Instruction Manual

Introduction

Thank you for choosing the vidaXL Revera Convertible Corner Desk. This manual provides essential information for the safe assembly, operation, and maintenance of your new desk. Please read these instructions carefully before beginning assembly and retain them for future reference.

Safety Information

• Ensure all components are present and undamaged before assembly. Do not use damaged parts.
• Assemble the desk on a soft, clean surface to prevent scratches.
• Tighten all fasteners securely, but do not overtighten. Periodically check and retighten fasteners as needed.
• Keep small parts away from children during assembly to prevent choking hazards.
• Do not stand or sit on the desk.
• Place the desk on a level surface to ensure stability.

Setup and Assembly

The vidaXL Revera desk is designed for straightforward assembly. It can be configured in two primary ways: an L-shaped corner desk or a straight, extended desk. Follow the steps below for assembly.

Components Checklist

Please verify that all parts are included in your package. Refer to the assembly diagram for specific part identification.

• Main Desk Panel
• Shelving Unit Panels (various sizes)
• Support Legs/Panels
• Hardware Pack (screws, dowels, cam locks, etc.)

Assembly Instructions

1. Unpack and Identify: Carefully unpack all components and lay them out on a protected surface. Identify each part using the provided assembly diagram.
2. Assemble Shelving Unit: Begin by assembling the shelving unit according to the detailed instructions in the separate assembly guide (if provided). Ensure all shelves and vertical supports are securely fastened.
3. Attach Main Desk Panel: Connect the main desk panel to the shelving unit. The design allows for rotation to achieve either an L-shape or a straight configuration. Align the pre-drilled holes and secure with the provided hardware.
4. Install Support Legs: Attach any additional support legs or panels to the main desk section to ensure stability.
5. Final Tightening: Once all parts are assembled, gently tighten all screws and fasteners. Do not overtighten.

This image displays the vidaXL Revera Corner Desk configured in an L-shape, featuring integrated shelving on the left side and a spacious work surface on the right. The desk is shown in a room setting with a laptop, books, and decorative items.

This image shows the vidaXL Revera Desk in its straight configuration, where the shelving unit is aligned with the main desk surface, creating a longer, continuous workspace. This demonstrates the convertible nature of the desk.

Operating the Convertible Desk

The unique design of the Revera desk allows it to be easily converted between an L-shaped corner desk and a straight, extended desk to suit your space and needs.

Converting the Desk Configuration

1. Clear the Desk: Remove all items from both the main desk surface and the shelving unit to prevent damage or injury during conversion.
2. Loosen Connecting Hardware (if applicable): Depending on the specific assembly, there may be specific fasteners that need to be slightly loosened to allow rotation. Refer to your assembly guide for details.
3. Rotate the Main Desk: Carefully rotate the main desk panel relative to the shelving unit. The design allows for a smooth pivot. Ensure the desk is lifted slightly to avoid scratching the floor.
4. Secure in New Position: Once the desired configuration (L-shape or straight) is achieved, ensure the desk is stable and re-tighten any connecting hardware.
5. Verify Stability: Before placing items back, gently test the stability of the desk in its new configuration.

Another view of the vidaXL Revera Corner Desk in its L-shaped setup, highlighting the connection between the shelving unit and the main desk surface. The desk is presented in a light grey Sonoma finish.

Maintenance

Proper care will extend the life and appearance of your vidaXL Revera desk.

Cleaning Instructions

• Wipe surfaces with a soft, damp cloth.
• Avoid using harsh chemicals, abrasive cleaners, or polishes that may damage the engineered wood finish.
• Immediately wipe up spills to prevent moisture damage.

General Care

• Keep the desk away from direct sunlight and heat sources to prevent fading or warping.
• Use coasters or mats under hot items or beverages to protect the surface.
• Periodically check all screws and fasteners and tighten them if they have become loose.

Troubleshooting

If you encounter any issues with your desk, refer to the following common problems and solutions.

Stability Issues

• Problem: Desk wobbles or feels unstable.
  • Solution: Ensure the desk is placed on a level surface. Check and tighten all assembly screws and fasteners. If adjustable feet are present, adjust them to compensate for uneven floors.

Assembly Difficulties

• Problem: Parts do not fit together or holes do not align.
  • Solution: Double-check the assembly diagram to ensure you are using the correct parts and orientation for each step. Do not force parts together. Disassemble and re-attempt the step carefully.

Specifications

This diagram illustrates the key dimensions of the vidaXL Revera Corner Desk. It shows a total length of 200 cm (78.7 inches), a depth of 50 cm (19.7 inches), and a height of 76 cm (29.9 inches). The shelving unit measures 100 cm (39.4 inches) in length.

Warranty and Support

For information regarding warranty coverage, please refer to the warranty documentation provided with your purchase or visit the official vidaXL website. If you require assistance with assembly, parts, or have any questions not covered in this manual, please contact vidaXL customer support.

Customer Support: Please refer to your purchase receipt or the vidaXL website for the most current contact information for customer service in your region.