Product Overview
The Moen Lindor 84505 is a chrome-finished, single-handle, 4-inch centerset bathroom sink faucet designed for efficient water usage and modern aesthetics. It includes a drain and deck plate for a complete installation.
Image: The Moen Lindor 84505 single-handle bathroom faucet in chrome finish.
Setup and Installation
This section provides general guidance for installing your Moen Lindor 84505 faucet. For detailed, step-by-step instructions, always refer to the manufacturer's official installation guide included with your product. Professional installation is recommended if you are unfamiliar with plumbing procedures.
Before You Begin
- Ensure all necessary components are present: faucet body, handle, drain assembly, deck plate, and mounting hardware.
- Gather required tools: adjustable wrench, plumber's putty or silicone sealant, screwdriver, safety glasses.
- Turn off the main water supply to the sink area.
- Clear the workspace under the sink.
Installation Steps (General)
- Prepare the Sink: Clean the faucet mounting area on the sink. If using the deck plate, apply a bead of plumber's putty or silicone sealant to the underside of the deck plate to create a watertight seal.
- Install the Faucet: Insert the faucet body through the single hole in the sink or deck plate. From underneath the sink, secure the faucet using the provided washer and mounting nut. Tighten firmly but do not overtighten.
- Connect Water Supply Lines: Attach the hot and cold water supply lines to the corresponding inlets on the faucet. Connect the other ends to your home's water supply valves. Ensure all connections are hand-tight, then use an adjustable wrench for a final quarter-turn.
- Install the Drain Assembly: The faucet includes a pop-up drain. Install the drain body into the sink drain hole, applying plumber's putty or silicone sealant around the flange for a watertight seal. Secure the drain body from underneath the sink with the provided gasket and nut. Connect the tailpiece to the P-trap.
- Test for Leaks: Once all connections are made, slowly turn on the main water supply. Check all connections for leaks. Run water through the faucet for a few minutes to flush out any debris.
Note: Proper installation of the drain assembly is crucial for preventing leaks. If you encounter difficulties, consult online resources or a professional plumber.
Image: The Moen Lindor 84505 faucet installed on a bathroom sink with a deck plate.
Operating Instructions
The Moen Lindor 84505 faucet features a single-handle design for easy control of water flow and temperature.
Water Flow and Temperature Control
- To Turn On/Off: Lift the single handle upwards to turn on the water. Push the handle downwards to turn off the water.
- To Adjust Temperature: Move the handle to the left for hotter water and to the right for colder water.
- To Adjust Flow: The further the handle is lifted, the greater the water flow.
Pop-Up Drain Operation
This faucet includes a push-down pop-up drain for convenient basin filling and draining.
- To Close the Drain: Press down firmly on the top of the drain stopper in the sink basin.
- To Open the Drain: Press down again on the top of the drain stopper. It will pop up, allowing water to drain.
The aerated flow is designed for everyday bathroom tasks, such as brushing teeth and washing hands, while meeting WaterSense criteria for water conservation.
Maintenance and Care
Proper care and maintenance will ensure the longevity and appearance of your Moen Lindor faucet.
Cleaning the Faucet
- Clean the chrome finish regularly with a soft, damp cloth.
- Use mild soap and water if necessary.
- Avoid abrasive cleaners, harsh chemicals, ammonia-based products, or scouring pads, as these can damage the finish.
- Rinse thoroughly after cleaning and dry with a soft cloth to prevent water spots.
Aerator Maintenance
If water flow decreases or becomes erratic, the aerator may be clogged with mineral deposits or debris.
- Unscrew the aerator from the tip of the faucet spout.
- Separate the components of the aerator.
- Rinse all parts under running water to remove debris. For stubborn mineral deposits, soak the parts in a solution of equal parts white vinegar and water.
- Reassemble the aerator and screw it back onto the faucet spout.
Troubleshooting
This section addresses common issues you might encounter with your Moen Lindor 84505 faucet.
| Problem | Possible Cause | Solution |
|---|---|---|
| Low Water Flow | Clogged aerator; partially closed shut-off valves; debris in supply lines. | Clean the aerator (see Maintenance); ensure shut-off valves are fully open; flush supply lines. |
| Faucet Leaks from Spout | Worn cartridge; debris in cartridge. | Replace the cartridge (consult Moen support); flush the system. |
| Leaks at Base of Faucet | Loose mounting nut; improper seal. | Tighten mounting nut; reapply plumber's putty or silicone sealant. |
| Drain Does Not Seal Properly | Improper drain installation; debris in drain. | Reinstall drain assembly ensuring proper sealant and tightening; clear any debris from the drain stopper. |
If these troubleshooting steps do not resolve the issue, please contact Moen customer support or a qualified plumber.
Specifications
Key technical specifications for the Moen Lindor 84505 Bathroom Sink Faucet:
- Model Number: 84505
- Brand: Moen
- Finish: Chrome
- Number of Handles: 1
- Mounting Type: Deck Mount
- Installation Type: Centerset
- Hole Count: 1
- Special Feature: Pop Up Drain
- Material: Plastic (for handle, other components may vary)
- Spout Reach: 4.8 Inches
- Item Weight: 2.24 Pounds
- Product Dimensions: 3"D x 9.5"W x 20"H (packaging dimensions may vary)
- WaterSense Certified: Yes, meets EPA WaterSense criteria for water conservation.
- ADA Compliant: Yes, complies with Americans with Disabilities Act (ADA) specifications.
Warranty Information
The Moen Lindor 84505 faucet comes with a manufacturer's warranty. For specific details regarding coverage, duration, and terms, please refer to the warranty documentation included with your product or visit the official Moen website. Retain your proof of purchase for warranty claims.
Customer Support
For further assistance, technical support, or to order replacement parts, please contact Moen customer service directly. You can typically find their contact information (phone number, email, or support portal) on the Moen official website or in the product packaging.
Moen Official Website: www.moen.com
