1. Introduction
The KRUX Edis 1000 is a USB condenser microphone kit designed for high-quality audio capture. It features a cardioid polar pattern, an adjustable arm for flexible positioning, and a pop filter to reduce plosive sounds. This manual provides detailed instructions for setting up, operating, and maintaining your microphone.
1.1 Package Contents
Please verify that all the following components are included in your package:
- KRUX Edis 1000 USB Condenser Microphone
- Adjustable Microphone Arm (Desk Clamp Type)
- Shock Mount
- Pop Filter
- Foam Windscreen
- USB Type-B to USB Type-A Cable
Figure 1: All included components of the KRUX Edis 1000 microphone kit.
2. Setup Guide
2.1 Mounting the Adjustable Arm
- Attach the desk clamp to a sturdy surface, such as a desk or table edge. Tighten the screw until the clamp is secure.
- Insert the base of the adjustable microphone arm into the hole on the desk clamp. Tighten the locking knob on the clamp to secure the arm.
- Adjust the arm to your desired height and position. Ensure all joints are tightened to prevent movement during use.
Figure 2: KRUX Edis 1000 microphone fully assembled on its adjustable arm.
2.2 Attaching the Microphone and Pop Filter
- Screw the shock mount onto the threaded end of the adjustable arm.
- Gently place the KRUX Edis 1000 microphone into the shock mount. The microphone should be securely held by the elastic bands of the shock mount.
- Attach the pop filter to the adjustable arm using its clamp. Position the pop filter approximately 2-3 inches (5-7 cm) in front of the microphone.
- Optionally, place the foam windscreen over the microphone for additional wind and plosive noise reduction.
2.3 Connecting to Your Device
- Connect the USB Type-B end of the provided cable to the port at the bottom of the microphone.
- Connect the USB Type-A end of the cable to an available USB port on your computer, game console, or smartphone (an adapter may be required for some smartphones, not included).
- The microphone is Plug & Play compatible. Your operating system should automatically detect and install the necessary drivers.
- Verify the microphone is selected as the input device in your system's sound settings or your recording/streaming software.
3. Operating Instructions
3.1 Basic Usage
- Positioning: For optimal sound quality, speak directly into the front of the microphone (the side with the KRUX logo) at a distance of 6-12 inches (15-30 cm).
- Gain Control: The KRUX Edis 1000 does not feature a physical gain knob. Adjust input levels through your computer's sound settings or your recording software.
- Monitoring: Use your computer's audio output to monitor your sound. The microphone does not have a direct headphone jack.
Figure 3: Close-up of the KRUX Edis 1000 microphone.
3.2 Optimizing Audio Quality
- Environment: Record in a quiet environment to minimize background noise.
- Pop Filter: Always use the pop filter to prevent harsh 'P' and 'B' sounds (plosives) from distorting your audio.
- Shock Mount: The shock mount helps isolate the microphone from vibrations and handling noise from the desk or arm.
- Software Settings: Utilize noise reduction, equalization, and compression features available in your recording or streaming software to further enhance sound quality.
4. Care and Maintenance
- Cleaning: Use a soft, dry cloth to clean the microphone body and arm. Do not use liquid cleaners or solvents.
- Storage: When not in use, store the microphone in a clean, dry place away from extreme temperatures and humidity.
- Handling: Avoid dropping or subjecting the microphone to strong impacts, as this can damage internal components.
- Cable Care: Do not bend or crimp the USB cable excessively. Always grasp the connector, not the cable, when plugging or unplugging.
5. Troubleshooting
| Problem | Possible Solution |
|---|---|
| Microphone not detected by computer. |
|
| Low or no audio output. |
|
| Audio sounds distorted or crackling. |
|
| Excessive 'P' and 'B' sounds (plosives). |
|
6. Technical Specifications
| Feature | Specification |
|---|---|
| Model Name | EDIS 1000 |
| Model Number | KRX0109 |
| Brand | KRUX |
| Microphone Type | Condenser |
| Polar Pattern | Unidirectional (Cardioid) |
| Connectivity Technology | USB |
| Connector Type | USB Type-B |
| Compatible Devices | Game Console, Personal Computer, Smartphone |
| Audio Sensitivity | 130 Decibels |
| Signal-to-Noise Ratio | 78 dB |
| Number of Channels | 1 |
| Power Source | USB Cable (Bus-powered) |
| Material | Metal |
| Color | Black |
| Item Weight (Microphone) | 215 Grams |
| Item Dimensions (Microphone L x W x H) | 15 x 4.6 x 4.6 centimeters |
| Special Features | Adjustable Arm, Plug & Play |
| Recommended Uses | Streaming |
7. Warranty and Support
For warranty information and technical support, please refer to the official KRUX website or contact your retailer. Keep your proof of purchase for any warranty claims.
Manufacturer: KRUX
Website: www.krux.tech (Example link, please verify official KRUX support website)
