Introduction
Thank you for choosing the Moen Sombra 87702 Single-Handle Kitchen Faucet with Side Sprayer. This manual provides detailed instructions for the proper installation, operation, and maintenance of your new faucet to ensure long-lasting performance and satisfaction. Please read all instructions carefully before beginning installation or use.
Safety Information
- Always turn off the main water supply before installing or servicing the faucet.
- Wear safety glasses and gloves during installation to prevent injury.
- If you are unsure about any part of the installation process, consult a qualified plumber.
- Do not overtighten connections, as this may cause damage to the faucet or plumbing.
Package Contents
Verify that all components are present before beginning installation:
- Moen Sombra Single-Handle Kitchen Faucet
- Side Sprayer with Hose
- Supply Lines (pre-attached or included)
- Optional Deck Plate (for 3 or 4-hole installations)
- Mounting Hardware
Figure 1: Moen Sombra Faucet and Included Components. This image displays the main faucet body, the side sprayer, and icons indicating included supply lines and an optional deck plate for 2 or 4-hole installations.
Setup and Installation
This faucet is designed for single-hole or 4-hole installation. Follow these general steps for proper setup:
- Prepare the Installation Area: Turn off the hot and cold water supply valves under the sink. Clear the area around the sink hole(s) and remove any existing faucet.
- Install the Faucet: If using a single-hole installation, place the faucet directly into the sink hole. For 4-hole installations, first place the optional deck plate over the sink holes, then insert the faucet through the center hole of the deck plate. Secure the faucet from underneath the sink using the provided mounting hardware.
- Connect Water Supply Lines: Connect the hot and cold supply lines from the faucet to the corresponding hot and cold water supply valves. Ensure connections are hand-tight, then use a wrench for a quarter turn to secure, being careful not to overtighten.
- Connect Side Sprayer: Attach the side sprayer hose to the designated connection point on the faucet body or supply line assembly under the sink. Ensure a secure, leak-free connection.
- Test for Leaks: Once all connections are made, slowly turn on the hot and cold water supply valves. Check all connections for any signs of leaks. Run the faucet for a few minutes to flush out any debris and check for proper operation.
Operating Instructions
The Moen Sombra faucet features a single handle for easy control of water flow and temperature, along with a convenient side sprayer.
- Water Flow and Temperature: The single lever handle controls both water flow and temperature. Lift the handle to increase water flow. Move the handle to the left for hot water and to the right for cold water.
- Side Sprayer Operation: To use the side sprayer, simply press the trigger on the sprayer handle. Water will divert from the main spout to the sprayer. Release the trigger to return water flow to the main spout.
- Spout Swivel: The high-arc spout can swivel 360 degrees, providing flexibility and reach for various sink tasks.
Figure 2: Faucet in Operation. This image shows the Moen Sombra faucet installed in a kitchen, with water flowing from the high-arc spout into a double-basin sink.
Figure 3: Faucet and Side Sprayer Detail. A detailed view of the Moen Sombra faucet and its chrome side sprayer, highlighting their design and finish.
Maintenance
To maintain the beauty and performance of your Moen Sombra faucet, follow these cleaning and care guidelines:
- Cleaning the Finish: Clean the chrome finish regularly with a soft, damp cloth. For stubborn spots, use a mild soap and water solution, then rinse thoroughly and dry with a soft cloth.
- Avoid Harsh Cleaners: Do not use abrasive cleaners, scouring pads, ammonia-based cleaners, or cleaners containing bleach, acids, or alcohol. These can damage the finish and void your warranty.
- Aerator Maintenance: If water flow decreases, the aerator may be clogged. Unscrew the aerator from the end of the spout, clean any debris, and rinse thoroughly before reattaching.
Troubleshooting
If you encounter issues with your faucet, refer to the following common problems and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Low water flow from spout | Clogged aerator; partially closed supply valve; debris in supply lines. | Clean aerator; ensure supply valves are fully open; flush supply lines. |
| Faucet leaks from base or connections | Loose connections; worn O-rings or gaskets. | Tighten connections (do not overtighten); replace O-rings or gaskets if worn. |
| Side sprayer not working or weak flow | Diverter issue; clogged sprayer head; kinked hose. | Check sprayer hose for kinks; clean sprayer head; if diverter is faulty, contact customer support for replacement parts. |
| Water temperature inconsistent | Improper adjustment of hot/cold supply; issue with cartridge. | Verify hot and cold supply lines are connected correctly; if problem persists, the cartridge may need inspection or replacement. |
If these solutions do not resolve the issue, please contact Moen Customer Support.
Specifications
| Feature | Detail |
|---|---|
| Brand | Moen |
| Model Name | Sombra 87702 |
| Finish Type | Chrome |
| Material | Metal (Stainless Steel) |
| Number of Handles | 1 |
| Mounting Type | Deck Mount |
| Hole Count | 4 (or Single Hole with optional deck plate) |
| Spout Height | 15.34 Inches |
| Spout Reach | 8.2 Inches |
| Special Feature | 360 Swivel Spout |
| Recommended Uses | Kitchen |
| Item Weight | 6.44 pounds |
Warranty Information
Moen faucets are manufactured under the highest standards of quality and workmanship. The Moen Sombra 87702 faucet is backed by Moen's Limited Lifetime Warranty against leaks, drips, and finish defects to the original consumer purchaser. For full warranty details and conditions, please refer to the official Moen website or contact customer support.
Customer Support
If you have any questions, require assistance with installation, or need to order replacement parts, please contact Moen Customer Support:
- Website: Visit the official Moen website for FAQs, product registration, and contact information.
- Phone: Refer to your product packaging or the Moen website for the most current customer service phone numbers.
Please have your model number (87702) and date of purchase available when contacting support.
