1. Introduction
Thank you for choosing the HOROW HR-T10SD Heated Smart Toilet. This compact, one-piece toilet is designed to provide enhanced comfort and convenience with features such as a heated seat, foot-activated flushing, and a blackout flush system. This manual provides essential information for the proper installation, operation, and maintenance of your new smart toilet.
Image 1.1: The HOROW HR-T10SD Heated Smart Toilet.
2. Safety Information
- Read all instructions carefully before installation and use.
- Ensure the power supply is disconnected before performing any maintenance or installation.
- This product operates on 110 Volts and 50 watts. Ensure your electrical system meets these requirements.
- Do not attempt to repair or modify the toilet yourself. Contact qualified service personnel for assistance.
- Keep children away from the toilet during operation and maintenance.
3. Setup and Installation
The HOROW HR-T10SD is a floor-mounted, one-piece toilet designed for straightforward installation. A rough-in of 12 inches is required. Professional installation is recommended to ensure proper function and compliance with local plumbing codes.
3.1 Pre-Installation Checklist
- Verify all components are present and undamaged.
- Ensure the water supply valve is turned off.
- Confirm the rough-in measurement is 12 inches from the wall to the center of the drain pipe.
- Have necessary tools ready (e.g., wrench, screwdriver, sealant).
3.2 Installation Steps (Overview)
- Position the toilet over the flange, ensuring proper alignment.
- Secure the toilet to the floor using the provided hardware.
- Connect the water supply line to the toilet's inlet.
- Connect the power cord to a grounded electrical outlet.
- Turn on the water supply and check for leaks.
- Test all functions of the toilet.
Image 3.1: Product dimensions and 12-inch rough-in requirement.
Image 3.2: The HR-T10SD toilet installed in a modern bathroom setting.
4. Operating Instructions
Your HOROW HR-T10SD smart toilet offers several advanced features for comfort and convenience.
Image 4.1: Overview of key features including heated seat, blackout flush, and foot flush.
4.1 Heated Seat
The toilet features a heated seat for comfort, especially in colder environments. The seat temperature can be adjusted using the thermostat knob located on the side of the toilet. Turn the knob to your desired warmth setting.
Image 4.2: The heated seat feature provides warmth for user comfort.
4.2 Foot-Activated Flushing
To activate the flush without using your hands, simply use the foot induction method. A sensor located near the base of the toilet detects foot movement to initiate a powerful tornado flush. Note that the sensor may not detect feet if covered by dark socks or shoes.
Image 4.3: Illustration of the foot-activated flush sensor.
4.3 Blackout Flush System
In the event of a power outage, the toilet's built-in powerful battery ensures continued functionality. This system allows for approximately 2000 flushes without external power, providing reliability during unexpected electrical interruptions.
Image 4.4: The blackout flush system ensures operation during power outages.
4.4 Soft-Close Cover
The toilet is equipped with a soft-close seat and cover mechanism, preventing sudden drops and reducing noise and potential damage.
Image 4.5: The soft-close feature ensures quiet and gentle closing of the seat and lid.
5. Maintenance
Regular maintenance ensures the longevity and optimal performance of your HOROW HR-T10SD smart toilet.
5.1 Cleaning
- Use mild, non-abrasive cleaners and a soft cloth to clean the ceramic and glazed surfaces.
- Avoid harsh chemicals, abrasive pads, or strong acids, as these can damage the finish.
- Wipe down the exterior regularly to prevent buildup.
5.2 Water Filter Maintenance
If you experience reduced flush volume, check the debris filter located within the elbow connection of the water inlet. Over time, sediment or iron particles from the water supply can accumulate and restrict water flow. Turn off the water supply, remove and clean the filter, then reassemble and test.
6. Troubleshooting
This section addresses common issues you might encounter with your smart toilet.
| Problem | Possible Cause | Solution |
|---|---|---|
| Toilet clogs frequently. | Insufficient water flow or pressure; excessive toilet paper usage. | Ensure adequate water pressure. Avoid flushing large amounts of toilet paper. If issues persist, consult a licensed plumber to verify water flow and pressure. |
| Low flush volume. | Debris filter in water inlet is clogged. | Turn off water supply, locate and clean the debris filter in the elbow connection of the water inlet. |
| Heated seat not working. | Power issue; internal component failure. | Check power connection. If power is confirmed, contact customer service for assistance. |
| Foot flush sensor unresponsive. | Obstruction; dark footwear interfering with sensor. | Ensure no objects are blocking the sensor. Note that dark-colored socks or shoes may sometimes interfere with sensor detection. |
7. Specifications
| Feature | Detail |
|---|---|
| Model Number | HR-T10SD |
| Color | White |
| Product Dimensions (L x W x H) | 25.59"D x 15.59"W x 19.8"H |
| Material | Ceramic |
| Installation Type | Floor Mounted |
| Shape | Oval |
| Seat Material Type | Polypropylene |
| Item Weight | 90 pounds |
| Voltage | 110 Volts |
| Wattage | 50 watts |
| Water Consumption | 1.27 Gallons per Flush |
| Flush Type | Electronic |
| Rough-In | 12 Inches |
| Special Features | Heated Seats, Soft Close |
| Usage | Commercial/Residential |
8. Warranty and Support
HOROW is committed to providing quality products and excellent customer service.
8.1 Warranty Information
This product includes a 12-Month Replacement Warranty. Please retain your proof of purchase for warranty claims.
8.2 Return Policy
A 30-Day Money Back Guarantee is offered for this product. Refer to your purchase platform for specific return procedures.
8.3 Customer Support
For any issues, questions, or technical assistance, please contact HOROW customer support. Our professional technical and service teams are available to provide lifetime troubleshooting guidance.
- Contact Method: Refer to the contact information provided with your purchase or visit the official HOROW website.
- When contacting support, please provide: Your model number (HR-T10SD), date of purchase, and a detailed description of the issue.
