Introduction
This manual provides detailed instructions for the setup, operation, and maintenance of your Armitron Sport Digital Chronograph Watch, model 40/8423. This watch features a digital display with multiple functions including time, date, chronograph, lap time, alarm, military time, and backlight.

Image: Front view of the Armitron Sport Digital Chronograph Watch, model 40/8423, in Navy Blue/Grey. The digital display shows "10:10" and "00" seconds, with buttons labeled SET/EL, MODE, START/PAUSE, and ADJ around the bezel.
Button Functions
Familiarize yourself with the watch buttons:
- SET/EL (Top Left): Used to enter setting modes and activate the electroluminescent backlight.
- MODE (Bottom Left): Cycles through different watch modes (Time, Chronograph, Alarm).
- START/PAUSE (Top Right): Used to start/stop functions in chronograph mode and adjust values in setting modes.
- ADJ (Bottom Right): Used to adjust values in setting modes and reset functions.
Setup: Setting Time and Date
Follow these steps to set the time and date on your watch:
- From the normal time display, press the MODE button repeatedly until the seconds begin to flash. This indicates you are in time setting mode.
- Press the ADJ button to reset the seconds to zero. If the seconds are reset when the value is between 30 and 59, the minutes will advance by one. If reset when between 00 and 29, the minutes remain unchanged.
- Press the START/PAUSE button to move the flashing selection to the minutes.
- Press the ADJ button to adjust the minutes.
- Press the START/PAUSE button to move the flashing selection to the hour.
- Press the ADJ button to adjust the hour. Note the 'A' or 'P' indicator for AM/PM, or 'H' for 24-hour (military) format.
- Continue pressing START/PAUSE to cycle through setting the year, month, and day. Use the ADJ button to change the values for each.
- Once all settings are correct, press the MODE button to exit the setting mode and return to the normal time display.
Tip: It is recommended to keep these instructions handy for future adjustments, as the setting process can be intricate.
Operating Modes
Your watch offers several operational modes. Press the MODE button to cycle through them:
- Time Display: Shows current time (hours, minutes, seconds), day of the week, and date. Press SET/EL to activate the backlight for approximately 3 seconds.
- Chronograph (Stopwatch):
- Press MODE until "CHRONO" or a similar indicator appears.
- Press START/PAUSE to begin timing.
- Press START/PAUSE again to pause timing.
- Press ADJ to reset the chronograph to zero while paused.
- To record lap times, press ADJ while the chronograph is running. The lap time will display briefly, and the main chronograph will continue running in the background.
- Alarm:
- Press MODE until "ALARM" or a bell icon appears.
- Press SET/EL to enter alarm setting mode (hour will flash).
- Use ADJ to set the hour, then START/PAUSE to move to minutes.
- Use ADJ to set the minutes.
- Press SET/EL to confirm and exit.
- To turn the alarm ON/OFF, press ADJ in the alarm display mode (without flashing). An alarm icon will appear when active.
- Military Time (24-Hour Format): The watch supports both 12-hour (AM/PM) and 24-hour (military) time formats. This setting is typically adjusted during the initial time setup. When setting the hour, repeatedly press ADJ to cycle between 12-hour and 24-hour formats.
- Backlight: Press the SET/EL button at any time to illuminate the display for approximately 3 seconds.
Maintenance
Water Resistance
Your Armitron Sport watch is water resistant to 165 feet (50 meters). This means it is suitable for short periods of recreational swimming, but not for diving or snorkeling. Avoid pressing buttons underwater, as this can compromise the water resistance.
Battery Replacement
The watch uses 1 Lithium Metal battery (included). When the display becomes dim or functions become erratic, the battery may need replacement. Battery replacement should ideally be performed by a qualified watch technician to ensure proper sealing and maintain water resistance.
Cleaning
Clean your watch with a soft, damp cloth. Avoid using harsh chemicals or abrasive materials, which can damage the case or strap.
Troubleshooting
| Problem | Possible Cause / Solution |
|---|---|
| Display is dim or difficult to read. |
|
| Difficulty setting time/date. |
|
| Watch is not functioning. |
|
Specifications
- Model Number: 40/8423NVY
- Movement: Quartz
- Display: Digital Multifunctional, Reverse LCD
- Case Material: Resin
- Lens Material: Glass Crystal
- Strap Material: Silicone (Navy Blue and Light Grey double injected perforated)
- Case Diameter: 43.5mm
- Water Resistance: 165 feet (50M)
- Functions: Date, Chronograph, Lap Time, Alarm, Military Time, Backlight with three-second delay
- Battery: 1 Lithium Metal (included)
- Product Dimensions: 5 x 5 x 0.7 inches
- Item Weight: 1.6 ounces
Warranty and Support
For warranty information or further support, please refer to the official Armitron website or contact Armitron customer service. Keep your purchase receipt as proof of purchase.
You can visit the official Armitron store for more products and support: Armitron Store on Amazon.





