Wagner Electro-Torch C900085 User Manual

1. Product Overview

The Wagner Electro-Torch C900085 is an electric fire starter designed to ignite charcoal, wood-burning fireplaces, campfires, and fire pits using super-heated air. This chemical-free method eliminates the need for matches or starter fluids, providing a clean and efficient way to start fires.

It features a dual ignition switch for precise control over the heating and fanning processes, allowing for rapid ignition and flame development.

Figure 1: The Wagner Electro-Torch C900085, a black and silver electric fire starter with a perforated metal barrel and a red power switch.

Figure 2: Diagram illustrating the internal airflow and heating element of the Electro-Torch, demonstrating how it generates super-heated air up to 1500°F.

2. Safety Information

Please read and understand all safety instructions before operating the Electro-Torch. Failure to follow these instructions may result in electric shock, fire, and/or serious injury.

• For Outdoor Use Only: When lighting charcoal or wood outdoors, ensure adequate ventilation.
• Indoor Use: When lighting wood in a fireplace or wood stove, ensure the chimney or flue is open and functioning correctly to prevent smoke and carbon monoxide buildup.
• Keep Away from Flammable Materials: Do not use near gasoline, paint thinners, or other highly flammable liquids or gases.
• Hot Air: The Electro-Torch produces air up to 1500°F (815°C). Do not touch the metal barrel during or immediately after use. Allow the unit to cool completely before handling or storing.
• Electrical Safety:
  • Always connect to a grounded outlet.
  • Do not operate with a damaged cord or plug.
  • Keep the power cord away from hot surfaces, sharp edges, and moving parts.
  • Do not expose to rain or wet conditions.
• Thermal Protection: The unit is equipped with an automatic thermal switch. If the unit reaches an excessively high temperature, it will shut off. Allow approximately 15-20 minutes for the unit to cool down before attempting to restart.
• Children and Pets: Keep the Electro-Torch out of reach of children and pets. Never leave the unit unattended while in operation.

3. Setup

The Wagner Electro-Torch C900085 requires minimal setup before use.

1. Unpack: Carefully remove the Electro-Torch from its packaging. Retain packaging for future storage or transport.
2. Inspect: Check the unit for any visible damage, especially the power cord and the metal barrel. Do not use if damaged.
3. Power Connection: Ensure the power cord is fully extended and plug it into a standard grounded electrical outlet. The unit operates on standard household current.

4. Operating Instructions

The Electro-Torch is designed for quick and efficient fire starting.

4.1 Lighting Charcoal

1. Prepare Charcoal: Arrange your charcoal briquettes or lump charcoal in a pile or pyramid in your grill or smoker.
2. Initial Ignition (Position 1): Hold the Electro-Torch with the metal barrel approximately 2-3 inches away from the charcoal. Press and hold the dual ignition switch to Position 1. This position generates super-heated air (up to 1500°F) to ignite the charcoal. You will see sparks and glowing embers within 30-60 seconds.
3. Fan the Flames (Position 2): Once embers are visible, switch to Position 2 while maintaining distance. This position produces high-velocity airflow to fan the flames and spread the heat. Continue fanning until the charcoal is fully ignited and covered in a light ash, typically within 2-3 minutes.
4. Remove and Cool: Release the switch to turn off the unit. Carefully place the Electro-Torch on a heat-resistant surface or hang it using its integrated hook. Allow the unit to cool completely before storing.

Figure 3: The Wagner Electro-Torch igniting charcoal in a grill, showing glowing embers and sparks, highlighting its chemical-free operation.

Figure 4: Close-up view of the Electro-Torch igniting charcoal briquettes in a grill, with visible flames and glowing coals.

4.2 Lighting Wood (Fireplaces, Campfires, Fire Pits)

1. Prepare Wood: Arrange kindling and logs in your fireplace, campfire, or fire pit.
2. Ignition: Point the metal barrel of the Electro-Torch at the kindling or a small log. Press and hold the dual ignition switch to Position 1. Maintain a safe distance while directing the hot air.
3. Fan the Fire: Once the wood begins to smoke and ignite, switch to Position 2 to increase airflow and help the fire grow. Continue until a sustained flame is achieved.
4. Re-igniting: If your fire or charcoal starts to burn down, add more wood or charcoal and use the Electro-Torch (Position 2 for fanning) to get it roaring again.

Figure 5: A collage of images demonstrating the versatility of the Electro-Torch, showing it in use for lighting campfires, wood stoves, fireplaces, and grills.

Figure 6: The Electro-Torch being used to light logs in a fireplace, demonstrating its application for indoor wood fires.

5. Maintenance

Proper maintenance ensures the longevity and safe operation of your Electro-Torch.

• Cleaning: Ensure the unit is unplugged and completely cool before cleaning. Wipe the exterior with a damp cloth. Do not use abrasive cleaners or immerse the unit in water.
• Storage: Store the Electro-Torch in a dry, safe place, away from extreme temperatures and moisture. Ensure the cord is neatly wrapped and not kinked.
• Inspection: Periodically inspect the power cord and plug for any signs of damage. If damage is found, discontinue use and contact customer service.

6. Troubleshooting

7. Specifications

• Model: C900085
• Brand: Wagner
• Color: Black
• Material: Metal
• Item Weight: 1.8 Pounds (approx. 0.82 kg)
• Product Dimensions: 4"L x 4.25"W x 19"H (approx. 10.16cm L x 10.8cm W x 48.26cm H)
• Maximum Temperature: 1500 Degrees Fahrenheit (approx. 815 Degrees Celsius)
• Power Source: Corded Electric
• Cord Length: 6 feet (approx. 1.83 meters)

8. Warranty and Customer Support

The Wagner Electro-Torch C900085 is backed by a 2-year warranty.

For any questions or assistance with your Electro-Torch, please contact our U.S. based customer service team. Refer to the product packaging or the official Wagner website for the most current contact information.