APDTY 141745 Transmission Linear Control Shift Solenoid Wiring Pigtail Connector Set

Product Overview

The APDTY 141745 Transmission Linear Control Shift Solenoid Wiring Pigtail Connector Set is a brand new kit designed for repairing or replacing damaged transmission solenoid wiring connectors. This set includes both the brown and black wiring connectors required for the repair.

It is intended for use with APDTY-141744 or Honda part numbers 28250-P6H-024, 28250P6H024, and D98990.

This product is compatible with various Acura and Honda models, including:

• 1998-2003 Acura CL
• 1996-2001 Acura Integra
• 2001-2002 Acura MDX
• 1999-2003 Acura TL
• 1998-2007 Honda Accord
• 2003-2007 Honda Pilot
• 1997-2001 Honda Prelude
• 1998-2006 Honda Odyssey

Setup and Installation

This wiring pigtail connector set is designed for direct replacement of existing damaged connectors. Installation should be performed by a qualified technician or an individual with experience in automotive electrical systems.

Important: Always disconnect the vehicle's battery before beginning any electrical work to prevent short circuits or damage to components.

The kit includes one brown connector and one black connector. Ensure correct identification and connection to the corresponding solenoid terminals. Refer to your vehicle's factory service manual for specific wiring diagrams and procedures related to the transmission linear control shift solenoid.

Figure 1: The APDTY 141745 connector set, featuring both the brown and black wiring pigtail connectors.

Figure 2: Detailed view of the brown connector, showing its internal pin configuration.

Figure 3: Detailed view of the black connector, showing its internal pin configuration.

Ensure all connections are secure and properly insulated after installation.

Maintenance

While the wiring connectors themselves require no specific maintenance, the proper functioning of the transmission system, which these connectors support, relies heavily on regular vehicle maintenance.

It is imperative to follow all factory service manual recommendations for transmission fluid and filter changes. Improper fluid levels and condition can lead to internal transmission failure, which may manifest as issues that could be mistakenly attributed to electrical components.

Troubleshooting

This product is a repair part for damaged wiring connectors. If you are experiencing transmission issues, ensure that the problem is indeed related to faulty wiring or connectors before replacing this component.

• Diagnosis: Before replacing connectors, verify that the original connectors are physically damaged (e.g., chewed wires, corroded terminals) or electrically faulty.
• Underlying Issues: The most successful repairs using this kit are on models that have no pre-existing internal transmission issues. If the transmission has internal mechanical or hydraulic problems, replacing the wiring connectors will not resolve those issues.
• Fluid Condition: As noted in the maintenance section, incorrect transmission fluid levels or degraded fluid quality can cause transmission malfunctions. Always check and correct fluid levels and condition according to the manufacturer's specifications.
• Post-Installation: After replacing the connectors, it may be necessary to clear any stored transmission shift codes from the vehicle's onboard diagnostic system using an appropriate scan tool.

Specifications

California Proposition 65 WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.

Warranty and Support

For information regarding product warranty or technical support, please contact APDTY directly through their official channels or the retailer from whom the product was purchased.

Visit the APDTY Store on Amazon for more product information and contact options.