Edison Professional EP-360
Edison Professional EP-360 Portable Speaker System User Manual
High Power Portable System with LED Lighting
Introduction
The Edison Professional EP-360 is a high-quality portable Bluetooth speaker system designed for powerful audio output and vibrant LED lighting. It features dual 10-inch woofers, a long-lasting rechargeable battery, and a retractable handle with wheels for easy portability. This manual provides essential information for setting up, operating, and maintaining your EP-360 system.
Figure 1: Edison Professional EP-360 Portable Speaker System. This image displays the front view of the black speaker unit, highlighting its two large illuminated woofers with purple and white LED lighting behind a protective mesh grille. A retractable handle is visible at the top.
What's in the Box
Please check the contents of your package to ensure all items are present:
- Edison Professional EP-360 Speaker Unit
- Microphone
- Remote Control
- AC Power Cord
- User Manual (this document)
Setup
1. Initial Charging
Before first use, fully charge the EP-360's internal battery. Connect the supplied AC power cord to the speaker's power input and then to a standard wall outlet. The charging indicator light will illuminate. Allow approximately 6-8 hours for a full charge. The unit can be used while charging.
2. Positioning the Speaker
Place the speaker on a stable, flat surface. For optimal sound dispersion, position it in an open area, away from walls or corners that might obstruct audio. The EP-360 is designed for floor standing use.
3. Retractable Handle and Wheels
To transport the speaker, extend the retractable handle by pressing the release button (if present) and pulling the handle upwards. Tilt the speaker back onto its wheels and roll it to your desired location. Push the handle back down until it locks into place for storage or stationary use.
4. Connecting the Microphone
Locate the microphone input jack on the speaker's control panel. Insert the microphone cable securely into this jack. Ensure the microphone's power switch (if applicable) is in the 'ON' position when in use.
Operating Instructions
1. Powering On/Off
Press and hold the POWER button on the control panel or remote control to turn the speaker on or off. A power indicator light will confirm the unit's status.
2. Bluetooth Pairing
- Turn on the EP-360 speaker. It will automatically enter Bluetooth pairing mode, indicated by a flashing Bluetooth indicator light.
- On your mobile device (smartphone, tablet, etc.), enable Bluetooth and search for available devices.
- Select "EP-360" from the list of devices.
- Once paired, the Bluetooth indicator light will become solid, and you will hear a confirmation tone.
- You can now play audio from your device through the EP-360 speaker.
3. Volume Control
Adjust the master volume using the VOLUME knob on the control panel or the volume buttons on the remote control. For microphone volume, use the dedicated MIC VOL knob.
4. LED Lighting Control
The EP-360 features integrated LED lighting on its woofers. Use the LIGHT button on the control panel or remote to cycle through different lighting modes or to turn the lights off.
5. Using the Microphone
After connecting the microphone, ensure its volume is adjusted appropriately using the MIC VOL knob. Speak directly into the microphone for clear audio output through the speaker.
Maintenance
1. Cleaning
Wipe the exterior of the speaker with a soft, dry cloth. Do not use abrasive cleaners, waxes, or solvents. Avoid spraying liquids directly onto the speaker.
2. Battery Care
- To prolong battery life, avoid fully discharging the battery frequently.
- Recharge the battery regularly, even if the speaker is not in frequent use.
- Store the speaker in a cool, dry place when not in use for extended periods.
3. Storage
When storing the speaker, ensure the retractable handle is fully retracted. Keep the unit in a dry environment, away from extreme temperatures and direct sunlight.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| No power | Battery is depleted; Power cord not connected; Unit is off. | Charge the battery; Ensure AC power cord is securely connected; Press the POWER button to turn on. |
| No sound | Volume too low; Device not paired; Incorrect input source. | Increase master volume; Re-pair Bluetooth device; Ensure correct input mode is selected. |
| Bluetooth connection unstable or fails | Device too far; Interference; Speaker not in pairing mode. | Move device closer to speaker (within 30 ft); Avoid obstacles; Ensure speaker is in pairing mode. |
| Microphone not working | Microphone not connected; MIC VOL too low; Microphone switch off. | Ensure microphone is securely plugged in; Increase MIC VOL; Turn on microphone switch. |
Specifications
| Model Name | EP-360 |
| Speaker Type | Woofer (Dual 10-inch) |
| Connectivity Technology | Bluetooth |
| Power Source | Battery Powered / AC |
| Control Method | Touch / Remote |
| Product Dimensions | 14 x 13.8 x 28 inches |
| Item Weight | 28 pounds |
| Included Components | Speaker, Microphone, Remote, AC power cord, Manual |
| Special Features | LED Lighting, Retractable Handle, Wheels |
Warranty and Support
For warranty information or technical support, please refer to the warranty card included with your product or visit the official Edison Professional website. Contact details for customer service are typically provided on the manufacturer's website or in the product packaging.
Note: Specific warranty terms and support availability may vary by region and purchase date.
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.