i-box Dawn Clock Radio User Manual

Introduction

The i-box Dawn is a versatile bedside device combining a digital alarm clock, FM radio, Bluetooth wireless speaker, and integrated wireless charging pad with an additional USB charging port. This manual provides comprehensive instructions for setting up, operating, and maintaining your i-box Dawn.

Figure 1: i-box Dawn Clock Radio with a smartphone on its wireless charging pad.

Product Features

• QI Wireless Charging: Built-in pad compatible with all Qi-enabled phones for convenient, wire-free charging.
• USB Charging Port: An additional 1A USB port for charging other devices like a second phone or power bank.
• Dual Alarm Clock: Set two independent wake-up times, with options to wake to FM radio or a buzzer.
• Dimmable LED Display: 5-level brightness adjustment for the digital time display, including an 'off' setting.
• Bluetooth Speaker: Stream audio wirelessly from your smartphone or tablet.
• FM Radio: Digital FM tuner with up to 10 preset stations.
• Enhanced Sound: Features 6W stereo speakers and a passive subwoofer for improved audio quality.
• Sleek Design: Modern aesthetic with a soft-touch top face and fabric wrap surround.

Figure 2: Key features of the i-box Dawn, including wireless charging, Bluetooth, and dual alarms.

Setup

1. Power Connection

Connect the supplied power adapter to the DC 5V port on the back of the i-box Dawn and plug it into a wall outlet. The unit will power on and the display will illuminate.

For backup power during outages, insert 2 AAA batteries (not included) into the battery compartment on the bottom of the unit. This will maintain time and alarm settings.

2. Setting the Time

1. Press and hold the TIME SET button until the hour digits flash.
2. Use the + or - buttons (Volume Up/Down) to adjust the hour. Ensure AM/PM is correctly set if using 12-hour format.
3. Press TIME SET again to confirm the hour, then the minute digits will flash.
4. Use the + or - buttons to adjust the minutes.
5. Press TIME SET one more time to save the time.

To switch between 12-hour and 24-hour display formats, briefly press the 12/24HR button.

3. Setting Alarms (Alarm 1 and Alarm 2)

The i-box Dawn features two independent alarms. Follow these steps for each alarm:

1. Press and hold either ALARM 1 SET or ALARM 2 SET button until the hour digits flash.
2. Use the + or - buttons to adjust the alarm hour.
3. Press the respective ALARM SET button again to confirm the hour, then the minute digits will flash.
4. Use the + or - buttons to adjust the alarm minutes.
5. Press the respective ALARM SET button again to select the alarm source (FM radio or buzzer). Use + or - to toggle.
6. Press the respective ALARM SET button one more time to save the alarm setting.

To activate or deactivate an alarm, briefly press the ALARM 1 ON/OFF or ALARM 2 ON/OFF button. An alarm icon will appear on the display when active.

Figure 3: The dual alarm feature allows for two separate wake-up times.

4. FM Radio Setup

Extend the wire aerial on the back of the unit for optimal FM reception. To auto-scan and save stations:

1. Press the MODE button to switch to FM Radio mode.
2. Press and hold the PLAY/PAUSE/BT button (or the Play/Pause icon) to initiate an auto-scan. The radio will scan and save available FM stations to presets.
3. To manually tune, briefly press the PREVIOUS or NEXT buttons (Skip Back/Forward icons).
4. To recall a preset station, briefly press the PRESET button (M icon) and then use the PREVIOUS or NEXT buttons to navigate through saved stations.

5. Bluetooth Pairing

To use the i-box Dawn as a Bluetooth speaker:

1. Press the MODE button until "BT" appears on the display. The unit will enter pairing mode, indicated by a flashing "BT".
2. On your smartphone or tablet, enable Bluetooth and search for "i-box Dawn" in the list of available devices.
3. Select "i-box Dawn" to pair. Once connected, "BT" will stop flashing and a confirmation tone will sound.
4. You can now stream audio from your device to the i-box Dawn.

Figure 4: Stream your favorite music wirelessly via Bluetooth.

6. Wireless Charging (QI)

Place your Qi-enabled smartphone centrally on the wireless charging pad located on the top surface of the i-box Dawn. The charging indicator on your phone should activate. Ensure proper alignment for efficient charging.

Figure 5: Place your Qi-enabled phone on the top surface for wireless charging.

7. USB Charging

Connect your device's USB charging cable to the 1A USB port on the back of the i-box Dawn. This port provides power for charging a secondary device.

Figure 6: The USB port allows for charging an additional device.

Operating Instructions

1. General Controls Overview

The i-box Dawn features intuitive controls on its top panel. Refer to the diagram below for button identification and function:

Figure 7: Top and rear panel controls and ports.

• SNOOZE/SLEEP/DIMMER button: Briefly press to snooze an active alarm. Press repeatedly to cycle through display brightness levels. Press and hold to activate sleep timer.
• MODE button: Cycles through FM Radio, Bluetooth, and AUX modes.
• PLAY/PAUSE/BT button: Plays/pauses audio in Bluetooth/FM mode. Press and hold in FM mode to auto-scan.
• PREVIOUS/NEXT buttons: Skips tracks in Bluetooth mode, tunes stations in FM mode, or navigates presets.
• VOLUME + / - buttons: Adjusts audio volume. Also used for time/alarm setting adjustments.

2. Display Dimmer

The LED display has 5 brightness levels. Briefly press the SNOOZE/SLEEP/DIMMER button repeatedly to cycle through the brightness settings (Bright, Medium, Low, Dim, Off). This allows you to adjust the display to your preference, especially for nighttime use.

Figure 8: Adjust the display brightness to your comfort.

3. Alarm Management

When an alarm sounds, you have the following options:

• Snooze: Press the SNOOZE/SLEEP/DIMMER button to temporarily silence the alarm for 9 minutes. The alarm will sound again after this period.
• Stop Alarm: Press the respective ALARM ON/OFF button to turn off the alarm for the day. It will reactivate at the set time the next day.

4. Sleep Timer

To set a sleep timer that automatically turns off the audio after a set period:

1. While audio is playing (FM or Bluetooth), press and hold the SNOOZE/SLEEP/DIMMER button.
2. The display will show the sleep timer duration (e.g., "90"). Use the + or - buttons to adjust the timer (options typically include 15, 30, 45, 60, 75, 90 minutes, or OFF).
3. Release the button to confirm the setting. The audio will play for the selected duration and then automatically turn off.

5. Official Product Videos

For visual guidance on setup and features, please refer to the official product videos below:

Maintenance

• Cleaning: Use a soft, dry cloth to clean the surface of the unit. Do not use abrasive cleaners or solvents.
• Battery Replacement: If using backup batteries, replace them annually or when the display shows signs of dimming during power outages.
• Storage: If storing the unit for an extended period, disconnect it from power and remove any batteries. Store in a cool, dry place.

Troubleshooting

Specifications

Warranty and Support

The i-box Dawn comes with a 3-year warranty. For any support inquiries, please contact the i-box customer service team. As a proud British brand, i-box products are designed and developed within the UK, ensuring dedicated customer support.

For further assistance, please visit the official i-box store: i-box Store on Amazon.