LeCuag Ionic Foot Bath Detox Machine Model 22 User Manual

Introduction

Thank you for choosing the LeCuag Ionic Foot Bath Detox Machine. This device is designed to provide a foot spa experience in the comfort of your home. This manual provides essential information for the safe and effective use, setup, operation, and maintenance of your new ionic foot bath machine.

Safety Information

• Do not immerse the control unit in water.
• Avoid using the device near standing water.
• Always unplug the device when not in use.
• Statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition.
• Pregnant women and children are prohibited from using this device.

Package Contents

Please verify that all items listed below are included in your package:

• 1 x Mini Detox Machine (Control Unit)
• 1 x Foot Tub
• 1 x Power Adapter
• 2 x Ion Arrays
• 100 x Spa Liners
• 1 x Portable Storage Bag
• 1 x User Manual (this document)

Setup Instructions

1. Place the foot tub on a stable, flat surface.
2. Insert a spa liner into the foot tub.
3. Securely attach the control unit to the designated slot on the foot tub.
4. Place one ion array into the foot tub, ensuring it is fully submerged in water later.
5. Connect the ion array cable to the control unit.
6. Fill the foot tub with warm water up to a comfortable level, ensuring the ion array is covered.
7. Add a small amount of salt to the water (approximately 1/4 to 1/2 teaspoon) to enhance conductivity. Adjust as needed if the array does not produce sufficient bubbles during operation.
8. Connect the power adapter to the control unit and then plug it into a power outlet.

Operating Instructions

1. After setup, press the power button on the control unit to turn on the machine.
2. The machine has a pre-programmed setting for 30 minutes.
3. Submerge your feet into the water.
4. The machine will automatically shut off after 30 minutes.
5. It is advised to use the detox foot bath twice a week. For long-term use, consider 4 times/week for 6-12 months.

Understanding Water Color Changes

The water in the foot bath will change color during operation. This is a result of the reaction between the positive and negative ions released by the machine and the minerals or salts present in the water. Even without feet submerged, the water will change color due to these reactions. The color will darken further when your feet are immersed.

Maintenance

Proper maintenance ensures the longevity and effectiveness of your ion arrays.

1. After each use, remove the ion array from the foot tub.
2. Simply spray the array with water and use a brush to clean any residue.
3. For deeper cleaning and maintenance, soak the ion array in vinegar.
4. With proper cleaning, each ion array can be used approximately 40 to 50 times.

Troubleshooting

• Water changes color without feet: This is normal. The water changes color due to the reaction between the ions and minerals/salts already present in the water. The color will intensify with feet submerged.
• Ion array doesn't create enough bubbles: If the array is not producing sufficient bubbles, try adding a bit more salt to the water to increase conductivity. If the issue persists, the array may be worn out and needs to be replaced with a new one.

Specifications

Warranty and Support

For any questions, concerns, or support regarding your LeCuag Ionic Foot Bath Detox Machine, please refer to the contact information provided with your purchase or visit the official LeCuag website. Specific warranty details may vary; please retain your proof of purchase for warranty claims.