Introduction
This manual provides detailed instructions for the Fastrack Analog-Digital Watch, model NM38035SP01. Please read this manual carefully to understand the functions and proper operation of your watch. Keep this manual for future reference.
Key Features
- Analog-Digital Fusion: Dual-time display offering both traditional analog hands and digital formats.
- Adventure-Ready Strap: Durable green silicone strap designed for various environments.
- Multi-Function Features: Includes date, day, stopwatch, and alarm for enhanced utility.
- Bold Grey Dial: Layered dial design with high-contrast elements for clear visibility.
- 50M Water Resistance: Designed to withstand splashes, rain, and brief immersion.
Setup
1. Initial Time Setting (Analog)
- Pull the crown (button on the right side of the watch case) out to the first click position.
- Rotate the crown to set the hour and minute hands to the correct time.
- Push the crown back in to its normal position to start the analog timekeeping.
2. Digital Time and Date Setting
Refer to the specific button functions for your model. Typically, a "Mode" button cycles through functions, and "Adjust" or "Set" buttons are used to change values.
- Press the Mode button until the digital time display flashes.
- Use the Adjust or Set button to change the flashing digits (hours, minutes, seconds).
- Press Mode again to move to the next setting (e.g., date, month, day).
- Once all settings are correct, press Mode or Reset to exit the setting mode.
Image: Front view of the Fastrack Analog-Digital Watch, showing the grey dial and green strap.
Operating Instructions
1. Switching Between Modes
Press the Mode button (usually located on the bottom left) to cycle through the digital functions: Timekeeping, Stopwatch, Alarm, and Date Display.
2. Using the Stopwatch
- Enter Stopwatch mode by pressing the Mode button.
- Press the Start/Stop button (usually top right) to begin timing.
- Press Start/Stop again to pause/resume.
- Press the Reset button (usually bottom right) to clear the stopwatch to zero.
3. Setting the Alarm
- Enter Alarm mode by pressing the Mode button.
- Press the Adjust or Set button to make the alarm time digits flash.
- Use the Start/Stop button to change the flashing digits.
- Press Mode to confirm and exit alarm setting.
- To turn the alarm on/off, typically press Start/Stop while in Alarm mode.
4. Using the Backlight
Press the Light button (usually top left) to illuminate the digital display for a few seconds in low-light conditions.
Maintenance
1. Water Resistance
This watch is rated for 50 meters (5 ATM) water resistance. This means it is suitable for everyday use, splashes, rain, and brief immersion in water. It is not suitable for swimming, diving, or prolonged water activities. Do not operate buttons while the watch is wet or submerged.
2. Cleaning Your Watch
- Wipe the watch case and strap with a soft, dry cloth.
- For stubborn dirt, use a slightly damp cloth and mild soap, then wipe dry immediately.
- Avoid using chemical cleaners, solvents, or abrasive materials, as these can damage the watch's finish.
3. Battery Replacement
The watch uses 1 Lithium Metal battery. When the digital display fades or the watch stops functioning, the battery may need replacement. It is recommended to have the battery replaced by an authorized service center to ensure water resistance integrity.
Image: Back view of the Fastrack Analog-Digital Watch, highlighting the green silicone strap and buckle.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Analog hands not moving | Dead battery (analog movement) or crown is pulled out. | Push the crown in. If still not moving, replace the battery. |
| Digital display is blank or dim | Dead battery (digital module). | Replace the battery. |
| Incorrect digital time/date | Time/date not set correctly. | Follow the "Digital Time and Date Setting" instructions. |
| Water inside the watch | Buttons operated underwater or watch exposed to high pressure water. | Immediately take the watch to an authorized service center. Do not attempt to open it yourself. |
Specifications
- Model Number: NT38035SP01 (also referred to as NM38035SP01/NN38035SP01)
- ASIN: B079H8YJTH
- Movement: Analog-Digital Quartz
- Water Resistance: 50 Meters (5 ATM)
- Battery Type: 1 Lithium Metal battery (included)
- Case Material: (Not specified, assuming standard watch case material)
- Strap Material: Silicone
- Item Weight: 216 g
- Package Dimensions: 7.8 x 7.6 x 7.6 cm
- Manufacturer: Titan Company Limited
- Country of Origin: India
Warranty Information
Fastrack watches typically come with a manufacturer's warranty covering manufacturing defects. Please refer to the warranty card included with your purchase for specific terms, conditions, and duration. Keep your purchase receipt as proof of purchase for warranty claims.
An optional 1-Year Extended Warranty Plan by Onsitego may be available for purchase separately. This plan is not part of the standard manufacturer's warranty.
Customer Support
For any queries, service requests, or technical assistance, please contact Fastrack customer support or visit an authorized Fastrack service center. Contact details can usually be found on the official Fastrack website or on your warranty card.
Manufacturer: Titan Company Limited, Sipcot Industrial Complex, Hosur, Tamil Nadu - 635129, India.
You can also visit the Fastrack Store on Amazon for more product information.
