1. Introduction
This manual provides essential information for the assembly, setup, operation, and maintenance of your POLYWOOD® La Casa Café 5-Piece Composite Patio Furniture Set. This classic set is designed to comfortably seat up to four guests for a relaxed outdoor dining experience, featuring contoured chairs and a spacious dining table.
Image: The POLYWOOD® La Casa Café 5-Piece Composite Patio Furniture Set, featuring a square dining table and four chairs, all in a teak finish. The set is designed for outdoor dining and relaxation.
2. Safety Information
Please read all safety warnings and instructions carefully before assembling or using this product. Failure to follow these instructions may result in injury or damage to the product.
- Exercise caution around sharp edges during assembly.
- Keep the furniture set away from direct heat sources to prevent material damage.
- This product is not intended for use by children under 3 years due to the presence of small parts.
- Always assemble and use the product strictly according to the provided instructions.
- Ensure all fasteners are securely tightened before use and periodically check for looseness.
3. Package Contents
Verify that all components listed below are present in your package before beginning assembly. If any parts are missing or damaged, please contact Polywood customer support.
- (2) La Casa Café Dining Side Chairs
- (2) La Casa Café Dining Arm Chairs
- (1) Farmhouse 37" Dining Table
- Assembly Hardware (bolts, nuts, washers, etc.)
- Assembly Tools (e.g., Allen wrench, if included)
4. Assembly Instructions
Assembly typically requires two adults. Lay out all components on a soft, clean surface to prevent scratching. Do not fully tighten bolts until all components are loosely assembled.
- Unpack Components: Carefully remove all parts from the packaging and identify each component against the package contents list.
- Assemble Chairs:
- Attach chair legs to the seat frame using the provided hardware.
- Secure the backrest to the seat frame and legs.
- For arm chairs, attach the armrests.
- Once all parts are aligned, gradually tighten all bolts until secure.
- Assemble Table:
- Attach table legs to the tabletop frame.
- Ensure the table is stable and level before fully tightening all bolts.
- Final Inspection: After assembly, ensure all bolts are fully tightened and the furniture is stable and level.
5. Setup
Once assembled, place your POLYWOOD® patio furniture set on a flat, stable surface. While POLYWOOD® lumber is designed to withstand various climates, consider placement that optimizes comfort and usability for your outdoor space.
- Choose a level area on your patio, deck, or lawn.
- Ensure adequate space around the table and chairs for comfortable movement.
- Avoid placing directly under heavy objects that could fall.
6. Operating Instructions
The POLYWOOD® La Casa Café Dining Set is designed for outdoor dining and relaxation. Simply arrange the chairs around the table as desired. The contoured seats and backs of the chairs provide comfort for extended use.
- Use the table for dining, holding beverages, or other outdoor activities.
- Chairs are suitable for seating one person each.
- Do not stand on the furniture or use it for purposes other than its intended design.
7. Maintenance
POLYWOOD® lumber is exceptionally durable and low-maintenance. Regular cleaning will help maintain its appearance.
- Routine Cleaning: Wipe with a dry cloth to remove dust and light debris.
- For deeper cleaning, wash with soap and water. For stubborn dirt or stains, a 1/3 bleach and 2/3 water solution can be used. A high-pressure washer (not exceeding 1,500 psi) can also be used with caution.
- Avoid abrasive cleaners or scrubbing pads, as these can damage the surface.
- No painting, staining, or waterproofing is required.
8. Troubleshooting
Most issues can be resolved with simple checks. If you encounter problems not addressed here, please contact Polywood customer support.
| Problem | Possible Cause | Solution |
|---|---|---|
| Furniture is wobbly after assembly. | Bolts not fully tightened or uneven surface. | Ensure all bolts are securely tightened. Move furniture to a level surface. |
| Difficulty aligning parts during assembly. | Parts are not oriented correctly or bolts are overtightened prematurely. | Loosen all bolts, re-align parts, then gradually tighten. Refer to assembly diagrams if available. |
| Surface appears dirty or stained. | Accumulation of dirt, pollen, or environmental stains. | Clean with soap and water. For stubborn stains, use a bleach solution as described in the Maintenance section. |
9. Specifications
| Attribute | Detail |
|---|---|
| Model Number | B07K7THZ27 |
| Brand | Polywood |
| Material | High Density Polyethylene |
| Color | Teak |
| Product Dimensions (L x W x H) | 101 x 104 x 34 inches |
| Item Weight | 121 pounds |
| UPC | 190609083488 |
| Manufacturer | Poly-Wood, LLC |
| Product Care Instructions | Wipe with Dry Cloth (for routine cleaning, see Maintenance section for detailed care) |
10. Warranty and Support
POLYWOOD® stands behind the quality of its products.
- Residential Warranty: This product is covered by a 20-year residential warranty.
- Commercial Warranty: This product is covered by a 3-year commercial warranty.
- These warranties cover defects in material and workmanship. For full warranty details, please refer to the official Polywood website or contact their customer service.
For further assistance, missing parts, or warranty claims, please contact Polywood customer support directly. You can typically find their contact information on their official website or through the retailer where you purchased the product.
Polywood Official Store: Visit the Polywood Store on Amazon
