or the retailer where the product was purchased.
You can visit the TOY Life Store on Amazon: TOY Life Store
Note: No official product videos were available in the provided product data for inclusion in this manual.