Probrico Keypad Deadbolt Lock Instruction Manual

1. Introduction

This manual provides comprehensive instructions for the installation, operation, maintenance, and troubleshooting of your Probrico Keypad Deadbolt Lock. Please read this manual thoroughly before installation and use to ensure proper function and safety.

2. Safety Information

• Do not attempt to disassemble or modify the lock. This may cause damage and void the warranty.
• Use only specified battery types (4x AA batteries, not included).
• Keep the keypad clean and dry. Avoid using abrasive cleaners.
• Ensure the door frame and door are properly aligned and secure before installation.
• Do not expose the lock to extreme temperatures or direct water spray.

3. Package Contents

Verify that all components are present before beginning installation:

All components of the Probrico Keypad Deadbolt Lock, including the front keypad panel, interior battery unit, deadbolt latch, strike plate, and mounting hardware.

• Front Keypad Panel
• Rear Panel (Interior Unit)
• Lock Latch
• Rear Panel Locating Plate
• Striking Plate Box
• Keys (x2)
• Mounting Screws (various sizes)

4. Setup and Installation

4.1. Pre-Installation Check

Before installation, ensure your door is prepared for a deadbolt lock. The door thickness should be between 1.3" and 2" (33mm-52mm).

Diagram illustrating the compatible door thickness and backset for installation.

4.2. Battery Installation

The lock requires 4 AA batteries (not included). Install them into the interior unit before final assembly.

The interior unit of the lock showing the battery compartment. Note the low battery power alarm indicator.

4.3. Installation Steps

Follow these steps for physical installation:

1. Install the deadbolt latch into the door edge. Ensure the latch is oriented correctly for your door's swing.
2. Connect the front keypad panel to the deadbolt latch and route the connecting wire through the door hole.
3. Attach the rear panel locating plate to the door, securing it with screws.
4. Connect the wire from the front panel to the rear panel.
5. Mount the rear panel to the locating plate and secure it.
6. Install the strike plate and strike box on the door frame.

5. Operating Instructions

5.1. Adding Passwords

Learn how to add administrator and general user passwords to your lock.

5.2. Changing Passwords

Instructions for changing existing administrator or general user passwords.

5.3. Deleting Passwords

Steps to delete single user passwords or all user passwords (excluding administrator).

5.4. Automatic Locking Function

Configure the lock to automatically lock after a set period (5-900 seconds).

5.5. Normally Open Mode

Enable or disable the normally open mode, allowing the door to remain unlocked without requiring a code for entry.

5.6. Vacation Mode

Activate or deactivate vacation mode to enhance security when you are away for an extended period.

5.7. Silence Mode

Enable or disable silence mode to mute the lock's beeping sounds during operation.

6. Maintenance

• Cleaning: Wipe the keypad and lock body with a soft, damp cloth. Avoid harsh chemicals or abrasive materials.
• Battery Replacement: Replace all four AA batteries when the low battery alarm sounds. Use high-quality alkaline batteries for optimal performance.
• Lubrication: Periodically lubricate the deadbolt latch mechanism with a silicone-based lubricant to ensure smooth operation.

6.1. Emergency Battery Backup

If batteries run out, you can use a power bank to temporarily power the lock via the micro-USB port for emergency entry.

The lock's exterior unit with a micro-USB port for emergency power supply.

7. Troubleshooting

Common issues and their solutions:

7.1. System Resetting

If the lock malfunctions or you need to restore factory settings, perform a system reset. This will delete all user passwords but retain the administrator password.

8. Specifications

• Brand: Probrico
• Lock Type: Keypad
• Model Number: Probrico-KEDL-100-SC-ORB-1T
• Color: Oil Rubbed Bronze
• Style: Single Cylinder Deadbolt
• Dimensions (L x W x H): 8 x 7 x 4 inches
• Item Weight: 2.18 pounds
• Power Source: 4 x AA Batteries (not included)
• Control Method: Touch, Mechanical knob
• User Codes: Up to 100 programmable codes

9. Warranty & Support

For detailed warranty information and customer support, please refer to the official Probrico website or contact their customer service. An official installation manual in PDF format is also available for download:

Download Installation Manual (PDF)