ICO Bath V6301 Volkano Summit Wall Mounted Euro Toilet Paper Holder

Introduction

Thank you for choosing the ICO Bath V6301 Volkano Summit Wall Mounted Euro Toilet Paper Holder. This manual provides essential information for the safe installation, operation, and maintenance of your new product. Please read these instructions thoroughly before beginning installation and retain them for future reference.

Safety Information

• Always wear appropriate safety gear, such as safety glasses, during installation.
• Ensure the mounting surface is structurally sound and can support the weight of the holder and its contents.
• Use caution when using power tools to avoid injury.
• Keep small parts away from children to prevent choking hazards.

Package Contents

Verify that all components are present before beginning installation:

• Toilet Paper Holder Assembly
• Mounting Bracket
• Mounting Screws
• Wall Anchors (if applicable)
• Hex Wrench (if applicable)

Tools Required

The following tools are typically required for installation:

• Pencil
• Measuring Tape
• Drill
• Drill Bit (appropriate size for anchors/screws)
• Phillips Head Screwdriver
• Level

Setup and Installation

Follow these steps to properly install your wall-mounted toilet paper holder:

1. Choose Location: Select a suitable location on the wall, ensuring it is at a comfortable height and accessible. Use a level to ensure the placement is straight.
2. Mark Drilling Points: Hold the mounting bracket against the wall at the desired location. Use a pencil to mark the positions for the screw holes.
3. Drill Pilot Holes: Using an appropriate drill bit, drill pilot holes at the marked locations. If installing into drywall, insert wall anchors into the pilot holes until flush with the wall surface.
4. Attach Mounting Bracket: Align the mounting bracket with the drilled holes. Insert the mounting screws through the bracket and into the wall anchors or directly into studs. Tighten the screws securely with a Phillips head screwdriver. Do not overtighten.
5. Attach Toilet Paper Holder: Position the toilet paper holder assembly over the mounting bracket. It typically slides onto the bracket and is secured with a small set screw located on the underside of the holder. Use the provided hex wrench to tighten this set screw until the holder is firm and does not wobble.

Operating Instructions

Using your Euro-style toilet paper holder is straightforward:

• Loading Toilet Paper: Simply slide a new roll of toilet paper onto the open arm of the holder. The design allows for easy replacement without a spring-loaded spindle.
• Dispensing: Pull the toilet paper from the roll as needed.

Maintenance

To maintain the finish and functionality of your toilet paper holder:

• Cleaning: Clean regularly with a soft, damp cloth. For stubborn spots, use a mild soap solution and rinse thoroughly.
• Avoid Harsh Cleaners: Do not use abrasive cleaners, scouring pads, or chemical solvents, as these can damage the chrome finish.
• Check Tightness: Periodically check the set screw on the underside of the holder and the mounting screws to ensure they remain tight. Tighten if necessary to prevent wobbling.

Troubleshooting

If you encounter any issues, refer to the following common solutions:

• Holder is Loose/Wobbly: Ensure the set screw on the underside of the holder is tightened securely. Also, check the mounting screws that attach the bracket to the wall. If wall anchors were used, ensure they are properly seated and not stripped.
• Toilet Paper Roll Falls Off: Ensure the roll is fully seated on the arm. This model is designed for standard-sized toilet paper rolls.

Specifications

Warranty and Support

The ICO Bath V6301 Volkano Summit Wall Mounted Euro Toilet Paper Holder is covered under ICO Bath's limited residential warranty for parts and a 2-year commercial warranty. For specific warranty details or technical support, please refer to the official ICO Bath website or contact their customer service directly.