Duravit 219601

Duravit No.1 One-Piece Toilet with HygieneGlaze Instruction Manual

Model: 219601

1. Introduction

Thank you for choosing the Duravit No.1 One-Piece Toilet with HygieneGlaze. This manual provides essential information for the safe installation, operation, and maintenance of your new toilet. Please read these instructions carefully before installation and retain them for future reference.

Duravit No.1 One-Piece Toilet in white with HygieneGlaze

Figure 1: The Duravit No.1 One-Piece Toilet, a modern white ceramic toilet featuring an integrated tank and bowl, designed for efficient and hygienic use.

2. Safety Information

Please observe the following safety precautions during installation and use:

  • Always turn off the water supply to the toilet before beginning any installation or maintenance work.
  • Wear appropriate personal protective equipment (PPE) such as gloves and eye protection during installation.
  • The toilet is heavy. Use proper lifting techniques or seek assistance to prevent injury.
  • Ensure all connections are secure and watertight to prevent leaks.
  • Do not use abrasive cleaners or tools that could damage the toilet's surface or HygieneGlaze coating.
  • Keep small parts out of reach of children.

3. Setup and Installation

This section outlines the general steps for installing your Duravit No.1 One-Piece Toilet. Professional installation is recommended.

3.1. Required Tools and Materials (Not Included)

  • Adjustable wrench
  • Screwdriver (Phillips and flathead)
  • Putty knife
  • Measuring tape
  • Level
  • Wax ring with flange or rubber seal
  • Toilet supply line
  • Caulk gun and silicone sealant

3.2. Installation Steps

  1. Prepare the Area: Turn off the water supply to the existing toilet and flush to empty the tank. Disconnect the supply line and remove the old toilet. Clean the flange area thoroughly.
  2. Install Wax Ring/Seal: Place a new wax ring with a plastic horn or a rubber seal onto the closet flange on the floor. Ensure it is centered.
  3. Position the Toilet: Carefully lift the Duravit No.1 One-Piece Toilet and align the bolt holes on the toilet base with the closet bolts on the flange. Gently lower the toilet onto the wax ring/seal.
  4. Secure the Toilet: Install the washers and nuts onto the closet bolts. Tighten the nuts alternately until the toilet is snug and stable, but do not overtighten, as this can crack the ceramic.
  5. Connect Water Supply: Connect the flexible water supply line from the shut-off valve to the fill valve inlet on the toilet tank. Hand-tighten, then use a wrench for a final quarter-turn.
  6. Restore Water Supply and Check for Leaks: Turn on the water supply slowly and allow the tank to fill. Check all connections for leaks. Flush the toilet several times to ensure proper operation and check for any further leaks.
  7. Apply Caulk (Optional): For a finished look and to prevent water from collecting under the base, apply a bead of silicone caulk around the base of the toilet where it meets the floor. Leave a small gap at the back for ventilation.

4. Operating Instructions

The Duravit No.1 One-Piece Toilet is designed for simple and efficient operation.

  • Flushing: To flush the toilet, press the flush button located on the top of the tank. This model typically features a dual-flush mechanism. Press the smaller button for a liquid waste flush and the larger button for a solid waste flush to conserve water.
  • HygieneGlaze: Your toilet is equipped with HygieneGlaze, an innovative ceramic glaze that is antibacterial and highly effective in inhibiting the growth of bacteria and germs. This contributes to a cleaner and more hygienic toilet surface.

5. Maintenance and Care

Proper care will ensure the longevity and performance of your Duravit No.1 Toilet, especially maintaining the effectiveness of the HygieneGlaze.

  • Regular Cleaning: Clean the toilet regularly with a soft cloth or sponge and a mild, non-abrasive bathroom cleaner.
  • HygieneGlaze Care: To preserve the HygieneGlaze coating, avoid using harsh chemicals, abrasive cleaners, scouring pads, or strong acids/alkalis. These can damage the glaze and reduce its antibacterial properties.
  • Toilet Seat: Clean the plastic toilet seat with mild soap and water. Do not use harsh chemicals, as they can discolor or damage the seat material.
  • Internal Components: Periodically check the fill valve and flush valve for proper operation and wear. If issues arise, consult a plumber or refer to specific component manuals.

6. Troubleshooting

Refer to the following table for common issues and their solutions.

ProblemPossible CauseSolution
Toilet runs continuouslyFlapper not sealing, fill valve out of adjustment, or debris in valve.Check flapper for proper seating and wear. Adjust fill valve water level. Clean any debris from the fill valve.
Weak flushLow water level in tank, clogged rim jets, or partial clog in trapway.Adjust fill valve to increase water level. Clean rim jets under the bowl rim. Use a toilet auger to clear trapway.
Leaking at baseLoose closet bolts, faulty wax ring/seal, or cracked toilet base.Tighten closet bolts (do not overtighten). Replace wax ring/seal. If cracked, the toilet may need replacement.
Slow tank refillPartially closed water supply valve or clogged fill valve.Ensure water supply valve is fully open. Clean or replace fill valve if clogged.

If these solutions do not resolve the issue, please contact Duravit customer support or a qualified plumber.

7. Specifications

FeatureDetail
BrandDuravit
Model Number219601
ColorWhite
Product Dimensions (D x W x H)29.13" x 14.38" x 29.13"
Item Weight102 pounds
Installation TypeFloor Mounted (One-Piece)
Seat Material TypePlastic
Special FeatureHygieneGlaze antibacterial ceramic coating

8. Warranty and Support

Duravit products are manufactured to high-quality standards. For specific warranty information regarding your Duravit No.1 One-Piece Toilet, please refer to the warranty documentation included with your purchase or visit the official Duravit website.

For technical assistance, replacement parts, or any other inquiries, please contact Duravit customer support. Contact details can typically be found on the Duravit website or in the packaging materials.

Related Documents - 219601

Preview Duravit Happy D.2 Wall-Mounted Rimless Toilet - Technical Specifications and Accessories
Detailed specifications, dimensions, and accessory information for the Duravit Happy D.2 wall-mounted rimless toilet, including color options, variants, and compatible SensoWash shower-toilet seats.
Preview Duravit One-Piece Toilet Installation Guide
Comprehensive installation instructions for the Duravit One-Piece Toilet, covering safety, parts, and step-by-step assembly for a proper and lasting installation.
Preview Duravit Two-Piece Toilet Mounting Instructions
Detailed mounting and installation instructions for the Duravit Two-Piece Toilet, including safety guidelines, product information, and step-by-step assembly.
Preview Duravit Vero Toilet Seat and Cover SoftClose Installation Guide
Step-by-step instructions for installing the Duravit Vero toilet seat and cover with SoftClose functionality. Includes diagrams and multilingual guidance.
Preview Duravit DuraStyle Toilet Seat and Cover with Soft Close Installation Guide
This document provides installation instructions for the Duravit DuraStyle toilet seat and cover with soft-close functionality. It includes multilingual assembly steps and diagrams.
Preview Duravit DuraStyle Toilet Seat Installation Guide
Official mounting instructions for the Duravit DuraStyle toilet seat and cover, providing step-by-step guidance for installation.