Umarex Elite Force Airsoft Green Gas User Manual

Introduction

The Umarex Elite Force Airsoft Green Gas is a high-performance propellant designed for use with all compressed gas airsoft guns. This product is formulated for efficiency and environmental safety, featuring a new lower oil mixture to ensure consistent velocity during operation. This manual provides essential information for safe handling, proper usage, and storage of the green gas.

Image: Three cans of Umarex Elite Force Airsoft Green Gas. Each can features a distinctive green and black design with a shield emblem, the word "FUEL", and safety warnings. These cans are designed to provide consistent power for airsoft guns.

Safety Information

WARNING: This product contains pressurized gas and is highly flammable. Failure to follow these instructions may result in serious injury or property damage.

• Flammability: Keep away from heat, hot surfaces, sparks, open flames, and other ignition sources. No smoking.
• Pressurized Container: Do not pierce or burn, even after use. Do not expose to temperatures exceeding 50°C (122°F).
• Ventilation: Use only in well-ventilated areas. Avoid breathing gas.
• Eye Protection: Always wear appropriate eye protection when handling and using green gas.
• Skin Contact: Avoid prolonged or repeated skin contact. In case of contact, wash thoroughly with soap and water.
• Ingestion: Do not ingest. If swallowed, seek immediate medical attention.
• Children and Pets: Keep out of reach of children and pets.

Product Features

• Compatible with all compressed gas Airsoft Guns.
• Highly efficient and environmentally safe formulation.
• New formula with lower oil mixture for consistent velocity.
• Comes in a pack of three 8-ounce cans.

Usage Instructions

Follow these steps to properly fill your airsoft gun's magazine or gas reservoir:

1. Preparation: Ensure your airsoft gun and magazine are clean and free from debris. Always wear eye protection.
2. Locate Fill Valve: Identify the gas fill valve on your airsoft gun's magazine or gas reservoir.
3. Position Can: Hold the green gas can upside down, aligning the nozzle with the fill valve. Holding the can upside down ensures that the liquid propellant, not just gas, enters the reservoir.
4. Fill: Press the can firmly onto the fill valve. You will hear a hissing sound as the gas transfers. Continue filling until the hissing sound stops or changes significantly, indicating the reservoir is full. Avoid overfilling.
5. Remove Can: Carefully remove the can from the fill valve. A small amount of gas may escape, which is normal.
6. Test: After filling, allow the gas to stabilize for a few seconds before using the airsoft gun.

Note: The optimal filling time may vary depending on the size of your magazine's gas reservoir and ambient temperature. Do not attempt to modify the can or its nozzle.

Storage

Proper storage is crucial for the longevity and safety of the product:

• Store in a cool, dry, and well-ventilated area.
• Keep away from direct sunlight, heat sources, and open flames.
• Do not store in vehicles where temperatures can exceed 50°C (122°F).
• Ensure cans are stored upright to prevent leakage.

Disposal

Dispose of empty cans according to local regulations for pressurized containers. Do not puncture or incinerate empty cans.

Specifications

Warranty and Support

As a consumable product, Umarex Elite Force Airsoft Green Gas typically does not come with a direct manufacturer's warranty. For any product-related inquiries, safety data sheets, or general support, please contact Umarex USA directly through their official website or customer service channels. Always refer to the manufacturer's guidelines for the most current information.

You can visit the Umarex Store on Amazon for more information on their products.