Introduction
This manual provides instructions for the ALLIMITY RC-911R replacement remote control. This remote is designed to function as a direct replacement for various Onkyo AV Receiver models, offering seamless control over your audio-visual system. Please read this manual carefully before use to ensure proper operation and to maximize your experience.
Setup
1. Battery Installation
The RC-911R remote control requires two (2) AAA alkaline batteries for operation. Follow these steps to install them:
- Locate the battery compartment cover on the back of the remote control.
- Slide the cover downwards or press the latch (if present) to open the compartment.
- Insert two new AAA alkaline batteries, ensuring the positive (+) and negative (-) terminals match the diagrams inside the compartment.
- Replace the battery compartment cover, sliding it back into place until it clicks securely.
Important: Always use new alkaline batteries for optimal performance. Do not mix old and new batteries, or different types of batteries.
Operating Instructions
General Usage
To operate your Onkyo AV Receiver with the RC-911R remote control, point the remote directly towards the infrared (IR) sensor on your receiver. Ensure there are no obstacles between the remote and the receiver's sensor that could block the signal.
Compatible Onkyo AV Receiver Models
The RC-911R remote control is compatible with the following Onkyo AV Receiver models:
- HT-R695
- HT-S7800
- TX-NR555
- TX-NR575
- TX-NR585
- TX-NR656
- TX-NR686
- TX-NR676
- TX-NR757
- TX-NR777
- TX-NR787
- TX-RZ610
- TX-RZ710
- TX-RZ720
- TX-RZ810
- TX-RZ820
- TX-NR575E
- TX-NR676E
If your specific model is not listed, please refer to the "Support" section for assistance.
Maintenance
Battery Replacement
When the remote control's performance degrades or it stops responding, it is likely time to replace the batteries. Follow the battery installation steps outlined in the "Setup" section. Always replace both batteries simultaneously with new AAA alkaline batteries.
Cleaning
To clean the remote control, gently wipe its surface with a soft, dry cloth. For stubborn dirt, slightly dampen the cloth with water or a mild, non-abrasive cleaner. Avoid using harsh chemicals, solvents, or abrasive materials, as these can damage the remote's finish or internal components.
Troubleshooting
- Remote not responding:
- Check if the batteries are installed correctly with the correct polarity.
- Replace the batteries with new AAA alkaline batteries.
- Ensure there are no obstructions between the remote control and the AV receiver's IR sensor.
- Make sure you are pointing the remote directly at the receiver's sensor.
- Specific functions not working:
- Verify that your Onkyo AV Receiver model is listed in the "Compatible Onkyo AV Receiver Models" section.
- Some advanced functions might require specific settings on your AV receiver. Refer to your receiver's original manual for details.
Specifications
| Feature | Detail |
|---|---|
| Model Number | RC-911R |
| Product Material | Plastic |
| Connective Technology | Infrared (IR) |
| Product Dimensions | 7 x 2 x 0.65 inches |
| Item Weight | 2.8 ounces |
| Batteries Required | 2 AAA batteries |
| Max Number of Supported Devices | 1 |
| Special Feature | Ergonomic design |
Support
If your specific Onkyo AV Receiver model number is not listed in this manual, or if you encounter any issues not covered in the troubleshooting section, please contact the seller for assistance. Providing your receiver's model number will help in identifying the correct solution or confirming compatibility.