Blum 38C315B3 Motion 86 Degree Angle Restriction Hinge Clip User Manual

Introduction

The Blum 38C315B3 Motion 86 Degree Angle Restriction Hinge Clip is designed to limit the opening angle of cabinet doors to 86 degrees. This prevents doors from hitting adjacent walls, appliances, or other cabinets, protecting both the door and surrounding structures from damage. This clip is made from durable nylon and is intended for use with compatible Blum hinges.

Image: The Blum 38C315B3 Motion 86 Degree Angle Restriction Hinge Clip.

Setup and Installation

Installation of the Blum 38C315B3 hinge clip is a straightforward process. Only a screwdriver is required. It is recommended to install one hinge clip at a time to maintain door alignment.

Tools Required:

• Phillips Head Screwdriver
• Step stool (if needed for reaching upper cabinets)

Installation Steps:

1. Identify the Hinge: Locate the cabinet hinge where the restriction clip will be installed.
2. Remove the Middle Screw: Using a Phillips head screwdriver, carefully unscrew and remove the single middle screw that attaches the hinge to the cabinet frame. This screw is typically located on the part of the hinge connected to the cabinet box, not the door.
3. Open the Hinge Mechanism: Gently open the hinge mechanism to expose the internal groove where the restriction clip will sit. This groove is usually a small, curved channel within the hinge body.
4. Orient the Clip: Hold the small nylon restriction clip. Ensure the small hook or curved part of the clip is oriented towards the right (or the direction that will restrict the door's outward swing).
5. Insert the Clip: Carefully insert the restriction clip into the exposed groove of the hinge. Push it in as far as it will go, ensuring it is seated correctly. The clip does not typically 'snap' into place but rather rests securely within the groove.
6. Close the Hinge: Slowly close the hinge mechanism over the inserted clip. This action will secure the clip in its position.
7. Re-insert and Tighten Screw: Re-insert the middle screw that was previously removed and tighten it securely. Do not overtighten.
8. Test the Door: Gently open and close the cabinet door to verify that the restriction clip is functioning correctly and limiting the door's opening angle to approximately 86 degrees.
9. Repeat for Additional Hinges: If your cabinet door has multiple hinges, repeat these steps for each hinge where angle restriction is desired. For optimal performance and stability, it is often recommended to install a clip on both the top and bottom hinges.

Operation

Once installed, the Blum 38C315B3 Motion 86 Degree Angle Restriction Hinge Clip operates passively. It automatically limits the cabinet door's opening angle, preventing it from swinging beyond 86 degrees. No further user interaction is required for its function.

Maintenance

The Blum 38C315B3 hinge clip requires minimal maintenance. Periodically inspect the clips to ensure they remain securely in place within the hinges. If cleaning is necessary, wipe the clips and hinges with a soft, damp cloth. Avoid using harsh chemicals or abrasive cleaners, as these may damage the nylon material or the hinge finish.

Troubleshooting

• Door opens too wide: Ensure the restriction clip is fully seated in the hinge's groove and that the middle screw is tightened. Re-open the hinge, re-seat the clip, and re-tighten the screw if necessary.
• Door does not open enough: Verify that the clip is correctly oriented and not obstructing the hinge mechanism more than intended. If the clip is installed incorrectly, remove it and re-install following the steps above.
• Clip falls out: The clip may not be fully seated or the hinge mechanism might not be closing properly over it. Re-check installation.

Specifications

Warranty and Support

This product is covered by the manufacturer's standard warranty. For specific warranty details, claims, or technical support, please refer to the official Blum website or contact their customer service directly. Keep your purchase receipt for warranty purposes.