Redi-Remote RTRLCVD1924
Redi-Remote Replacement Remote Control Instruction Manual
Model: RTRLCVD1924
Introduction
This manual provides instructions for the Redi-Remote replacement remote control, model RTRLCVD1924. This remote is specifically designed to function as a direct replacement for the RCA RLCVD1924 remote control, offering full functionality for your compatible RCA unit without the need for programming.
Please read this manual carefully before using your new remote control to ensure proper operation and longevity.
Setup
Battery Installation
Your Redi-Remote requires four (4) AAA batteries for operation. These batteries are typically included with your purchase.
- Locate the battery compartment cover on the back of the remote control.
- Slide the cover downwards or press the latch (if present) and lift to open the compartment.
- Insert four new AAA batteries, ensuring that the positive (+) and negative (-) terminals align correctly with the markings inside the compartment. Incorrect insertion can prevent the remote from functioning.
- Replace the battery compartment cover by sliding it back into place until it clicks securely.

Figure 1: Battery compartment on the back of the remote control. Ensure correct battery polarity when inserting AAA batteries.
Once batteries are installed, the remote is ready for use with your compatible RCA RLCVD1924 unit. No additional programming is required.
Operating Instructions
This Redi-Remote is designed to replicate the functions of your original RCA RLCVD1924 remote. Simply point the remote at your television and press the desired button.

Figure 2: Front view of the Redi-Remote control. The upper section contains primary controls, while a sliding cover conceals additional buttons.
Key Functions
- POWER: Turns the television on or off.
- VOLUME (+/-): Increases or decreases the volume level.
- CHANNEL (+/-): Changes the television channel up or down.
- NUMBER BUTTONS (0-9): Directly input channel numbers.
- MENU: Accesses the television's on-screen menu.
- NAVIGATION BUTTONS (Arrows, OK): Used to navigate through menus and confirm selections.
- INPUT/SOURCE: Changes the video input source (e.g., HDMI 1, AV).
- MUTE: Silences the television audio.
Sliding Cover for Additional Buttons
The lower half of the remote control features a sliding cover. To access additional functions, gently slide this cover downwards. This will reveal buttons for advanced features such as playback controls, aspect ratio, or specific TV functions depending on your RCA model.
Operational Range
The remote operates using infrared (IR) technology. Ensure a clear line of sight between the remote's IR emitter (located at the top of the remote) and the IR receiver on your television. The maximum effective range is approximately 20 feet (6 meters).
Limitations
- This Redi-Remote cannot be programmed to control auxiliary devices (e.g., DVD players, soundbars, cable boxes). It is designed exclusively for the RCA RLCVD1924 television.
- The remote is not equipped with laser pointers or LED lights.
Maintenance
Cleaning
To clean your remote control, gently wipe the surface with a soft, dry cloth. For stubborn dirt, slightly dampen the cloth with water or a mild, non-abrasive cleaner. Avoid using harsh chemicals, solvents, or abrasive materials, as these can damage the remote's finish or internal components.
Battery Replacement
Replace batteries when the remote's response becomes sluggish or stops working. Always replace all four AAA batteries at the same time with new ones. Do not mix old and new batteries, or different types of batteries, as this can lead to leakage or improper function. Dispose of used batteries according to local regulations.
Storage
If the remote control will not be used for an extended period, it is recommended to remove the batteries to prevent potential leakage and damage to the remote.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Remote not responding. |
|
|
| Some buttons not working. |
|
|
| Remote controls other devices. | This remote is designed only for the RCA RLCVD1924. It cannot control other devices. | No action required. This remote is not universal. |
Specifications
- Brand: Redi-Remote
- Model Number: RTRLCVD1924
- Compatible Devices: RCA RLCVD1924 Television
- Connectivity Technology: Infrared (IR)
- Max Number of Supported Devices: 1
- Special Feature: No Programming Required
- Maximum Range: 20 Feet (approx. 6 meters)
- Number of Buttons: 58
- Batteries Required: 4 x AAA (included)
- Dimensions: 7 1/2" x 2 1/4" x 3/4" (approx. 19.05 cm x 5.72 cm x 1.91 cm)
- Item Weight: 5 Ounces (approx. 141.75 grams)
- UPC: 791090953634
Warranty and Support
Redi-Remote aims to provide reliable replacement remote controls. While specific warranty details are not provided in this manual, if you encounter any concerns or issues with your remote control after purchase, please contact the seller directly for assistance. They will be able to provide support and guidance regarding your specific product.
For further information or to report a problem, please refer to your purchase documentation or the retailer's website where the product was acquired.
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.