Introduction
This manual provides instructions for the assembly, operation, and care of your Spin Master PAW Patrol Ready Race Rescue Mobile Pit Stop Team Vehicle Playset. Please read all instructions carefully before use and retain this manual for future reference.
What's Included
- 1 x Mobile Pit Stop Team Vehicle
- 1 x Exclusive Chase Race Car
- 1 x Exclusive Chase Figure
Image: The complete PAW Patrol Ready Race Rescue Mobile Pit Stop Vehicle Playset, showing the main vehicle, Chase figure, and Chase race car.
Safety Information
WARNING: CHOKING HAZARD - Small parts. Not for children under 3 years. Adult supervision is recommended.
WARNING: Contains button or coin cell battery. Hazardous if swallowed. See instructions for battery replacement and disposal. KEEP BATTERIES OUT OF REACH OF CHILDREN.
Setup
- Unpack Components: Carefully remove all items from the packaging. Ensure all included parts are present.
- Initial Vehicle Configuration: The Mobile Pit Stop Team Vehicle may be in a compact state. Gently unfold any hinged sections to prepare it for play.
- Place Figure: Position the Chase figure into the Chase Race Car.
Image: Visual guide for setting up the playset. This image illustrates various play configurations and features of the Mobile Pit Stop Vehicle.
Operating Instructions
1. Transforming the Mobile Pit Stop
- Open Rear Ramp: Lower the back ramp of the Mobile Pit Stop vehicle to allow the Chase Race Car to drive in or out.
- Activate Transformation: Push the designated transformation button (often located on the top of the vehicle, as shown in the image) to open the panel into a race command center. This action may also activate sounds.
Image: This image shows the Mobile Pit Stop vehicle in its transformed state, revealing the race command center and internal features. It also depicts the process of opening the vehicle's side panels and rear ramp.
2. Launching the Race Car
- Position Car: Place the Chase Race Car into the built-in vehicle launcher within the command center.
- Launch: Push the yellow button (as indicated in the product description and image) to launch the race car forward.
Image: This image illustrates the mechanism for launching the Chase Race Car from the Mobile Pit Stop vehicle, showing the car exiting the launcher.
3. Activating Sounds
- Sound Buttons: Press the top two tire-shaped buttons on the Mobile Pit Stop vehicle to activate realistic sounds.
Maintenance
- Cleaning: Wipe the vehicle and figures with a damp cloth. Do not immerse in water.
- Storage: Store the playset in a clean, dry place away from direct sunlight when not in use. Ensure all components are properly closed and secured.
- Battery Replacement: If the sound features stop working, replace the button or coin cell batteries. Refer to the battery compartment for specific battery type and replacement instructions. Ensure proper polarity. Dispose of used batteries responsibly.
Troubleshooting
- Sounds Not Working:
- Check if batteries are correctly installed.
- Replace batteries with new ones if necessary.
- Vehicle Launcher Not Functioning:
- Ensure the race car is properly seated in the launcher.
- Verify that no obstructions are blocking the launch mechanism.
Specifications
| Product Dimensions | 6.5 x 4.3 x 1.2 inches |
| Item Weight | 1.6 pounds |
| ASIN | B0849K7CFN |
| Manufacturer | Spinmaster |
| Date First Available | January 28, 2020 |
Warranty and Support
For warranty information or customer support, please visit the official Spin Master website or contact their customer service department. Contact details can typically be found on the product packaging or the manufacturer's website.
Official Website: www.spinmaster.com
PAW Patrol Official Website: www.pawpatrol.com