Introduction
The Paladone PlayStation ONL5946PS Lava Lamp is a decorative lighting product featuring iconic PlayStation symbols. This lamp is designed to provide ambient lighting and a unique visual experience, making it a suitable accessory for any gaming room or bedroom.
Image: Paladone PlayStation Lava Lamp illuminated, showcasing blue liquid and floating PlayStation symbols.
Safety Information
Please read and understand all safety instructions before operating this product. Failure to follow these instructions may result in electric shock, fire, or serious injury.
- General Safety: Keep the lamp out of reach of children and pets. This product is not a toy.
- Heat Warning: The lamp and its contents become hot during operation. Do not touch the glass bottle or base while the lamp is on or immediately after turning it off. Allow sufficient time for cooling.
- Fragile Components: The glass bottle is fragile. Handle with care to prevent breakage.
- Electrical Safety: Use only with the provided power cord and a suitable power outlet. Ensure the voltage matches your region's standard. Some units may come with a UK plug; an appropriate, certified adapter is required for use in EU outlets. Unplug the lamp from the power source when not in use or before cleaning.
- Placement: Place the lamp on a stable, flat, and heat-resistant surface away from direct sunlight, extreme temperatures, or flammable materials. Do not place near heat sources or in areas with high humidity.
- Liquid Contents: Do not open the glass bottle or attempt to consume its contents. The liquid is not for ingestion and can cause irritation. In case of accidental contact, rinse thoroughly with water.
- Ventilation: Ensure adequate air circulation around the lamp. Do not cover the lamp while it is operating.
Package Contents
Verify that all components are present and in good condition upon unpacking:
- 1 x Lava Lamp Base
- 1 x Glass Bottle with Lava and PlayStation Symbols
- 1 x Top Cap
- 1 x Light Bulb (pre-installed in the base)
- 1 x Power Cord with In-line On/Off Switch
Setup
- Carefully unpack all components from the packaging.
- Place the lava lamp base on a stable, flat, and heat-resistant surface.
- Ensure the light bulb is securely screwed into the socket within the base.
- Gently place the glass bottle onto the base, ensuring it sits securely and is centered.
- Place the top cap onto the glass bottle.
- Connect the power cord to the lamp's base (if detachable) and then plug the power adapter into a suitable electrical outlet. If your lamp has a UK plug, use a certified adapter for your region.
Image: The lava lamp's power cord features an in-line on/off switch and measures 166 cm (65 inches) in length.
Operating Instructions
- Once assembled and plugged in, turn on the lamp using the in-line On/Off switch located on the power cord.
- For first-time use, allow 1 to 3 hours for the wax to heat up and begin flowing properly. The initial warm-up period may vary depending on room temperature.
- The lamp is designed for continuous operation for several hours. To prolong the life of the bulb and the lamp, avoid leaving it on for excessively long periods (e.g., over 8-10 hours).
- To turn off the lamp, use the On/Off switch. For extended periods of non-use, unplug the lamp from the wall outlet.
Image: Close-up of the lamp's interior, showing the PlayStation symbols flowing within the liquid.
Maintenance
- Cleaning: Always ensure the lamp is unplugged and completely cool before cleaning. Wipe the exterior surfaces (base, bottle, cap) with a soft, damp cloth. Do not use abrasive cleaners, solvents, or harsh chemicals, as these can damage the finish.
- Bulb Replacement: If the light bulb needs replacing, ensure the lamp is unplugged and cool. Carefully remove the glass bottle from the base. Unscrew the old bulb and replace it with a new bulb of the same type and wattage (E5 base, typically 25W or 30W). Refer to the specifications section for the exact bulb base type.
- Storage: When storing the lamp, ensure it is clean, dry, and cool. Store it upright in its original packaging or a safe place to prevent damage to the glass bottle.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Lava not flowing | Insufficient warm-up time; room too cold; incorrect bulb wattage. | Allow 1-3 hours for warm-up. Move lamp to a warmer room (above 20°C / 68°F). Ensure correct E5 bulb wattage is installed. |
| No light | Lamp unplugged; switch off; faulty bulb; power outlet issue. | Check power connection and switch position. Replace bulb if necessary. Test outlet with another device. |
| Cloudy liquid | Initial use; agitation during transport; overheating. | This often clears after several hours of operation. Ensure lamp is not in direct sunlight or excessively hot environments. If persistent, contact support. |
| Wax stuck at top or bottom | Lamp not level; improper heating/cooling. | Ensure lamp is on a perfectly level surface. Gently rock the lamp (while off and cool) to dislodge the wax. |
Specifications
- Model Number: ONL5946PS
- Brand: Paladone
- Product Dimensions (Approximate): Height: 39 cm (15.5 in), Base Width: 11 cm (4.5 in)
- Item Weight: 1.78 kg (3.92 lbs)
- Base Material: Plastic
- Shade Material: Plastic
- Bulb Base Type: E5
- Power Cord Length: 166 cm (65 in)
- Finish Type: Painted
- Style: PlayStation
Image: Dimensions of the Paladone PlayStation Lava Lamp.
Warranty and Support
Warranty: This product is sold without an explicit warranty as per the manufacturer's description.
Customer Support: For further assistance, inquiries, or to report any issues not covered in this manual, please visit the official Paladone website or contact their customer support department. Keep your purchase receipt for any potential service requests.
