Introduction
This manual provides essential instructions for the proper setup, operation, and maintenance of your Samsung OEM remote control. This remote is designed for use with Samsung soundbar models HW-JM4000C, HWK460, and HW-K460. Please read this manual thoroughly before using the remote control to ensure optimal performance and longevity.
Package Contents
Verify that your package contains the following items:
- Samsung Remote Control (Model: HW-JM4000C, HWK460, HW-K460 compatible)
- Note: Batteries are not included and must be purchased separately.
Image: Front view of the Samsung OEM Remote Control. The remote is black with various control buttons for power, volume, source selection, and playback. It has an ergonomic design.
Setup
1. Battery Installation
The remote control requires one CR2032 3V coin cell battery (not included).
- Locate the battery compartment on the back of the remote control.
- Open the battery compartment cover by sliding or pressing the latch as indicated.
- Insert one CR2032 3V battery with the positive (+) side facing upwards, as shown in the diagram (refer to the remote's physical markings if no diagram is available).
- Close the battery compartment cover securely until it clicks into place.
2. Initial Connection
This is an OEM (Original Equipment Manufacturer) remote control. It is designed to work directly with compatible Samsung soundbar models (HW-JM4000C, HWK460, HW-K460) without requiring any special pairing procedures. Once the battery is installed, point the remote control towards your soundbar and test its functions.
Operating Instructions
Familiarize yourself with the buttons on your remote control:
- POWER: Turns the soundbar on or off.
- VOLUME (+/-): Increases or decreases the soundbar's volume.
- MUTE: Mutes or unmutes the soundbar's audio output.
- SOURCE: Cycles through available input sources (e.g., HDMI, Optical, Bluetooth).
- SOUND MODE: Selects different sound effects or modes (e.g., Standard, Music, Movie).
- WOOFER (+/-): Adjusts the subwoofer level.
- PLAY/PAUSE: Controls playback for connected media devices.
- SKIP (Forward/Backward): Skips tracks for connected media devices.
Ensure there is a clear line of sight between the remote control and the soundbar's infrared (IR) receiver for proper operation.
Maintenance
Battery Replacement
Replace the CR2032 3V battery when the remote control's range decreases or it stops responding. Follow the battery installation steps outlined in the "Setup" section.
Cleaning
Wipe the remote control with a soft, dry cloth. Do not use liquid cleaners or abrasive materials, as these may damage the surface or internal components.
Storage
If the remote control will not be used for an extended period, remove the battery to prevent leakage and potential damage.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Remote control does not work. |
|
|
| Remote control works intermittently. |
|
|
Specifications
| Brand | Samsung |
| Model Numbers | HW-JM4000C, HWK460, HW-K460 |
| Compatible Devices | Samsung Home Theater Systems (specifically soundbars HW-JM4000C, HWK460, HW-K460) |
| Color | Black |
| Special Feature | Ergonomic design |
| Max Number of Supported Devices | 1 |
| Item Weight | 2.57 ounces |
| Package Dimensions | 6.66 x 2.48 x 1.65 inches |
| Battery Type (Not Included) | CR2032 3V Coin Cell |
Warranty Information
Specific warranty details for this OEM remote control may vary. Please refer to the warranty documentation provided with your original Samsung soundbar or contact Samsung customer support directly for current warranty terms and conditions.
Support
For further assistance, technical support, or service inquiries, please visit the official Samsung website or contact Samsung customer support. Contact information can typically be found on the Samsung website or in the documentation that came with your soundbar.
Samsung Official Website: www.samsung.com
