Legami Micro Night Dream LED Glasses Light Instruction Manual

Introduction

Welcome to the Legami Micro Night Dream LED Glasses Light. This compact and versatile light is designed to clip onto your glasses, providing convenient illumination for various tasks such as reading, crafting, or working in low-light conditions. Please read this manual carefully before use to ensure proper operation and maintenance.

Important Safety Information

• Keep this device out of reach of small children to prevent choking hazards from small parts.
• Do not look directly into the LED light for extended periods, as it may cause eye strain or temporary vision impairment.
• Do not expose the device to water, excessive moisture, or extreme temperatures. This product is not waterproof.
• Dispose of used batteries responsibly according to local regulations. Do not incinerate batteries.
• Do not attempt to disassemble or modify the device, as this will void the warranty and may cause damage or injury.

Package Contents

• 1 x Legami Micro Night Dream LED Glasses Light
• Note: Batteries are not included and must be purchased separately.

Setup

Battery Installation

The Legami Micro Night Dream LED Glasses Light requires 1.5 Volt DC batteries (not included) for operation.

1. Locate the battery compartment on the light unit.
2. Carefully open the compartment cover.
3. Insert the batteries, ensuring correct polarity (+/-) as indicated inside the compartment.
4. Close the battery compartment cover securely until it clicks into place.

Image description: A close-up view of the Legami Micro Night Dream LED Glasses Light, detached from glasses, showing its compact design and the area where batteries are inserted.

Attaching to Glasses

The light features a convenient clip mechanism for easy attachment to most glasses frames.

1. Gently open the clip on the light unit.
2. Position the clip onto the frame of your glasses, typically on one of the temples or the bridge.
3. Ensure the light is securely fastened and does not obstruct your vision. Adjust its position for optimal comfort and light direction.

Image description: The Legami Micro Night Dream LED Glasses Light clipped onto the right side of a pair of black-framed glasses, with its LED light emitting a bright white glow.

Operating Instructions

Turning On/Off

The light is operated via a tactile switch located on the unit.

1. To turn on the light, gently press the tactile switch.
2. To turn off the light, press the switch again.

Image description: The Legami Micro Night Dream LED Glasses Light clipped onto the right side of a pair of black-framed glasses, with its LED light currently off.

Adjusting Light Angle

The light head can be pivoted to direct illumination precisely where needed.

1. Gently pivot the light head to achieve the desired angle for your task.

Maintenance and Care

• Clean the unit with a soft, dry cloth. Do not use abrasive cleaners, solvents, or harsh chemicals.
• If the light will not be used for an extended period, remove the batteries to prevent potential leakage and damage to the device.
• Store the device in a cool, dry place away from direct sunlight and extreme temperatures.

Troubleshooting

Light Does Not Turn On

• Check if batteries are installed correctly with the positive (+) and negative (-) terminals aligned properly.
• Ensure batteries are not depleted. Replace with new batteries if necessary.
• Verify the battery compartment cover is securely closed.

Light is Dim

• This usually indicates low battery power. Replace batteries with new ones.

Light Falls Off Glasses

• Ensure the clip is properly secured to a stable and appropriate part of the glasses frame.
• Avoid excessive or sudden movements that might dislodge the light.

Product Specifications

Warranty and Support

This product is covered by a standard manufacturer's warranty against defects in materials and workmanship. The warranty period typically begins from the date of purchase. For specific warranty terms, claims, or technical support, please contact your retailer or the manufacturer directly. Please retain your proof of purchase for warranty validation.