Introduction
This manual provides essential instructions for the safe and efficient use of your Nespresso Inissia Original Espresso Machine. Please read all instructions before operating the appliance.
Setup
1. Unpacking and Initial Placement
Carefully remove the machine from its packaging. Place the machine on a clean, stable, and level surface. Ensure the power cord is accessible and not obstructed.
2. Filling the Water Tank
Lift the water tank lid and fill the tank with fresh drinking water. Do not exceed the 'MAX' fill line. Ensure the water tank is securely placed back on the machine.

3. First Use and Rinsing
Before first use, or after a long period of inactivity, rinse the machine. Fill the water tank. Place a container under the coffee outlet. Press either the Espresso or Lungo button to run water through the system without a capsule. Repeat this process 2-3 times to clean the internal components.
Operating Instructions
1. Powering On
Plug the machine into a grounded power outlet. Press either the Espresso or Lungo button to turn on the machine. The buttons will flash while the machine heats up. The machine is ready when the buttons illuminate steadily (approximately 25 seconds).
2. Inserting a Nespresso Capsule
Lift the lever completely. Insert a Nespresso Original capsule into the capsule compartment. Close the lever firmly.

3. Brewing Coffee
Place a cup under the coffee outlet. Press the Espresso button for a 40 ml shot or the Lungo button for a 110 ml shot. The machine will automatically stop when the selected volume is dispensed. You can stop the flow at any time by pressing the button again.
4. Ejecting the Used Capsule
After brewing, lift the lever to automatically eject the used capsule into the internal container. Close the lever.
5. Official Product Video: Nespresso Original Espresso Machine
Maintenance
1. Emptying the Used Capsule Container
The used capsule container can hold up to 11 capsules. Empty and rinse the container regularly to prevent overflow and maintain hygiene.

2. Cleaning the Drip Tray and Water Tank
Remove the drip tray and water tank. Wash them with warm water and a mild detergent. Rinse thoroughly and dry before reassembling. Do not use abrasive cleaning agents or scourers.
3. Descaling
Regular descaling is crucial for maintaining machine performance and coffee quality. Refer to the full Nespresso descaling instructions, typically found in the comprehensive manual or on the Nespresso website, for the correct procedure and recommended descaling solution.
Troubleshooting
- No water flow: Check if the water tank is filled and correctly positioned. Ensure no air bubbles are trapped in the system (run a few cycles of water without a capsule).
- Coffee is cold: Preheat your cup by running a Lungo cycle without a capsule. Ensure the machine has fully heated up (steady lights).
- Machine not turning on: Verify the power cord is securely plugged into a working outlet.
- Capsule not ejecting: Ensure the lever is lifted completely and then closed firmly.
Specifications
| Brand | Nespresso |
| Model Number | EN80CW |
| Color | Creamy White |
| Product Dimensions | 4.72"D x 12.63"W x 9.05"H |
| Item Weight | 3.99 pounds |
| Water Tank Capacity | 680 Milliliters |
| Pressure | 19 bars |
| Heat-up Time | 25 seconds |
| Cup Sizes | Espresso (40 ml), Lungo (110 ml) |
| Energy Saving Mode | Automatic switch-off after 9 minutes |
Warranty and Support
Your Nespresso Inissia Original Espresso Machine is covered by a manufacturer's warranty. For detailed warranty information, product registration, or technical support, please refer to the documentation included with your purchase or visit the official Nespresso website.