Beninca To Go 2AK Gate Remote User Manual

Introduction

This manual provides comprehensive instructions for the proper use, setup, and maintenance of your Beninca To Go 2AK Gate Remote. Please read this manual carefully before operating the device to ensure safe and efficient use.

Image of the Beninca To Go 2AK Gate Remote, showing its white casing and two black control buttons.

Product Overview

The Beninca To Go 2AK is an ergonomic gate remote control designed for convenient operation of compatible Beninca gate automation systems. It features two control buttons for managing different gate functions.

• Ergonomic Design: Comfortable to hold and use.
• Two Buttons: Allows for control of two distinct gate functions or gates.
• Infrared Connectivity: Reliable signal transmission.

Setup and Programming

Programming the Beninca To Go 2AK remote typically involves a simple procedure to link it with your existing Beninca gate receiver. The exact steps may vary slightly depending on your specific gate automation model. Always refer to your gate opener's manual for detailed programming instructions.

General Programming Steps (Consult Gate Opener Manual for Specifics):

1. Access the Receiver: Locate the programming button or dip switches on your gate opener's control board. This is often inside the gate motor housing.
2. Activate Learning Mode: Press and hold the programming button on the receiver until an indicator light (LED) illuminates or flashes, indicating it is in learning mode.
3. Transmit Code: While the receiver is in learning mode, press the desired button on your new Beninca To Go 2AK remote for a few seconds. The receiver's indicator light may change or turn off to confirm successful programming.
4. Test Operation: After programming, wait a few seconds, then test the remote by pressing the programmed button to ensure the gate responds correctly.
5. Program Additional Buttons (if needed): Repeat the process for the second button if you wish to control another function or gate.

Note: If you encounter difficulties, ensure the remote has a fresh battery and that you are within range of the gate receiver.

Operating Instructions

Once programmed, operating your Beninca To Go 2AK remote is straightforward.

• Opening/Closing the Gate: Press the programmed button once to activate the gate. Depending on your gate system's configuration, a single press will typically open or close the gate, or stop it if it is in motion.
• Stopping the Gate: If the gate is in motion, pressing the same button again will usually stop its movement.
• Range: The maximum effective range is approximately 10 metres, but this can be affected by environmental factors and obstacles.

Maintenance

Battery Replacement:

The Beninca To Go 2AK remote uses an Alkaline battery. If the remote's range decreases significantly or the indicator light (if present) does not illuminate when a button is pressed, the battery may need replacement.

1. Locate the battery compartment, usually on the back or side of the remote.
2. Carefully open the compartment using a small screwdriver or coin if necessary.
3. Remove the old battery and insert a new one, ensuring correct polarity (+/-).
4. Close the battery compartment securely.
5. Test the remote's functionality.

Cleaning:

Clean the remote with a soft, dry cloth. Do not use abrasive cleaners or solvents, as these can damage the casing or internal components.

Troubleshooting

Specifications

Warranty and Support

For warranty information and technical support, please contact your Beninca product supplier or refer to the official Beninca website. Keep your proof of purchase for any warranty claims.

For further assistance, you may also refer to the product page on Amazon.co.uk.