Introduction
This manual provides instructions for the Redi-Remote replacement remote control, designed for use with Polk RE9520-1 and DSB1 soundbar models. This remote is a custom replacement and is not an original Polk product. It is pre-programmed and requires no additional setup for compatible devices.
Setup
1. Battery Installation
The remote requires 4 AAA batteries for operation. Batteries may already be installed upon receipt. If not, follow these steps:
- Locate the battery compartment cover on the back of the remote control.
- Slide the cover downwards or press the latch and lift to open.
- Insert 4 AAA batteries, ensuring the positive (+) and negative (-) terminals align correctly with the markings inside the compartment.
- Replace the battery compartment cover by sliding it back into place until it clicks securely.
Image 1: Redi-Remote replacement remote control. This image shows the front of the remote, highlighting its button layout and overall design.
2. Initial Use
This Redi-Remote is pre-programmed for the Polk RE9520-1 and DSB1 models. No additional programming or setup is required. Once batteries are installed, the remote is ready for immediate use with your compatible Polk soundbar.
Operating Instructions
Point the remote control directly at your Polk soundbar. Ensure there are no obstructions between the remote and the soundbar's infrared receiver.
Key Functions
- Power Button: Turns the soundbar on or off.
- Volume Up/Down: Adjusts the soundbar's volume level.
- Mute Button: Mutes or unmutes the soundbar's audio output.
- Input/Source Selection: Cycles through available audio input sources (e.g., Optical, Bluetooth, AUX).
- Bass/Treble Controls: Adjusts bass and treble levels (if supported by the soundbar).
- Sliding Cover: The lower half of the remote features a sliding cover. Slide this cover down to reveal additional buttons for advanced functions specific to your Polk soundbar model.
For specific button functionalities, refer to your Polk soundbar's original user manual.
Maintenance
Battery Replacement
Replace batteries when the remote's response becomes sluggish or stops working. Always replace all 4 AAA batteries at the same time with new ones. Do not mix old and new batteries, or different types of batteries.
Cleaning
To clean the remote, gently wipe it with a soft, dry cloth. Do not use liquid cleaners, abrasive pads, or chemical solvents, as these can damage the remote's surface or internal components.
Storage
Store the remote in a cool, dry place away from direct sunlight and extreme temperatures. If the remote will not be used for an extended period, it is recommended to remove the batteries to prevent leakage.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Remote not responding. |
|
|
| Some buttons not working. |
|
|
| Remote feels unresponsive. |
|
|
Specifications
| Model Number | RTRE95201 |
| Compatible Polk Models | RE9520-1, DSB1 |
| Dimensions (L x W x H) | 7.5" x 2.25" x 0.75" (19.05 cm x 5.72 cm x 1.91 cm) |
| Item Weight | 5 ounces |
| Batteries Required | 4 x AAA (not included, or may be pre-installed) |
| Special Feature | No Programming Required |
| Color | Black |
| Max Number of Supported Devices | 1 |
Support and Warranty
For any concerns or issues with your Redi-Remote replacement remote control, please contact the seller directly for assistance. This remote is designed to be compatible with the specified Polk models and is backed by the seller's support.
Information regarding specific warranty terms should be obtained from the point of purchase or the seller.