Introduction
Thank you for choosing Anmumu Keurig Coffee Filter Replacements. These filters are designed to provide highly efficient filtration for your Keurig coffee maker, ensuring a better-tasting coffee experience by reducing chlorine, taste, and odor. Made with food-grade coconut shell activated carbon, these filters help improve water quality and prolong the lifespan of your coffee machine.
A comprehensive view of the 24-pack of Keurig coffee filter replacements, showcasing the quantity and individual filter design.
Product Features
- Highly Efficient Filtration: Food-grade coconut shell carbon block filter with 0.5 micron small pore size effectively removes calcium, chlorine, bad odors, and harmful contaminants.
- Safety Micromesh Material: Certified to NSF 42 for the reduction of chlorine, taste, and odor by NSF International.
- Health & Eco-friendly Packing: Filters are individually wrapped to maintain freshness.
- High Compatibility: Compatible with a wide range of Keurig 1.0 and 2.0 brewers.
This diagram highlights the filter's effectiveness in removing various impurities from water, including chlorine, suspended heavy metals, odors, incrustation, and sand, ensuring cleaner water for brewing.
The NSF certification logo confirms that these filters have been tested and certified to NSF Standard 42, ensuring effective reduction of chlorine, taste, and odor in water.
This image illustrates that the filters are made from 100% coconut shell activated carbon, known for its large specific surface area and strong adsorptive capabilities, which contribute to superior filtration.
A visual comparison demonstrating the superior design of the Dr.Water Filter, which contains more activated charcoal and features a special micromesh skin with ultra-fine-grain charcoal for enhanced filtration and better coffee taste.
Compatibility
These Dr.Water Filters are compatible with a wide range of Keurig Coffee Brewers, including both 1.0 and 2.0 models. Compatible models include, but are not limited to:
- Keurig 1.0 Models: B10, K10, B30, B31, B40, B44, K45, B50, K55, B60, K65, B66, B70, K75, B77, B79, B100, B130, B135, B140, B145, K145, B150, B200, K155, B1250, B1255, B3000, K15, K40, K50, K60, K70, K79, K130, K140, K150, B65, B71, B76, B155.
- Keurig 2.0 Models: K200, K250, K300, K350, K360, K400, K450, K460, K500, K550, K560, K575, K425, K475.
Setup & Installation
Follow these steps to install your new Anmumu Keurig Coffee Filter:
- Prepare the Filter: Remove the filter from its individual packaging. Soak the new filter in clean water for approximately 5 minutes. This helps to remove any carbon dust and prepares the filter for optimal performance.
- Rinse: Rinse the filter under running cold water for 30 seconds.
- Insert into Holder: Open your Keurig coffee maker's water reservoir and locate the filter holder. If there's an old filter, remove and discard it. Insert the new filter into the filter holder, ensuring it snaps securely into place.
- Place Holder in Reservoir: Place the filter holder with the new filter back into the water reservoir. Ensure it is seated correctly at the bottom of the reservoir.
- Fill Reservoir: Fill the water reservoir with fresh water.
- Initial Rinse Cycle: Before brewing coffee, run at least two full water-only cycles through your Keurig machine without a K-Cup. This primes the filter and flushes out any remaining carbon particles.
Maintenance & Replacement
For best filtration results and to maintain the quality of your coffee, it is suggested to replace the filter every 30 days or after 30 tank refills, whichever comes first. Regular replacement ensures consistent water quality and extends the life of your coffee machine.
To replace the filter, simply follow the 'Setup & Installation' steps, starting from preparing the new filter and replacing the old one.
Troubleshooting
- Slow Water Flow: If you notice a slower water flow, the filter might be clogged. Ensure the filter is properly seated, or it may be time for a replacement.
- Unusual Taste/Odor: If your coffee has an unusual taste or odor, the filter may be exhausted. Replace the filter immediately.
- Filter Not Fitting: Double-check that your Keurig model is listed in the compatibility section. Ensure the filter is oriented correctly in the filter holder.
Specifications
| Attribute | Detail |
|---|---|
| Brand | Anmumu |
| Material | Activated Charcoal (100% Coconut Shell) |
| Shape | Basket |
| Number of Pieces | 24 |
| Unit Count | 24 Count |
| Product Dimensions | 2 x 1.25 x 1.25 inches |
| Item Weight | 13.4 ounces |
| Manufacturer | DR.Water Filter |
| Model Number | model-g-203 |
Warranty & Customer Support
Dr.Water Filter offers an unconditional 30-day money-back guarantee. Your purchase is backed by our exclusive 1-year and 30-day money-back policy. If you are not completely satisfied with the product, you are entitled to a total refund.
Our professional customer service team is available to assist you with any questions or concerns. Please refer to your purchase platform for contact information or visit the Anmumu Store for more details.