Introduction
The Tamiya 58664 1/10 RC Ford Mustang GT4 Race Car Kit is a highly detailed radio control replica of the Ford Mustang GT4, designed for enthusiasts who enjoy the assembly process. This kit features a polycarbonate body that faithfully captures the sleek racing car, sitting atop the versatile TT-02 chassis. The TT-02 chassis is known for being beginner-friendly, highly adaptable, and easy to maintain, with a shaft-driven 4WD system.
What's in the Box
- Tamiya 58664 1/10 RC Ford Mustang GT4 Race Car Kit, with TT-02 Chassis
Please note that additional items such as a 2-channel radio, servo, 7.2-7.4volt battery pack, compatible charger, and Tamiya PS paint are required and sold separately to complete the model.
Safety Information
This product contains small parts and is not suitable for children under 16 years of age. Adult supervision is recommended during assembly and operation. Always follow local regulations regarding the use of radio-controlled models.
Setup and Assembly
The Tamiya Ford Mustang GT4 is a model kit that requires assembly. Follow the detailed instructions provided in the kit's manual for step-by-step guidance. Pay close attention to the order of assembly and the correct placement of parts.
Chassis Assembly (TT-02)
The TT-02 chassis is a shaft-driven 4WD system. It features a bathtub-type frame for durability and ease of assembly. Ensure all gears are properly lubricated and all screws are tightened securely but not over-tightened to avoid stripping plastic.
Image: Detailed view of the TT-02 chassis, showing the layout of components including the motor, receiver case, and battery compartment.
Body Preparation and Painting
The polycarbonate body comes clear and requires painting from the inside. Carefully cut out the body shell and wheel arches. Use Tamiya PS (Polycarbonate Spray) paints for best results. Mask off windows and other areas that should remain clear or be painted a different color. The kit includes separately molded plastic components for the rear wing and side mirrors, which should be attached after painting.
Image: Fully assembled Tamiya 1/10 RC Ford Mustang GT4 Race Car, showcasing the detailed body and wheels.
Image: Front view of the Tamiya Ford Mustang GT4 RC car, highlighting the grille and headlight details.
Image: Rear view of the Tamiya Ford Mustang GT4 RC car, showing the taillights and rear wing.
Image: Side profile of the Tamiya Ford Mustang GT4 RC car, displaying the body lines and wheel design.
Operating Your RC Car
Once assembled and equipped with the necessary electronics (radio, receiver, servo, battery), your Tamiya Ford Mustang GT4 is ready for operation. Ensure your battery is fully charged and properly connected. Turn on your transmitter first, then the car's receiver.
Driving Tips
- Start in an open area free from obstacles and people.
- Familiarize yourself with the controls: throttle for speed (forward/reverse) and steering for direction.
- The TT-02 chassis offers stable handling, making it suitable for various surfaces.
- Avoid prolonged full-throttle operation, especially on rough surfaces, to prevent overheating.
- Always turn off the car's receiver first, then the transmitter, when finished operating.
No official product videos from the seller are available for embedding at this time.
Maintenance
Regular maintenance will ensure the longevity and optimal performance of your Tamiya RC car. After each use, inspect the vehicle for any loose screws, damaged parts, or debris.
Post-Operation Checklist
- Clean the Chassis: Remove dirt, dust, and small stones from the chassis, suspension arms, and gearboxes. A soft brush or compressed air can be useful.
- Check Screws: Ensure all screws are tight. Pay particular attention to screws holding the motor, suspension components, and wheel hubs.
- Inspect Tires and Wheels: Check for wear, tears, or punctures on the tires. Ensure wheels are securely attached.
- Lubrication: Periodically check and re-lubricate moving parts, especially gears and bearings, as recommended in the kit's manual. Consider upgrading to ball bearings for smoother operation and reduced friction.
- Battery Care: Store batteries according to manufacturer's instructions. Do not leave batteries connected to the car when not in use.
Troubleshooting
If you encounter issues with your RC car, refer to the following common troubleshooting steps:
| Problem | Possible Cause | Solution |
|---|---|---|
| Car does not move or respond to controls. | Low battery in car or transmitter; loose wiring; receiver/transmitter not bound; motor/ESC issue. | Charge batteries; check all connections; re-bind receiver to transmitter; inspect motor/ESC for damage. |
| Car moves slowly or lacks power. | Low battery; motor/gears binding; excessive friction; motor wear. | Fully charge battery; check for debris in gears; lubricate moving parts; consider motor replacement or upgrade. |
| Steering is erratic or unresponsive. | Loose servo horn/linkage; damaged servo; radio interference; incorrect trim settings. | Check servo connections and linkages; replace servo if damaged; operate in a clear area; adjust transmitter trim. |
| Unusual noises from the drivetrain. | Debris in gears; worn gears; improper gear mesh. | Clean gears; inspect for wear and replace if necessary; adjust gear mesh according to manual. |
Specifications
| Feature | Detail |
|---|---|
| Product Dimensions | 19.13 x 9.13 x 6 inches |
| Item Weight | 2.2 pounds |
| ASIN | B07P2FQ8YT |
| Item Model Number | TAM58664 |
| Manufacturer Recommended Age | 16 - 16 years |
| Release Date | January 1, 2019 |
| Manufacturer | Tamiya |
Warranty and Support
For specific warranty information and technical support regarding your Tamiya 58664 1/10 RC Ford Mustang GT4 Race Car Kit, please refer to the documentation included with your product or visit the official Tamiya website. Tamiya is committed to providing high-quality products and support to its customers.
For further assistance, you may contact Tamiya customer service through their official channels.
