Energizer T12B AGM Motorcycle 12V Battery Instruction Manual

1. Introduction

This manual provides essential information for the safe and effective use of your Energizer T12B AGM Motorcycle 12V Battery. This battery is designed to provide reliable power for high-performance engines in various powersport applications.

The Energizer T12B battery utilizes Absorbent Glass Mat (AGM) technology, making it non-spillable, maintenance-free, and ready for immediate installation without the need for initial charging or acid filling.

2. Safety Information

WARNING: Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.

• Always wear appropriate personal protective equipment, including safety glasses and gloves, when handling batteries.
• Keep batteries away from open flames, sparks, and other ignition sources. Batteries can produce explosive gases.
• Do not attempt to open, disassemble, or modify the battery. Internal components are hazardous.
• Avoid short-circuiting battery terminals.
• Keep out of reach of children.
• In case of accidental contact with internal battery content, wash the affected area of skin and contact a doctor for further medical assistance.

3. Setup and Installation

The Energizer T12B AGM battery comes factory-charged, sealed, and ready to install. No initial charging or acid handling is required.

3.1. Removing the Old Battery

1. Ensure the vehicle's ignition is off.
2. Locate the battery compartment, typically under the seat. Remove any covers or seats as necessary.
3. Disconnect the negative (-) terminal first to prevent accidental short circuits. Use an appropriate wrench or screwdriver.
4. Disconnect the positive (+) terminal.
5. Carefully remove the old battery from its compartment.

3.2. Installing the New Battery

1. Place the new Energizer T12B battery into the battery compartment. Ensure it fits securely.
2. Connect the positive (+) terminal first. Secure the red cable to the positive terminal.
3. Connect the negative (-) terminal. Secure the black cable to the negative terminal.
4. Ensure all connections are tight and secure.
5. Replace any covers or seats removed earlier.

4. Operating Instructions

Your Energizer T12B AGM battery is designed for immediate use upon proper installation. It provides strong, reliable power for starting high-performance engines.

• Ensure all electrical connections are secure before operating your vehicle.
• The battery is designed to be repeatedly charged and discharged by your vehicle's charging system without affecting performance.

5. Maintenance

The Energizer T12B AGM battery is a maintenance-free unit. This means:

• No topping off with water or acid is necessary.
• The battery is permanently sealed at the factory.
• Regularly inspect battery terminals and cables for corrosion or loose connections. Clean as needed.
• If the vehicle is stored for extended periods, consider using a compatible battery tender to maintain optimal charge.

5.1. Battery Recycling

Proper recycling of used batteries is crucial for environmental protection. Visit recycling my battery for information on where to recycle your used battery.

6. Specifications

7. Product Images

8. Warranty and Support

For warranty information and customer support, please refer to the official Energizer website or contact your retailer. You can also visit the Energizer Store on Amazon for additional resources.