AFX FX-200 Half-Size Helmet Instruction Manual

Introduction

Thank you for choosing the AFX FX-200 Half-Size Helmet. This manual provides essential information for the proper use, care, and maintenance of your helmet. Please read it thoroughly before using your helmet to ensure maximum safety and product longevity. This helmet meets or exceeds DOT FMVSS-218 motorcycle helmet safety standards.

Safety Information

Your safety is paramount. Adhering to these guidelines is crucial for protecting yourself while riding.

• Proper Fit: A helmet must fit snugly and comfortably. An improperly fitted helmet can compromise its protective capabilities.
• Retention System: Always secure the Double D-ring retention system firmly under your chin. Never ride with an unfastened or loosely fastened chin strap.
• DOT Certification: This helmet is DOT FMVSS No. 218 Certified, indicating it meets specific safety standards for motorcycle helmets.
• No Modifications: Never modify your helmet in any way (e.g., drilling holes, painting with non-approved chemicals, attaching accessories not designed for the helmet). Modifications can weaken the helmet's structure and void its safety certification.
• Impact Replacement: A helmet is designed for a single impact. If your helmet sustains an impact, even if there is no visible damage, it must be replaced immediately. The protective materials may have been compromised.
• Inspection: Regularly inspect your helmet for any signs of wear, cracks, or damage to the shell, liner, or retention system. If any damage is found, discontinue use and replace the helmet.

Setup and Initial Use

1. Sizing and Fit

Selecting the correct helmet size is critical for safety and comfort. Use the sizing chart below to determine your appropriate size. Measure your head circumference at the largest point, approximately one inch above your eyebrows.

Image Description: A detailed sizing chart for AFX helmets, displaying adult and youth sizes. Adult sizes range from X-Small to XXXX-Large, with corresponding head circumferences in centimeters and inches, along with hat sizes. Youth sizes include Y-Small, Y-Medium, and Y-Large, also with corresponding measurements.

Once you have determined your size, try on the helmet. It should feel snug around your head and cheeks without causing painful pressure points. To check the fit, fasten the chin strap and try to move the helmet from side to side and up and down. If the helmet slides easily or rotates significantly, it is too large. Your skin should move with the helmet.

2. Retention System (Double D-ring)

The FX-200 helmet features a Double D-ring retention system for secure fastening. Follow these steps to properly secure your helmet:

1. Thread the end of the chin strap through both D-rings.
2. Loop the strap back through only the first D-ring.
3. Pull the strap tightly until it is snug against your throat, ensuring the helmet cannot be rolled off your head.
4. If your helmet includes a snap to secure the loose end of the strap, use it to prevent flapping.

Image Description: A black AFX FX-200 half-size helmet viewed from the side. The helmet features a small visor and a visible Double D-ring retention system with a black strap extending downwards, illustrating the chin strap mechanism.

Operating Your Helmet

Once your helmet is properly fitted and secured, you are ready to ride. Always ensure your vision is unobstructed and your peripheral awareness is maintained. The half-size design offers an open-face experience while providing essential head protection.

Care and Maintenance

Proper care extends the life of your helmet and maintains its protective qualities.

1. Cleaning

• Exterior: Clean the helmet shell with mild soap and water. Use a soft cloth to gently wipe away dirt and debris. Avoid abrasive cleaners, solvents, or harsh chemicals, as these can damage the clear coat finish and helmet materials.
• Interior: The interior comfort liner may be spot cleaned with a damp cloth and mild soap. Allow it to air dry completely before use.

2. Storage

Store your helmet in a cool, dry place away from direct sunlight and extreme temperatures. Avoid storing it near heat sources or chemicals. A helmet bag can protect it from dust and scratches.

Troubleshooting

If you encounter issues with your helmet, consider the following:

• Discomfort or Pressure Points: Re-evaluate the helmet size and fit. Ensure the helmet is seated correctly on your head. If discomfort persists, the helmet size may be incorrect.
• Helmet Feels Loose: Ensure the Double D-ring retention system is pulled tight and properly secured. If the helmet still moves excessively, it may be too large.
• Chin Strap Issues: If the chin strap is frayed or damaged, discontinue use and replace the helmet. Do not attempt to repair the strap.

Product Specifications

Warranty and Support

For warranty claims, technical support, or any product-related inquiries, please contact AFX customer service directly. Refer to the product packaging or AFX's official website for the most current contact information and detailed warranty terms and conditions.