1. Important Safety Information
Before operating your TODIMART G2 Electric Scooter, please read and understand all safety instructions. Failure to follow these instructions may result in serious injury or property damage.
- Always wear a helmet and appropriate protective gear (knee pads, elbow pads) when riding.
- Ensure all screws and quick-release mechanisms are securely fastened before each ride.
- Check brake functionality before each use.
- Adhere to local traffic laws and regulations regarding electric scooter usage.
- Do not ride in heavy rain, on icy surfaces, or through deep puddles.
- Avoid riding under the influence of alcohol or drugs.
- Maintain a safe distance from other vehicles and pedestrians.
- The maximum load capacity is 130 kg. Do not exceed this limit.
- This scooter is designed for adult use.
Image 1.1: TODIMART G2 Electric Scooter in its operational and folded states.
2. Package Contents
Verify that all items are present in the package:
- TODIMART G2 Electric Scooter
- Battery Charger
- Instruction Manual
- Installation Tools
3. Setup and Assembly
The TODIMART G2 Electric Scooter comes largely pre-assembled. Follow these steps for initial setup:
- Unfolding the Scooter: Carefully lift the handlebar stem until it locks into the upright position. Ensure the folding mechanism is securely latched.
- Handlebar Adjustment: Adjust the handlebar height to a comfortable position and secure it using the quick-release clamp.
- Initial Charge: Before first use, fully charge the scooter's battery. Connect the charger to the charging port and then to a power outlet. The charging indicator on the charger will change when fully charged (typically 5-6 hours).
- Tire Check: Inspect the 10-inch all-terrain tires for proper inflation. Refer to the tire sidewall for recommended pressure.
Image 3.1: The scooter can be folded for transport and storage. Folded dimensions are approximately 120cm x 62cm x 55cm.
4. Operating Instructions
4.1 Powering On/Off
Press and hold the power button on the handlebar display to turn the scooter on or off.
4.2 Display and Controls
The LCD display provides essential information:
- Battery Level: Indicates remaining battery charge.
- Speed: Current riding speed.
- Odometer: Total distance traveled.
- Gear/Speed Mode: Shows the selected speed mode (e.g., 1, 2, 3).
Use the control buttons near the display to:
- Switch between speed modes.
- Activate/deactivate lights.
- Engage turn signals.
Image 4.1: Multifunctional LCD display and handlebar controls.
4.3 Riding the Scooter
- Starting: The scooter supports two start modes:
- Zero-start: Accelerate directly from a standstill.
- Non-zero start: Push off with your foot to gain initial momentum before engaging the throttle.
- Acceleration: Gently press the throttle lever to accelerate. Increase pressure for higher speeds.
- Braking: Use the dual disc brakes for effective stopping. Apply both brakes simultaneously for optimal control and safety.
- Cruise Control: Activate cruise control for maintaining a constant speed on flat terrain. Refer to the specific button on your handlebar for activation.
Image 4.2: Riding the TODIMART G2 Electric Scooter. Always observe weather conditions and road safety.
Image 4.3: The 10-inch all-terrain tires and dual suspension system provide a stable ride.
5. Maintenance
Regular maintenance ensures the longevity and safe operation of your scooter.
- Battery Care:
- Charge the battery fully after each use.
- Do not overcharge or completely drain the battery.
- Store the scooter in a cool, dry place if not used for extended periods, with the battery charged to approximately 50-70%.
- Tire Maintenance:
- Regularly check tire pressure and inflate to the recommended PSI.
- Inspect tires for wear, punctures, or damage.
- Brake System:
- Periodically check brake pads and discs for wear.
- Ensure brake levers operate smoothly and provide adequate stopping power.
- Cleaning:
- Clean the scooter with a damp cloth. Avoid using high-pressure water jets or harsh chemicals.
- Do not immerse any part of the scooter in water.
- General Inspection: Regularly check all bolts, nuts, and moving parts for tightness and proper function.
Image 5.1: The 48V 10.4Ah battery provides a range of 35-45km and charges in 5-6 hours.
6. Troubleshooting
This section addresses common issues you might encounter:
| Problem | Possible Cause | Solution |
|---|---|---|
| Scooter does not power on. | Low battery; loose connections; power button malfunction. | Charge the battery; check all visible connections; contact support if issue persists. |
| Motor not engaging or weak power. | Low battery; throttle issue; motor connection problem. | Ensure battery is charged; check throttle cable; contact support. |
| Brakes are not effective. | Worn brake pads; loose brake cable; disc damage. | Inspect and replace brake pads if necessary; adjust brake cable tension; contact support for disc issues. |
| Unusual noises during operation. | Loose components; foreign objects; motor issue. | Inspect scooter for loose parts; remove any obstructions; contact support if noise persists. |
For issues not listed here or if solutions do not resolve the problem, please contact TODIMART customer support.
7. Specifications
| Feature | Detail |
|---|---|
| Model | TODIMART G2-500W-48V-10.4AH |
| Motor Power | 500W (Peak 800W) Brushless Rear-Wheel Drive |
| Battery | 48V 10.4Ah |
| Max Range | 40-45 KM (depending on terrain, rider weight, and speed) |
| Max Load | 130 kg |
| Max Climbing Angle | 25° |
| Tires | 10-inch All-Terrain (Synthetic Rubber) |
| Brakes | Dual Disc Brakes (Front and Rear) |
| Suspension | Dual Front and Rear Shock Absorbers |
| Lighting | High-brightness Front Headlight, Side Lights, Left/Right Turn Signals, Rear Brake Light |
| Display | LCD Multifunctional Display |
| Special Features | Foldable design (3 seconds), USB Charging Port, Cruise Control |
| Unfolded Dimensions (L x W x H) | 116 x 62 x 120 cm |
| Folded Dimensions (Approx.) | 120 x 62 x 55 cm |
| Net Weight | 21 kg |
| Frame Material | Aluminum |
Image 7.1: Overview of the 500W motor and key performance specifications.
8. Warranty and Support
TODIMART is committed to providing high-quality products and excellent customer service. Your TODIMART G2 Electric Scooter comes with a manufacturer's warranty. Please refer to the warranty card included in your package for specific terms and conditions.
For any questions, technical assistance, or warranty claims, please contact TODIMART customer support. Our dedicated team is available to assist you.
Contact information can typically be found on the product packaging, the official TODIMART website, or through your purchase platform.
