1. Introduction
This manual provides essential information for the safe and efficient use of your Hansgrohe Crometta Vario Hand Shower Set (Model 26694400). Please read these instructions carefully before installation and operation, and retain them for future reference. This set includes a hand shower with two spray types and a 1.60 m shower hose, designed for a flow rate of 9 liters per minute.
2. Safety Information
Observe all local plumbing and building codes. This product is intended for domestic use. Ensure proper water pressure and temperature are maintained according to local regulations. Do not modify the product. Use only genuine Hansgrohe replacement parts.
- Water Temperature: Avoid excessively hot water to prevent scalding.
- Installation: Installation should be performed by a qualified professional if you are unsure.
- Cleaning: Use only recommended cleaning agents to avoid damage to surfaces.
3. Components Overview
The Hansgrohe Crometta Vario Hand Shower Set 26694400 includes the following main components:
- Crometta Vario Hand Shower (White/Chrome)
- Shower Hose (1.60 m length)
- Wall Supports (plastic, chrome-plated)
Figure 1: Overview of the Hansgrohe Crometta Vario Hand Shower Set, showing the hand shower, hose, and wall bracket.
Figure 2: Technical drawing illustrating the dimensions of the Hansgrohe Crometta Vario Hand Shower. The diagram shows measurements such as length, width, and angle of the shower head.
4. Setup & Installation
Before beginning installation, ensure all necessary tools are available and the water supply is turned off. Refer to the technical drawing for precise measurements and positioning.
4.1. Wall Bracket Installation
- Choose a suitable location on the wall for the shower holder, ensuring it is at a comfortable height for all users.
- Mark the drilling points for the wall supports.
- Drill holes and insert wall plugs suitable for your wall type.
- Secure the wall supports using appropriate screws.
4.2. Shower Hose Connection
- Connect one end of the 1.60 m shower hose to the water outlet (e.g., shower mixer). Ensure a washer is in place to prevent leaks.
- Connect the other end of the shower hose to the hand shower. Ensure a washer is also in place here.
- Hand-tighten connections, then use a wrench to gently tighten further, being careful not to overtighten.
4.3. Initial Check
After installation, slowly turn on the water supply and check all connections for leaks. If leaks occur, gently tighten the connections further.
5. Operating Instructions
The Hansgrohe Crometta Vario Hand Shower offers two distinct spray patterns: Rain and Intense Rain. These can be easily switched by turning the shower head.
5.1. Changing Spray Types
Figure 3: Image showing a hand turning the shower head to adjust the spray pattern. The shower head features two distinct spray types: Rain and Intense Rain.
- To switch between the Rain and Intense Rain spray patterns, simply rotate the spray disc of the hand shower.
- The Rain spray provides a soft, wide coverage, ideal for rinsing.
- The Intense Rain spray offers a more concentrated and powerful stream, suitable for invigorating showers or rinsing shampoo.
5.2. Flow Rate
This model is designed for a maximum flow rate of 9 liters per minute (at 3 bar water pressure), promoting water efficiency.
Figure 4: Diagram illustrating the flow rate characteristics of the Hansgrohe Crometta Vario Hand Shower for both Rain (1) and Intense Rain (2) spray patterns, showing liters per minute (Q) versus pressure (bar/MPa).
6. Maintenance
Regular cleaning and maintenance will ensure the longevity and optimal performance of your Hansgrohe hand shower set.
6.1. Cleaning the Hand Shower
- Quick Clean Technology: The shower head features Quick Clean technology, allowing for easy removal of limescale deposits. Simply rub the silicone nozzles with your finger to dislodge any buildup.
- Surface Cleaning: Clean the chrome-plated surfaces with a soft cloth and a mild, non-abrasive cleaning agent specifically designed for bathroom fixtures.
- Avoid: Do not use abrasive cleaners, scouring pads, or cleaners containing acids, alcohol, or chlorine, as these can damage the finish.
6.2. Hose Maintenance
The pivot connectors on the shower hose prevent tangling. Periodically check the hose for any signs of wear or damage. Replace the hose if any cracks or leaks are observed.
7. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Reduced water flow from hand shower | Limescale buildup in nozzles | Rub the silicone nozzles to remove limescale (Quick Clean). |
| Reduced water flow from hand shower | Clogged filter screen in hose connection | Disconnect hose, clean or replace filter screen. |
| Water leaks at hose connections | Loose connection or worn washer | Tighten connections. Check and replace washers if necessary. |
| Shower hose tangles easily | Pivot connectors not functioning | Check for obstructions or damage to pivot connectors. Ensure hose is not twisted during storage. |
If you encounter issues not listed here or if solutions do not resolve the problem, please contact Hansgrohe customer support.
8. Specifications
- Model: Hansgrohe Crometta Vario Hand Shower Set 26694400
- Spray Patterns: Rain, Intense Rain (2 sprays)
- Shower Head Size: 100 mm
- Hose Length: 1.60 m
- Maximum Flow Rate: 9 l/min (at 3 bar)
- Material: Plastic (hand shower), Chrome-plated (finish, wall supports)
- Color: White/Chrome
- Product Dimensions: Approximately 14.02"L x 3.94"W
- Item Weight: 1.06 pounds
- Installation Type: Wall Mounted
- Features: Quick Clean technology, pivot connectors to prevent hose tangling
9. Warranty & Support
Hansgrohe products are manufactured to high-quality standards and come with a manufacturer's warranty. For detailed warranty terms and conditions, please refer to the official Hansgrohe website or contact their customer service directly. Keep your proof of purchase for warranty claims.
Customer Support:
For technical assistance, spare parts, or warranty inquiries, please visit the official Hansgrohe website or contact their customer support department. Contact information can typically be found on the Hansgrohe website or product packaging.
You can also visit the Hansgrohe Store on Amazon for more product information and support resources.
