1. Introduction
Thank you for choosing the Hauslane IN-R100SS-30 30-Inch Range Hood Insert. This manual provides essential information for the safe installation, operation, and maintenance of your new range hood. Please read this manual thoroughly before installation and use, and retain it for future reference.
2. Important Safety Information
WARNING:
- Always disconnect power to the range hood before servicing or cleaning.
- Installation must be performed by a qualified technician in accordance with all local codes and standards.
- Ensure proper ventilation to prevent back-drafting of combustion gases from other fuel-burning appliances.
- Do not operate the range hood with damaged wiring or if the housing is compromised.
- Clean grease filters regularly to prevent grease fires.
- Never leave cooking unattended.
3. Product Overview
The Hauslane IN-R100SS-30 is a 30-inch stainless steel range hood insert designed for integration into kitchen cabinetry. It features powerful ventilation, LED lighting, and dishwasher-safe baffle filters.
Key Features:
- Recessed Design: Integrates seamlessly into kitchen cabinetry for a minimalist aesthetic.
- Heavy-Duty Performance: Engineered to handle demanding cooking tasks, effectively removing smoke, steam, and odors.
- Baffle Filters: Stainless steel baffle filters efficiently capture grease particles before they drip onto surfaces.
- Replaceable LED Lighting: Features GU10 base LED lamps for energy-efficient illumination. Bulbs are easily replaceable and widely available.
- Ductless Conversion Capability: Can be converted for ductless operation using optional charcoal filters (sold separately).
- Dishwasher-Safe Filters: Baffle filters are removable and safe for cleaning in a dishwasher.
Components Included:
- 1 x Hauslane IN-R100SS-30 Range Hood Insert
- 1 x Dishwasher-Safe Baffle Filter (for 30'' Model)
- 1 x Top 6'' Round Exhaust Adapter
Figure 3.1: Front view of the Hauslane IN-R100SS-30 Range Hood Insert.
Figure 3.2: The range hood insert seamlessly installed under kitchen cabinetry.
Figure 3.3: Diagram illustrating the components included with the IN-R100SS-30 model.
4. Setup and Installation
Professional installation is highly recommended for this appliance to ensure proper function and safety. Refer to the technical drawing for precise dimensions and clearance requirements.
4.1 Pre-Installation Checklist:
- Verify that all components listed in Section 3.3 are present.
- Ensure the installation area meets the required dimensions and electrical specifications (120 Volts, 1.8 Amps).
- Determine if the installation will be ducted (vented to the outside) or ductless (recirculating). For ductless operation, charcoal filters (sold separately) are required.
- Confirm adequate structural support within the cabinet for the range hood insert.
4.2 Installation Steps (Summary):
- Prepare the cabinet opening according to the dimensions provided in the technical drawing.
- Install the ductwork (if ducted) or prepare for charcoal filter installation (if ductless). The unit accommodates a 6-inch round duct.
- Mount the range hood insert securely into the cabinet opening.
- Connect the electrical wiring to a grounded outlet, ensuring all connections comply with local electrical codes.
- Install the baffle filter(s) and LED lamps.
- Test the fan speeds and lighting functions.
Figure 4.1: Technical drawing showing dimensions and recommended installation clearance (24"-30" from cooktop).
5. Operating Instructions
The Hauslane IN-R100SS-30 features push-button controls for fan speed and lighting.
5.1 Fan Operation:
- Locate the fan speed control buttons on the right side of the unit.
- Press the appropriate button to select your desired fan speed (typically low, medium, high).
- For general cooking, a lower speed may suffice. For heavy-duty cooking or strong odors, higher speeds are recommended.
- Press the 'Off' button to turn off the fan.
5.2 Lighting Operation:
- Locate the light control button, usually positioned above the fan speed controls.
- Press the button to turn the LED lights on or off.
Figure 5.1: Push-button controls for fan speed and lighting.
6. Maintenance
Regular maintenance ensures optimal performance and extends the lifespan of your range hood.
6.1 Cleaning Baffle Filters:
- The stainless steel baffle filters should be cleaned regularly, ideally after every 30 hours of cooking or at least once a month, depending on usage.
- To remove, slide the latch or pull tab on the filter and gently pull it down.
- The filters are dishwasher-safe. Place them in the dishwasher for thorough cleaning.
- Alternatively, wash them by hand using hot water and a degreasing detergent.
- Ensure filters are completely dry before re-installing.
Figure 6.1: Close-up of the deep-groove baffle filters designed to capture grease.
6.2 Cleaning the Exterior:
- Wipe the stainless steel exterior with a soft cloth and a non-abrasive stainless steel cleaner.
- Avoid using harsh chemicals, abrasive pads, or steel wool, as these can scratch the surface.
6.3 Replacing LED Lamps:
- The range hood uses GU10 base LED lamps.
- To replace a bulb, ensure the power to the hood is off and the bulb has cooled.
- Gently twist and pull the old bulb out. Insert the new GU10 bulb by aligning the pins and twisting to secure.
- Replacement GU10 bulbs are readily available at most hardware stores.
Figure 6.2: Illustration of the replaceable GU10 LED light bulbs.
6.4 Ductless Filter Replacement (if applicable):
- If operating in ductless mode, the charcoal filters (sold separately) should be replaced every 3-6 months, depending on cooking frequency.
- Refer to the charcoal filter's specific instructions for replacement.
7. Troubleshooting
Before contacting customer support, please review the following common issues and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Range hood does not turn on. | No power supply. | Check circuit breaker or fuse box. Ensure the unit is properly plugged in. |
| Poor suction performance. | Clogged grease filters. | Clean or replace baffle filters (and charcoal filters if ductless). |
| Obstruction in ductwork (if ducted). | Inspect ductwork for blockages. | |
| Excessive noise during operation. | Loose components or improper installation. | Ensure all mounting screws are tight. Check for any loose parts or vibrations. |
| Motor issue. | Contact customer support for assistance. | |
| Lights not working. | Bulb failure. | Replace the GU10 LED lamp. |
| Wiring issue. | Consult a qualified electrician or customer support. |
8. Specifications
| Feature | Specification |
|---|---|
| Model | IN-R100SS-30 |
| Material | Stainless Steel |
| Mounting Type | Insert Mount |
| Product Dimensions (D x W x H) | 11.25" x 35.25" x 10" |
| Item Weight | 18.1 Pounds |
| Airflow Displacement | 600 Cubic Feet Per Minute (CFM) |
| Noise Level | 8.5 Sones |
| Controls Type | Push Button |
| Voltage | 120 Volts |
| Amperage | 1.8 Amps |
| Wattage | 300 Watts |
| Light Source Type | LED (GU10 base) |
| Filter Type | Baffle (Dishwasher-Safe) |
| Ventilation Type | Exhaust (Convertible to Ductless) |
| Certification | cETLus |
9. Warranty and Support
9.1 Warranty Information:
Hauslane offers a two-year limited warranty on the product and a lifetime warranty on the motors. This warranty covers defects in materials and workmanship under normal use. Please retain your proof of purchase for warranty claims.
9.2 Customer Support:
For technical assistance, warranty claims, or questions regarding your Hauslane range hood, please contact Hauslane customer support. Our US-based support team is available to assist you.
For the most current contact information, please visit the official Hauslane website or refer to the product packaging.
