Scout Rectangular Blue Digital Alarm Clock Model 280001026 User Manual

Introduction

This manual provides comprehensive instructions for the setup, operation, and maintenance of your Scout Rectangular Blue Digital Alarm Clock, Model 280001026. Please read this manual carefully before using the device to ensure proper function and longevity.

The Scout alarm clock features a unique design where rotating the clock activates or deactivates the alarm. It includes a precise alarm time adjustment, a light button for night illumination, and a snooze function. A twilight switch allows for continuous display illumination at night.

Package Contents

• Scout Rectangular Blue Digital Alarm Clock
• User Manual (this document)

Note: Batteries are not included and must be purchased separately.

Setup

1. Battery Installation

1. Locate the battery compartment on the back of the alarm clock.
2. Open the battery compartment cover.
3. Insert the required batteries (e.g., 2x AA, check specifications) according to the polarity indicators (+/-).
4. Close the battery compartment cover securely.

2. Setting the Time

1. On the back of the alarm clock, locate the time setting controls (usually a dial or buttons).
2. Adjust the time to the current hour and minute.

3. Setting the Alarm Time

1. Locate the alarm setting controls on the back of the alarm clock.
2. Adjust the alarm time to your desired wake-up time.

Operating Instructions

Activating and Deactivating the Alarm

The Scout alarm clock features a unique rotation mechanism to control the alarm function.

Image: This composite image illustrates how to activate and deactivate the alarm. When the side marked "AN" (ON) is facing up, the alarm is active. When the side marked "AUS" (OFF) is facing up, the alarm is deactivated. The middle section shows the clock being rotated to switch between these states.

• To activate the alarm, rotate the alarm clock so that the side marked "AN" (ON) is facing upwards. The display will show the current time and the set alarm time.
• To deactivate the alarm, rotate the alarm clock so that the side marked "AUS" (OFF) is facing upwards. The alarm icon will disappear from the display.

Snooze Function

When the alarm sounds, press the SNOOZE button (located on the top of the clock) to temporarily silence the alarm. The alarm will sound again after a short interval (typically 5-10 minutes).

Display Illumination (Light Button)

Press the LICHT (LIGHT) button (located on the top of the clock) to illuminate the display for a few seconds, allowing you to view the time in the dark.

Permanent Night Illumination (Twilight Switch)

On the back of the alarm clock, locate the twilight switch. This switch allows you to enable or disable permanent display illumination during nighttime hours. When enabled, the display will automatically light up dimly in low-light conditions.

Maintenance

• Clean the alarm clock with a soft, dry cloth. Do not use abrasive cleaners or solvents.
• Avoid exposing the alarm clock to extreme temperatures, direct sunlight, or high humidity.
• If the display becomes dim or the alarm function is inconsistent, replace the batteries.
• Do not attempt to disassemble the alarm clock, as this may void the warranty and cause damage.

Troubleshooting

Specifications

Warranty and Support

For warranty information or technical support, please refer to the official Scout website or contact your retailer. Keep your purchase receipt as proof of purchase.

For further assistance, you may visit the Scout brand page on Amazon.