Metra 107-CH5 DDIN Radio Provision Installation Manual

Introduction

This manual provides detailed instructions for the installation of the Metra 107-CH5 DDIN radio provision kit. This kit is designed to facilitate the installation of an aftermarket ISO DDIN radio into specific 1996-1998 Jeep Grand Cherokee vehicles. The kit components are textured to match the factory finish of your vehicle's dashboard.

Kit Components

Please verify that all components listed below are present in your kit before beginning installation:

• DDIN Radio Provision Bezel
• Left Mounting Bracket
• Right Mounting Bracket
• Hardware (screws, clips, etc. - specific types may vary)

Image 1: Overview of the Metra 107-CH5 DDIN radio provision kit, showing the main bezel and mounting brackets.

Image 2: Front view of the DDIN radio provision bezel, which integrates with the vehicle's dashboard.

Image 3: The left and right mounting brackets used to secure the aftermarket radio within the provision kit.

Setup and Installation Guide

Important: Professional installation is recommended. Disconnect the vehicle's battery before beginning any electrical work. Ensure your aftermarket radio is compatible with an ISO DDIN L-shaped chassis design, with the radio chassis positioned at the top of the screen.

1. Vehicle Disassembly

1. Carefully remove the factory radio and any surrounding trim panels from the dashboard. Refer to your vehicle's service manual for specific instructions on dash disassembly.
2. Disconnect all wiring harnesses and antenna cables from the factory radio.

2. Kit Assembly and Radio Preparation

1. Attach the left and right mounting brackets to your aftermarket ISO DDIN radio. Ensure the radio's chassis is oriented correctly (L-shaped, with the chassis at the top).
2. Slide the assembled radio and brackets into the Metra 107-CH5 DDIN radio provision bezel. Secure the radio to the bezel using the provided hardware.
3. Perform all necessary wiring connections for your aftermarket radio, including power, ground, speaker wires, and antenna. Test connections before final installation.

3. Final Installation

1. Carefully guide the assembled radio and Metra bezel into the dashboard opening.
2. Secure the Metra bezel to the vehicle's dashboard using the factory mounting points or provided hardware. Ensure a snug and flush fit.
3. Reassemble any removed trim panels.
4. Reconnect the vehicle's battery and test the functionality of the new radio.

Image 4: Example of the Metra 107-CH5 kit installed in a 1996-1998 Jeep Grand Cherokee dashboard with an aftermarket radio.

Operating Instructions

This Metra 107-CH5 kit is an installation accessory and does not have operational functions. Please refer to the instruction manual provided with your aftermarket radio for operating instructions.

Maintenance

The Metra 107-CH5 kit requires no specific maintenance. To clean the surface, use a soft, damp cloth. Avoid abrasive cleaners or solvents.

Troubleshooting

• Radio Does Not Fit Flush: Ensure your aftermarket radio is an ISO DDIN unit with an L-shaped chassis design, where the chassis is located at the top. Some double DIN radios may have different chassis configurations that are not compatible with this specific kit without modification. Verify that all mounting brackets are correctly aligned and secured.
• Dash Trim Gap: Double-check that the Metra bezel is fully seated and all clips or screws are engaged. Minor adjustments to the vehicle's dash opening may be required in some cases, but proceed with caution to avoid damage.
• Loose Fit: Ensure all screws securing the radio to the brackets and the brackets to the bezel are tightened. Verify that the bezel is securely fastened to the vehicle's dashboard.

Specifications

Warranty and Support

Specific warranty information for the Metra 107-CH5 kit is not provided in this manual. Please refer to the product packaging or contact Metra customer support for details regarding warranty coverage and technical assistance.