Introduction
This manual provides instructions for the Mr. Coffee Easy Measure 12 Cup Programmable Coffee Maker, Model 31160392. This appliance is designed to simplify coffee preparation with its color-coded measuring system and programmable features. It includes a 2-step advanced water filtration system to enhance coffee flavor and an illuminated freshness indicator.
Important Safeguards
When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons, including the following:
- Read all instructions before using this product.
- Do not touch hot surfaces. Use handles or knobs.
- To protect against electric shock, do not immerse cord, plugs, or coffee maker in water or other liquid.
- Close supervision is necessary when any appliance is used by or near children.
- Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts, and before cleaning the appliance.
- Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair, or adjustment.
- The use of accessory attachments not recommended by the appliance manufacturer may result in fire, electric shock, or injury to persons.
- Do not use outdoors.
- Do not let cord hang over edge of table or counter, or touch hot surfaces.
- Do not place on or near a hot gas or electric burner, or in a heated oven.
- To disconnect, turn any control to “off,” then remove plug from wall outlet.
- Do not use appliance for other than intended use.
- Scalding may occur if the lid is removed during the brewing cycle.
Package Contents
Verify that all components are present in the packaging:
- Mr. Coffee Easy Measure 12 Cup Programmable Coffee Maker Unit
- Glass Carafe
- Gold Tone Reusable Filter
- Measuring Scoop
- Water Filtration System (with initial filter cartridge)
Image: The Mr. Coffee Easy Measure 12 Cup Programmable Coffee Maker shown with its glass carafe, gold tone reusable filter, measuring scoop, and water filter.
Setup
- Unpack the Coffee Maker: Remove all packaging materials, labels, and tags from the coffee maker.
- Clean Components: Wash the carafe, reusable filter, and water filter basket in warm, soapy water. Rinse thoroughly and dry.
- Position the Coffee Maker: Place the coffee maker on a flat, level surface near an electrical outlet.
- Install Water Filter: If using the water filtration system, insert the filter cartridge into the filter holder as per the instructions provided with the filter. Place the assembled filter into the water reservoir.
- Initial Cleaning Cycle: Before first use, run a full brewing cycle with only water to clean the internal components. Fill the water reservoir to the 12-cup mark with fresh water. Do not add coffee grounds. Press the “Brew Now” button. Discard the water after the cycle is complete.
Image: A hand demonstrates the installation of the water filtration system into the coffee maker's reservoir, designed to reduce impurities for better-tasting coffee.
Operating Instructions
Brewing Coffee
- Fill Water Reservoir: Open the lid and fill the water reservoir with cold, fresh water to the desired level, using the color-coded markings on the reservoir and carafe for accurate measurement.
- Add Coffee Grounds: Place the gold tone reusable filter (or a paper filter) into the brew basket. Use the included measuring scoop to add the appropriate amount of coffee grounds, following the color-coded guide on the scoop. For best results, use 1 scoop per 2 cups of water.
Image: This image illustrates the color-coding system for measuring, showing a hand adding coffee grounds into the filter basket, with corresponding color indicators on the scoop and water level.
Image: A detailed view of the coffee maker's brew basket, emphasizing its design for holding a larger quantity of coffee grounds.
- Close Lid and Place Carafe: Close the top lid securely and ensure the empty carafe is properly placed on the warming plate.
- Start Brewing: Press the “Brew Now” button to begin the brewing cycle. The coffee maker will automatically start brewing.
- Grab-A-Cup Auto Pause: The “Grab-A-Cup” feature allows you to temporarily remove the carafe during brewing to pour a cup. The brewing will pause and resume once the carafe is returned to the warming plate. Do not remove the carafe for more than 20 seconds to prevent overflow.
- Freshness Indicator: After brewing, the illuminated freshness indicator will display how long the coffee has been sitting on the warming plate, up to 4 hours.
Image: A close-up view of the coffee maker's control panel, highlighting the 'FRESH' indicator light, which signals the freshness of the brewed coffee.
Programming “Brew Later”
- Set Current Time: Press the “Hour” and “Min” buttons to set the current time. Hold the buttons to advance quickly.
- Set Delay Brew Time: Press the “Program” button. The program indicator light will illuminate. Use the “Hour” and “Min” buttons to set the desired time for brewing to start.
- Activate Delay Brew: Press the “Program” button again to confirm. The program indicator light will remain on, indicating that the delay brew is set. The coffee maker will automatically start brewing at the programmed time.
Maintenance
Daily Cleaning
- Always unplug the coffee maker before cleaning.
- Wash the carafe, reusable filter, and measuring scoop in warm, soapy water. These parts are also top-rack dishwasher safe.
- Wipe the exterior of the coffee maker with a soft, damp cloth. Do not use abrasive cleaners or scouring pads.
- Do not immerse the coffee maker base in water or any other liquid.
Descaling (Mineral Deposit Removal)
Mineral deposits (calcium) can build up in your coffee maker over time, affecting performance and coffee flavor. Descale your coffee maker every 3-6 months, or more frequently if you have hard water.
- Fill the water reservoir with 4 cups of undiluted white household vinegar.
- Place an empty carafe on the warming plate.
- Press the “Clean” button. The clean indicator light will illuminate.
- Allow the coffee maker to complete the cleaning cycle. Once complete, the clean indicator light will turn off.
- Run 2-3 full cycles with fresh water only to rinse out any remaining vinegar.
Water Filter Replacement
The 2-step advanced water filtration system requires periodic filter replacement for optimal performance. Replacement cartridges are sold separately. Refer to the filter packaging for specific replacement intervals, typically every 30-60 days depending on usage and water hardness.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Coffee does not brew. | Coffee maker not plugged in; “Brew Now” not pressed; Delay Brew set; Water reservoir empty. | Ensure unit is plugged in. Press “Brew Now”. Check if Delay Brew is active. Fill water reservoir. |
| Coffee tastes weak or too strong. | Incorrect coffee-to-water ratio; Coffee grounds too fine/coarse. | Adjust coffee grounds amount using the Easy Measure system. Use medium grind coffee. |
| Water overflows from brew basket. | Too much coffee grounds; Filter not seated correctly; Clogged filter. | Reduce coffee grounds. Ensure filter is properly seated. Clean or replace filter. |
| Coffee maker leaks. | Carafe not properly placed; Mineral buildup. | Ensure carafe is centered on warming plate. Perform descaling procedure. |
| Display shows incorrect time. | Power interruption. | Reset the current time using the “Hour” and “Min” buttons. |
Specifications
- Brand: Mr. Coffee
- Model Name: Easy Measure 12 Cup Programmable
- Model Number: 31160392
- Coffee Maker Type: Drip Coffee Machine
- Capacity: 12 Cups
- Color: Silver/Chrome
- Product Dimensions: 9.4"D x 11.3"W x 14.6"H
- Item Weight: 6.39 pounds
- Special Feature: Programmable, Easy Measure System, Water Filtration, Freshness Indicator
- Included Components: Coffee Maker, Glass Carafe, Gold Tone Reusable Filter
- Operation Mode: Fully Automatic
- Human Interface Input: Buttons
- UPC: 072179237136
Image: A diagram illustrating the physical dimensions (depth, width, height) of the Mr. Coffee Easy Measure 12 Cup Programmable Coffee Maker.
Warranty Information
Mr. Coffee products typically come with a limited manufacturer's warranty. For specific details regarding the warranty period, coverage, and terms for your Model 31160392 coffee maker, please refer to the warranty card included in your product packaging or visit the official Mr. Coffee website. Keep your purchase receipt as proof of purchase for any warranty claims.
Support
For further assistance, product registration, or to purchase replacement parts and accessories, please visit the official Mr. Coffee website or contact their customer service department. Contact information can typically be found on the product packaging or the official website.
Online Resources: www.mrcoffee.com
