Bosch 00494772 Genuine OEM Dishwasher Door Seal Instruction Manual

Introduction

This manual provides detailed instructions for the installation, operation, and maintenance of the Bosch 00494772 Genuine OEM Door Seal. This part is designed to seal the gap between the dishwasher tub opening and the outer edge of the door, preventing water leaks during operation and ensuring efficient appliance performance.

Safety Information

Before beginning any repair or installation, it is crucial to prioritize safety. Please observe the following precautions:

Disconnect Power: Always ensure the dishwasher is completely disconnected from its electrical power supply before attempting any service.
Disconnect Water: Turn off the water supply to the dishwasher.
Wear Protective Equipment: It is recommended to wear appropriate protective safety equipment, such as work gloves and eye protection, to prevent injury.
Consult Appliance Manual: Always refer to your specific dishwasher's service manual for additional safety guidelines and model-specific instructions.

Setup and Installation

The Bosch 00494772 Door Seal is designed for straightforward replacement and typically does not require specialized tools. The seal measures approximately 71-72 inches in length.

Installation Steps:

Preparation: Open the dishwasher door fully. Carefully locate and remove the old door seal from its groove around the perimeter of the dishwasher tub opening. Clean the groove thoroughly to remove any accumulated food debris, grime, or residue.
Positioning the New Seal: Locate the midpoint of the new door seal. Align this midpoint with the center of the top groove of the dishwasher tub opening.
Insertion: Begin inserting the seal into the groove, working from the top center outwards towards one side, then repeat for the other side. Ensure the seal is pushed firmly and completely into the channel around the entire perimeter. Some users find that applying a small amount of silicone grease to the ribs of the gasket can facilitate smoother insertion.
Seating the Seal: Once the seal is fully inserted, gently close the dishwasher door. Leave the door closed for several hours (e.g., 2-4 hours) to allow the new seal to properly compress and seat itself within the door frame, ensuring a tight and effective seal.

Image: The Bosch 00494772 Genuine OEM Dishwasher Door Seal, shown in black. This image illustrates the appearance of the replacement part.

Compatible Models:

This door seal is compatible with a wide range of Bosch dishwasher models. Please verify your specific model number against the following list to ensure compatibility:

SHX33R55UC/64
SHE45C02UC/56
SHX33M05UC-46
SHE43M02UC/48
SHE43M06UC/48
SHE45C02UC/50
SHE45C02UC/53
SHX33M02UC-46
SHX33M06UC-46
SHX43M05UC-48
SHX45M01UC-48
SHE45M02UC/50
SHE45M02UC/52
SHE45M02UC/53
SHE45M02UC/56
SHE45M06UC/50
SHE46C02UC/47
SHE46C02UC/48
SHE46C05UC/47
SHE46C05UC/48
SHE47C02UC-18
SHE47C02UC-21
SHE47C05UC-21
SHE47C06UC-21
SHX45M02UC-48
SHX45M06UC-48
SHE43M05UC/48
SHE45M02UC/48
SHE45M05UC/48
SHE45M05UC/50
SHE45M05UC/52
SHE45M05UC/53
SHE45M05UC/56
SHE45M06UC/48
SHE46C02UC/46
SHU43C02UC-17
SHU43C05UC-17
SHU43C06UC-17
SHU43C07UC-17
SHE45M05UC/47
SHE46C02UC/38
SHE46C02UC/40
SHE46C02UC/43
SHE46C05UC/38
SHE46C05UC/40
SHE46C05UC/43
SHE46C05UC/46
SHE55M12UC-59
SHE55M15UC-59
SHE55M16UC-59
SHE55P05UC-53
SHX45M05UC-48
SHE46C02UC/36
SHE46C05UC/36
SHE46C06UC/47
SHE46C06UC/48
SHE66C06UC46
S35KMK17UC-18
S35KMK17UC-36
S35KMK17UC-40
SHE45C05UC/40
SHE45C05UC/48
SHE46C02UC/17
SHE46C02UC/22
SHE46C02UC/33
SHE46C05UC/17
SHE46C05UC/22
SHE46C05UC/33
S35KMK17UC-27
S35KMK17UC-43
S35KMK17UC-46
SHE45M02UC/46
SHE45M05UC/46
SHE45M06UC/46
SHE45M06UC/52
SHE45M06UC/53
SHE45M06UC/56
SHE46C06UC/38
SHE46C06UC/40
SHE46C06UC/43
SHE46C06UC/46
SHE46C06UC/33
SHE46C06UC/36
SHX45P02UC-53
SHX45P06UC-53
SHE45C05UC/50
SHE46C06UC/17
SHE46C06UC/22
SHE43P06UC/58
SHE43P06UC/56

Operating

After successful installation and proper seating of the door seal, your dishwasher should operate without any water leaks from the door area. The seal's primary function is to create a watertight barrier, containing water within the appliance during all wash and rinse cycles. It is advisable to monitor for any signs of leakage during the first few wash cycles after replacing the seal to confirm proper installation.

Maintenance

Regular maintenance of your dishwasher door seal can extend its lifespan and prevent future leaks:

Regular Inspection: Periodically inspect the door seal for any signs of wear, cracks, tears, or hardening of the rubber material.
Cleaning: Clean the seal and its groove regularly with a damp cloth and a mild, non-abrasive detergent. Food debris, grease, and detergent residue can accumulate on the seal, compromising its effectiveness.
Avoid Damage: Be careful not to pinch or damage the seal when loading or unloading the dishwasher. Avoid using sharp objects near the seal.

Troubleshooting

If you experience issues after replacing the door seal, consider the following troubleshooting steps:

Issue: Water leaks from the dishwasher door.

Possible Cause 1: The new door seal is not fully or correctly seated in its groove.
Solution 1: Open the door and carefully re-examine the seal's placement around the entire perimeter. Ensure it is pushed completely and evenly into the channel. Close the door and leave it shut for several hours to allow for proper compression and seating.
Possible Cause 2: The door seal was twisted, kinked, or damaged during installation.
Solution 2: Inspect the seal for any visible twists, kinks, or tears. If the seal is damaged, it may need to be replaced. Ensure proper alignment and avoid twisting during re-installation.
Possible Cause 3: The dishwasher door latch or hinges are faulty, preventing the door from closing tightly and creating adequate pressure on the seal.
Solution 3: Check the door latch mechanism and hinges for proper function and alignment. Repair or replace these components if they are preventing the door from closing securely. A door that does not close properly will prevent even a new seal from working effectively.

Specifications

Feature	Detail
Brand	Bosch
Model Number	00494772
Item Type	Door Seal
Color	Black
Approximate Length	71-72 inches
Approximate Package Dimensions (L x W x H)	9.8" x 8" x 1.5"
Item Weight	8 ounces
Material	Genuine OEM part
UPC	759569183012

Warranty Information

As a Genuine OEM (Original Equipment Manufacturer) part, the Bosch 00494772 Door Seal is designed and engineered to exact specifications, ensuring quality and compatibility. For specific warranty details pertaining to this replacement part or your Bosch appliance, please refer to the official Bosch appliance warranty documentation that accompanied your dishwasher or contact Bosch customer service directly.

Support

For further assistance, technical support, or to inquire about other genuine Bosch parts and accessories, please visit the official Bosch Home Appliances website or contact their customer service department. You can also find more information and products at the Bosch Store on Amazon.

Bosch 00494772