Introduction
This manual provides essential instructions for the safe and effective use of your Nerf Elite 2.0 Phoenix CS-10 Motorized Blaster. Please read all instructions carefully before assembly and operation. Retain this manual for future reference.
Recommended Age: Ages 8+
Warning: Do not aim at eyes or face. Use only official Nerf darts. Other darts may not meet safety standards. Do not modify darts or blaster.
Package Contents
Your Nerf Elite 2.0 Phoenix CS-10 package should include the following items:
- Nerf Elite 2.0 Phoenix CS-10 Blaster
- Removable Stock
- Removable Barrel Extension
- 10-Dart Clip
- 20 Official Nerf Elite Darts
- Instruction Manual (this document)
Image: The Nerf Elite 2.0 Phoenix CS-10 Blaster shown in its retail packaging, highlighting the main blaster unit, removable stock, removable barrel, and the 10-dart clip.
Setup
- Install Batteries: The Nerf Elite 2.0 Phoenix CS-10 requires 4 AA batteries (not included). Locate the battery compartment, usually on the side or bottom of the blaster. Use a screwdriver to open the compartment, insert the batteries according to the polarity indicators (+/-), and securely close the compartment.
- Attach Stock: Align the removable stock with the attachment point at the rear of the blaster. Push firmly until it clicks into place.
- Attach Barrel Extension: Align the removable barrel extension with the front of the blaster. Twist or push until it is securely attached.
- Load Darts into Clip: Insert the 20 official Nerf Elite darts into the 10-dart clip. Ensure darts are fully seated.
- Insert Clip: Insert the loaded 10-dart clip into the blaster's magazine well until it locks into place.
Operating Instructions
The Nerf Elite 2.0 Phoenix CS-10 features motorized blasting for rapid-fire action.
- Rev the Motor: Press and hold the acceleration button (typically located below the main trigger) to rev up the blaster's motor. You will hear the motor spinning.
- Fire Darts: While holding the acceleration button, pull the main trigger to fire individual darts. Release the acceleration button to stop the motor.
- Range: The blaster can shoot foam darts up to 90 feet (27 meters).
Maintenance
- Cleaning: Wipe the blaster with a dry or slightly damp cloth. Do not immerse in water.
- Dart Care: Use only clean, undamaged official Nerf Elite darts. Damaged darts can cause jams or affect performance.
- Battery Replacement: Replace batteries when the blaster's motor sounds weak or darts do not fire with full power. Always replace all 4 AA batteries at the same time.
- Storage: Store the blaster and darts in a cool, dry place away from direct sunlight. Remove batteries if storing for extended periods.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Blaster does not fire or motor does not rev. |
|
|
| Darts fire weakly or inaccurately. |
|
|
Specifications
- Model: Nerf Elite 2.0 Phoenix CS-10
- Brand: Nerf (by Hasbro)
- Power Source: 4 AA Batteries (not included)
- Dart Capacity: 10 darts per clip (20 darts included)
- Maximum Range: Up to 90 feet (27 meters)
- Item Weight: Approximately 2.2 pounds
- Package Dimensions: Approximately 28.6 x 12.5 x 4 inches
- Recommended Age: 8+ years
Warranty and Support
For warranty information, product support, or to purchase additional darts and accessories, please visit the official Nerf website or contact Hasbro customer service.
Official Nerf Website: Visit the Nerf Store on Amazon
Please refer to the product packaging for specific warranty details and contact information for your region.
